Zanussi Fcs 825 C User Manual

Washing programmes
Programme/ TemperatureType of laundryAvailable optionsDescription of the pro-gramme
COTTON
(COTTON)
90°White cotton (heavily
soiled cotton items)
SPIN REDUCTION/RINSE
HOLD - QUICK/DAILY 1)-
ECONOMY -PREWASH -
EASY IRON
Main wash
Rinses
Long spin max. 800 rpm
Max load 3 kg
COTTON
(COTTON)
60° - 30°Coloured cotton  (normally
soiled cotton items)
SPIN REDUCTION/RINSE
HOLD - QUICK/DAILY 1)-
ECONOMY2) -PREWASH -
EASY IRON
Main wash
Rinses
Long spin max. 800 rpm
Max load 3 kg
SYNTHETIC...

Programme/ TemperatureType of laundryAvailable optionsDescription of the pro-
gramme
SPIN 
Separate spin for hand
washed garments and after
programmes with the Rinse
Hold option selected. You
can choose the spin speed
by turning the spin speed
selector to adapt it to the
fabrics to be spun.
SPIN REDUCTION
Drain and long spin
Max. spin speed 800 rpm
Max Load 3 kg
 /OFF
For resetting the pro-
gramme or switching the
machine off
  
1) If you select this option, we recommend that you reduce the maximum load....

Cleaning the drawer recess
Having removed the draw-
er, use a small brush to
clean the recess, ensuring
that all washing powder
residue is removed from
the upper and lower part of
the recess.
Replace the drawer and run the rinse programme with-
out any clothes in the drum.
Cleaning the water inlet filter
If your water is very hard or contains traces of lime depos-
it, the water inlet filter may become clogged. It is therefore
a good idea to clean it from time to time.
Turn off the water tap. Un-
screw...

ProblemPossible cause/Solution
The machine does not start:
The door has not been closed.
• Close the door firmly.
The plug is not properly inserted in the power socket.
• Insert the plug into the power socket.
There is no power at the socket.
• Please check your domestic electrical installation.
The main fuse has blown.
• Replace the fuse.
The selector dial is not correctly positioned and the button Start has not been
pressed.
• Please turn the selector dial and press the button Start again.
The machine...

ProblemPossible cause/Solution
Unsatisfactory washing results:
Too little detergent or unsuitable detergent has been used.
• Increase the detergent quantity or use another one.
Stubborn stains have not been treated prior to washing.
• Use commercial products to treat the stubborn stains.
The correct temperature was not selected.
• Check if you have selected the correct temperature.
Excessive laundry load.
• Reduce the laundry load.
The door will not open:
The programme is still running.
• Wait the end of...

Mod. ... ... ...
Prod. No. ... ... ...
          Ser. No. ... ... ...
Technical data
DimensionsWidth
Height
Depth50 cm
67 cm
55 cm
Level of protection against ingress of solid particles and moisture ensured by
the protective cover, except where the low voltage equipment has no protec-
tion against moistureIPX4
Water supply pressureMinimum
Maximum0,05 MPa
0,8 MPa
Maximum LoadCotton3 kg
Spin SpeedMaximum800 rpm
Electrical dataVoltage
Overall power
Fuse
Frequency230 V
1600 W
10 A
50 Hz
Consumption values...

ProgrammeEnergy consumption
(kWh)1)Water consumption (li-
tres)1)Programme duration (mi-
nutes)1)
Wool 30°0.3545~ 50
Rinses0.0330~ 27
Drain--~ 1
Spin--~ 5
1) The consumption information shown in this chart is indicative. It can vary depending on the quantity and the type of laundry, on the
temperature of the water supply and on the ambient temperature.
Standard programmes for the Energy Label consumption
values
The cotton 60 °C and cotton 40 °C with Economy option
selected are the standard programmes for...

Return machine to its upright position and remove the
power supply cable and the draining and inlet hose
from the hose holders on the rear of the appliance.
With a suitable spanner unscrew and remove the three
screws and their spacers on machines rear.
The three holes must then
be plugged with the plastic
plug caps supplied in the
bag containing the in-
struction booklet, which
can be found inside the
drum.
Positioning
Install the machine on a flat hard floor. Make sure that air
circulation around the...

Hooked over the edge of a sink using the plastic hose
guide supplied with the machine.
In this case, make sure the end cannot come unhooked
when the machine is emptying. This could be done by ty-
ing it to the tap with a piece of string or attaching it to the
wall.
In a sink drain pipe with a trap.
650-800 mm
The drain hose can be connected directly into the pipe
(e.g. beneath a washtub or sink), above the water trap. The
drain hose must be arranged so that some part of it’s
length is routed up to a...

Environment concerns
The symbol  on the product or on its packaging
indicates that this product may not be treated as
household waste. Instead it should be taken to the
appropriate collection point for the recycling of electrical
and electronic equipment. By ensuring this product is
disposed of correctly, you will help prevent potential
negative consequences for the environment and human
health, which could otherwise be caused by inappropriate
waste handling of this product. For more detailed
information...