Xerox Phaser 3600DN User Manual

9.14   
Vertical linesIf black vertical streaks appear on the page:
• The drum inside the print cartridge has 
probably been scratched. Install a new print 
cartridge. 
Gray 
backgroundIf the amount of background shading becomes 
unacceptable, the procedures below may fix the 
problem.
• Change to lighter weight pages. See page 5.3.
• Check the printer’s environment; very dry (low 
humidity) or high humidity (higher than 80% 
RH) conditions can increase the amount of 
background shading.
• Remove the old...

9.15   
Back of 
printouts are 
dirty• The transfer roller may be dirty. See page 8.1.
• Check for leaking toner. Clean the inside of the 
printer. 
Solid color or 
Black pages•The print cartridge may not be installed 
properly. Remove the cartridge and reinsert.
•The print cartridge may be defective and need 
replacing. Install a new print cartridge.
• The printer may require repair. Contact a 
service representative.
Loose toner
• Clean the inside of the printer. 
• Check the paper type and quality....

9.16   
Common PostScript problems
The following situations are PostScript language specific and may 
occur when several printer languages are being used.
Note
To receive a printed or screen displayed message when 
PostScript errors occur, open the Print Options window and 
click the desired selection next to the PostScript errors section.
ConditionPossible causeSuggested solutions
PostScript file 
can not be 
printed.The PostScript 
driver may not 
be installed 
correctly.• Print a configuration page...

9.17   
The machine does not 
print.The CUPS (Common Unix Printing 
System) version distributed with SuSE 
Linux 9.2 (cups-1.1.21) has a problem 
with ipp (Internet Printing Protocol) 
printing. Use the socket printing instead of 
ipp or install later version of CUPS (cups-
1.1.22 or higher).
Some color images 
come out all black.This is a known bug in Ghostscript (until 
GNU Ghostscript version 7.05) when the 
base color space of the document is 
indexed color space and it is converted 
through CIE...

10.1   
10 Installing accessories
Your printer is a full-featured laser printer that has been optimized to 
meet most of your printing needs. Recognizing that each user may have 
different requirements, however, Xerox makes several accessories 
available to enhance the printer’s capabilities.
This chapter includes:
• Precautions when installing accessories
• Installing a memory DIMM
Precautions when installing accessories
Disconnect the power cord: 
Never remove the control board cover while the power is...

10.2   
6Holding the memory DIMM by the edges, align the notches on the 
memory DIMM with the grooves on the memory DIMM slot.
7Push the DIMM straight into the DIMM slot until it snaps into place. 
Make sure the latches fit over the notches located on either side of 
the DIMM.
8Replace the control board cover.
1groove
2notch
1
2
1
1latch
9Reinstall the duplex-slot cover or the optional duplex unit.
10Reconnect the power cord and printer cable, and turn the printer 
on.
Setting the memory in the...

11.1   
11 Specifications
This chapter includes:
• Printer specifications
Printer specifications
ItemSpecifications and Description
Printing speed
aUp to 38 ppm (A4); Up to 40 ppm (Letter)
Duplex: Up to 26 ipm (A4); Up to 27 ipm (Letter)
Resolution
Up to 1200 x 1200 dpi effective output
Warm-up time
Less than 45 seconds
First print out time
Standby mode: 9 seconds 
Sleep mode: 40 seconds
Power rating
AC 110 - 127 V or AC 220 - 240 V
See the Rating label on the machine for the 
correct voltage, frequency...

1
INDEX
A
accessories
installing
memory DIMM 10.1
order information 7.1
C
cleaning
drum 8.2
inside 8.1
outside 8.1
cleaning sheet, print 8.2
component location 1.2
control panel
menus 2.1
status LED 9.7
D
demo page, print 2.9
DIMM, install 10.1
display language, change
control panel 2.9
drum, clean 8.2
E
error messages 9.8
H
high altitude 9.15
I
installing accessories
memory 10.1
J
jam, clear 9.1
L
loading paper
multi-purpose tray 5.6
tray 2/optional tray 3 5.5
M
Macintosh problems 9.17
manual feed mode...

2
system requirements
Mac OS 3.2
Windows 3.2
W
Windows problems 9.15
Downloaded From ManualsPrinter.com Manuals 

Software section
Downloaded From ManualsPrinter.com Manuals