Whirlpool Wp 88 Installation And Maintenance Instructions

Whirlpool is a registered trademark of Whirlpool USA5019 396 01167
1
GBWP 88
Before using the dishwasher, read the 
installation and maintenance instructions carefully!
1) Programme data obtained in conformity with European standard EN 50242. The data may vary, for example, according to   
different loads, extra functions, sensor settings (only with sensor programmes), water supply temperatures, water hardness 
and power supply voltage.
2) Programme for energy data label in conformity with EN 50242. -...

2
2. QUICK REFERENCE GUIDE
Detailed instructions are given in the following pages, see also chapter “5. What to do if...”
1. Switch on the 
applianceOpen the dishwasher door.
Press the 
ON button.
2. Select a programmePress the button   or   to bring up the desired programme on the display. 
Select options, if available.
3. Select the type of 
detergentThe detergent selection procedure varies depending on the dishwasher model. 
Chapter “1. Overview ” provides instructions for selecting detergent type.
4....

3
3. HOW TO USE THE APPLIANCE
PROGRAMME SELECTION
Press the button   or   to bring up the desired programme on the display. The appliance must be switched 
on. If required, select options (if supplied). The corresponding indicator lamp switches on. Appropriate 
programmes and relative available options are detailed in table 1.1 on page 1.
Programme times stated in the table were obtained under normal conditions and may vary 
depending on conditions. Differences of up to 20 minutes are possible with...

4
3. HOW TO USE THE APPLIANCE
c. How to adjust the rinse aid dosage regulator
The rinse aid dosage can be adjusted to the detergent used. The lower the setting, the less 
rinse aid is dispensed (factory setting: position 4).
Press the button 
2 to open the cover.
Using a coin or similar object, turn the arrow to the desired setting. 
After adjusting the rinse aid setting, shut the cover again.
If there are streaks: reduce the dosage by turning the dial to a lower setting (1-3). If crockery is 
not...

5
3. HOW TO USE THE APPLIANCE
HOW TO LOAD THE RACKS
CUTLERY RACK:May be used in two different positions.
In position 2 the upper rack must be 
lowered (see “Upper rack height 
adjustment” 
C below).
For optimum washing results, position 
cutlery as shown (handles of spoons 
facing inwards).
Beware of sharp/pointed items. Risk 
of injury!
UPPER RACK 
- depending on model:
The two handles 
C must be level.
Washing without the upper rack/cutlery rack
If the appliance is equipped with the adjustable...

6
4. PRECAUTIONS AND GENERAL RECOMMENDATIONS
1. Packing
The packaging materials are 100% recyclable and marked with the recycling symbol.  .
2. Removing the packaging and inspecting the contents
After unpacking, make sure that the dishwasher is undamaged and that the door closes correctly. If in doubt, contact a 
qualified technician or your local retailer.
3. Before using the dishwasher for the first time
- The appliance is designed to operate at ambient temperatures of between 5°C and 45°C.
- This...

7
5. WHAT TO DO IF...
If a fault occurs, 
before contacting the After-sales Service, make the following checks to try and remedy the 
problem. Most faults can be remedied by taking the following courses of action, quickly restoring normal 
appliance operation.
The appliance... Possible causes/solutions
...is not working/will not start - The appliance must be switched on.
- Check the household circuit fuse if there is no power supply.
- The dishwasher door must be closed.
- Check whether the “Delayed...

8
5. WHAT TO DO IF...
Crockery and cutlery ... Possible causes/solutions
...are not perfectly clean/have food 
residues- In the event of frequent use of low temperature programmes 
(50°C or lower) (if available), every now and again select a 
higher temperature programme
- The spray arms must not be clogged, the filters must not be 
dirty and must be fitted correctly (see the instructions in 
“Maintenance and installation”).
- The spray arms must be able to turn freely and must not be 
impeded by...