Vodavi Starplus Triad S Installation Manual

4-8 Keys et Self Tes t
Single Li ne Tele pho nes
The following applies to all 2500 type single line telephones connected
to the s yst em.
DS S/ D L S C on so le
The following applies to DSS/DLS Consoles:
Table 4- 3: Single Line Telephone
Sy mpt o m A c ti o n
Ph on e wil l n ot di al ou t Verify co rrec t SLT ty p e pr og ra mmed in sta tio n
id enti fic at ion . Ver ify lin e g rou p ac cess
pr og ra mmi ng .
No ri ng in g t o p ho ne Ch eck C O lin e ri ng in g assi gn men ts in
pr og ra mmi ng .
Mes s...

CO L ine Card Funct ion s 4-9
CO Line Card Functions
The system can be equipped with either a CKIB or CSIB line interface card.
Each card type contains three (3) Loop Start CO lines.
Table 4- 5: CO L ine Loop Start Board (CKIB/CSIB Board)
Sym pt om Ac t io n
3 loop start CO li nes on the syst em do not
wor kChe ck or change card. Check CO line
d ema rc at io n.
CO l in e(s) d oes n o t ri ng C he ck CO l in e rin g assi gn men t in
p ro gra m min g.
No ise o r c ross-t al k on th e lin e C he ck CO l in...

4-10 Sys tem Fun ctio ns
Sy s t e m F u n c ti o n s
The following f unctions a re related to sy stem res ources a nd the comm on
equipment boa rds controlling them.
Tabl e 4 -6: Sys te m Fu n c ti o n s
Symptom Action
Bas ic KS U a nd MBU
Co mp let e system fa ilu re Ver ify tha t po wer sw itc h i s on , p ower co rd is
plugged i n. Chec k po wer LED o n MB U (left edge
o f ca r d ) . Ve r i fy P M U w as i ns t al le d wi t h so f t w ar e.
Any co rrec tl y ac ti vated featu re d oes n ot
wor k pr op...

Remo t e Mai n tena nce 4 - 11
Remote Maintenance
General Overview
TheRemoteMaintenancefeatureallowsauthorizedpersonneltosurvey
sys te m, slot c on figur at i on i nfor mat ion and prog ram ming . T his c an be
done through the op tional mod em or data te rminal conne cte d v ia th e
RS-232C port on the option al MIS U Module. The comm ands are entered
fr om a key boar d a nd ar e li mi te d t o t hos e l is te d.
Overview of Maintenance Commands
There are four basic commands available in the Remote...

4- 12 Re mo te M ai nte nance
Exit Maintenance
The E xit comma nd te rminates the current Maintena nce fea ture se ssion.
The Exit command format is: maint>x
Figure 4-1: Maintenance Help Menu
Sys te m Co nf igu ration
Figure 4- 2is a configuration of theSTARPLUSTr iad-SS yst em and di spl ays
what is printed when the installer typesdsat t he mai nt>
pr ompt .
.
F igure 4 -2: Sy st em Conf igurat io n 

Remo t e Mai n tena nce 4 - 13
Where:
†Colu mn 1lists the card slot.
†Colu mn 2l is ts car d t ype of t hat car d sl ot .
†Colu mn 3l is ts c ar d s ta tu s :
OOSstatus ca n indica te the entire card is out of service, or a specif ic
st at ion is not i nst al le d or i nst al le d bu t n ot oper at iona l.
INSstatus can indicate a specific station is installed and operating
correctly.
†Colu mn 4lists card options.
†Colu mn 5lists firmware version of card.
Station Configuration
Figure 4- 3illustrate s...

4- 14 Re mo te M ai nte nance
Figure 4-3: Station Configuration
CO Li ne Co nf iguratio n
Figure 4- 4illustrates a representation of what is printed out for slot two
when a LCOB is installed in that slot and:
The i nst al le r typ esds2at th emaint>pr omp t.
Co lu mnIn d ica tes:
1StationNumber
2 St ation Type (keyset, DSS, SLT )
Keyset - ID 0 = K ey statio n
DX X 1 = DS S M a p 1
DX X 2 = D S S M a p 2
DX X 3 = D S S M a p 3
DX X 4 = D S S M a p 4
DX X 5 = D S S M a p 5
SLT - I D 6 = S LT
SLT w /L a m p...

Remo t e Mai n tena nce 4 - 15
Figure 4-4: CO Line Configuration
Column
In di ca tes:
1COLineNumber
2 Status:
†OOSst atus can indicate the ent ire card isoutofservi ce.
†IN Sstatus can indicate a board stat ion isin-servic e and operati ng
co rrec tl y.
I nc om in g = I nc omi ng C O lin e ca l ls a re a ll owed
Ou tg oi ng = Out go ing C O lin e c al ls a re a ll owed
B ot hw ay = B oth in co mi ng a nd ou tg oi ng CO l in e ca ll s a re a llo wed
For example, Outgoing Enabled indicates the CO line is...

4- 16 Re mo te M ai nte nance
Event Tr ac e Buf fer
TheEventTraceBufferisusedtostoreanddumpeventtraces(upto30)
tha t occur jus t prior to aSTARPLUSTri ad- SS yst em soft or ha rd re st ar t.
These can then be reviewed by authorized personnel to aid in system
troubles hooting.
The ba si c for mat for t he comman ds a re as fol lo ws:
Tabl e 4 -7 : Eve n t Tr ace Bu ffe r Co m man d s
Command Function
t  Di splays the current st at us of the Event Trace B uffer.
t 0 Tur ns t he Trace b u ffer OFF.
t 1  Tur...

Remo t e Mai n tena nce 4 - 17
DT M F R ece iver Tra ce
The CONFIG utility allows technicians to take specific DTMF receivers
in/out of serv ice. T his is us eful fo r troublesh ooting D TMF receiver
pr oble ms to is ola te a spe c if ic D TM F re c ei ve r t hat m ay b e f aul ty.
1. Conne ct a PC with co mmunica tion s oftware to the I/O port 1 on the
MISU.
2. At the ENTER PASSWORD> prompt, typeCO N F IGand pre ss [EN TE R] .
Basi c F orma t for Comma nds:
d< space>r< return >- t o d isp lay t he s ta...