Zanussi Wjs1265w Manual

WASHER-DRYER
WJS 1265 W
WJS 1465 W
WJS 1665 W



	

 






 






	


	




	

	
	






		




 

!





	
	#




	



!!
INSTRUCTION BOOKLET132999022GB
132999022 WJS1265-1465-1665W.qxd  9/13/01  11:15 AM  Pagina  1    (Nero/Process Black pellicola) 

2
Installation

This appliance is heavy. Care should be taken when
moving it.

It is dangerous to alter the specifications or attempt
to modify this product in any way.

All packing and transit bolts must be removed before
use. Serious damage can occur to the product and to
property if this is not adhered to. See relevant section
in instructions.

Any plumbing work required to install this appliance
should be carried out by a qualified plumber or
competent person.

Any electrical work required to install...

3
Contents
For the User
Important Safety Information2
Your New Washer-Dryer4
Description of the Appliance5
Door locked light 5
Detergent dispenser drawer 5
The Control Panel6-10
Operating sequence11-14
Washing11
Load the laundry 11
Measure out the detergent 11
Measure out the fabric softener 11
Switch the machine on 11
Select the required programme/fabric 11
Select the temperature 12
Select the spin speed or the RINSE HOLD option 12
Select the desired options 12
Select the DELAY TIME 12
Start the...

4
Your New Washer-Dryer
Your new washer-dryer, fitted with the Zanussi “JET SYSTEM”, meets all modern requirements
for effective treatment of laundry with low water, energy and detergent consumption. 
Even small loads are washed “economically” because the amount of water used is regulated
automatically according to the load and type of fabric.
It is gentle with your laundry, simple to use and easy to care for.

The special wool programmewith its new delicate
wash system treats your woollens with extreme...

5
Description of the Appliance
1 Detergent dispenser drawer
2 Control Panel
3 Door locked light
4 Door opening handle
5 Filter
6 Adjustable feet
Door locked light
It stays on during the whole programme indicating that
the door is locked.
When the light goes out, the door can be opened (see
page 13).
Detergent dispenser drawer
Prewash
Main wash
Fabric softener





	

 






 






	



	




	

	...

6
The Control Panel
Maximum temperatures are 90°C for cotton, 60°C for 
synthetic fabrics, 40°C for delicate fabrics, wool and
fabrics to be hand-washed (HAND WASH
programme).
Important!
By pressing the TEMPERATURE and SPIN SPEED
buttons simultaneously, the acoustic signal at the end of
the cycle is deactivated.
By pressing these 2 buttons again the acoustic signal is
reactivated.
5 SPIN SPEED button
Press this button repeatedly to change the spin speed, if
you want your laundry to be spun at a speed...

7 -Select spin speed by means of button 5, and press
the START/PAUSE button.
Drain only
-  Press the SKIP/RESET button once, so as to cause
the DRAIN light  to light up, then press the
START/PAUSE button.
Important! If you accidentally press the SKIP/RESET
button more than once, the display will show three
blinking dashes. To cause the washing machine to
drain the water, select any washing programme by
means of the FABRIC button, then press
SKIP/RESET three timesin order to select the
DRAIN position...

8  Selected drying timein minutes or hours and
minutes.
After the programme has started the time remaining is
updated every minute.
 The washing machine has stopped with water in
the tub, at the end of a programme with the RINSE
HOLD option: this is indicated by a static zero.
 The washing machine has completed the
programme: this is indicated by a blinking zero. At
the same time, the door locked light goes out. The
zero will reappear when you switch the washing
machine on, unless the previous...

9 When you PAUSE the cycle, the DOOR LOCKED
light goes out, and it becomes possible to open the
door, provided
 the machine is not in the heating or drying phase;
 the level of the water is not high;
 the drum is not turning.
Important! You must set the washing machine to
PAUSE before you make any change in the programme
in progress.
Draining of water and spinningafter the execution
of programmes with the RINSE HOLD option.
11 SKIP/RESET button
This button performs two functions:
- Clears the memory...

10
12 DELAY button
This button makes it possible to delay the starting of the
programme by up to 24 hours. The delay you have
selected is shown on the display for about 3 seconds;
afterwards, the duration of the programme reappears.
You must select this option afteryou have set the
programme and beforeyou press the START/PAUSE
button.
The time value shown on the display will decrease by
one unit every hour.
You can change the delay time at any moment,
before you press the START/PAUSE button.
If you have...