Vivitek Dw864 User Manual

— 72 — 
HDMI Q &  A 
Q. What is the difference between a “Standard” HDMI cable  and a “High-Speed” HDMI 
cable? 
Rec e ntly,  HDM I L ice ns i ng,  L L C  a n n o u nce d  t h at  ca b le s  wo ul d  b e  test e d  as  St an d a r d  o r  Hi g h-
Speed  cables.  
˙St a n d ar d  ( o r  “c at e g or y  1 ” )  HDM I  c a bl es  h a ve  b e e n  te ste d  t o  pe r fo r m  at  s p e e ds  o f  7 5M hz  o r  
up  to  2.25Gbps,  which  is  the  equiva l ent  of  a  720p/108 0 i  signal.  
˙ Hi g h  Sp e e d...

– 73 – 
SPECIFICATIONS 
Specificat ions 
Mode l D863 DX864 DW 866 
Displa y  type TI  DMD 0.55” TI  DMD 0.65” 
Re solution XGA 1024x768 W XGA,  1280x800 
Proje ction dista nce 1 ~ 10 m 
Proje ction scre e n  size 25.6”  ~ 308” 27.1- 302.2 
Proje ction le ns Manual  Focus/Manual  Zoom 
Zoom  ra tio 1.2x 1.1x 
Ve rtica l ke ystone   corre ction +/- 40 steps 
Proje ction me thods Front,  Rear,  Desktop/Ceiling  (Rear,  Front) 
Da ta  compa tibility VGA, SVGA, XGA,  SXGA, SXGA+,  UXGA,  W UXGA@60hz, Mac...

— 74 — 
Projection Distance vs. Projection Size 
 
Projection Distance and Size Table 
XGA D863 / DX864 
D863 / DX864 
IMAGE 
DIAGONAL IMAGE WIDTH IMAGE HIGHT 
PROJECTION 
DISTANCE  
FROM 
PROJECTION 
DISTANCE 
TO 
OFFSET-A
（INCH） （INCH） ( CM ) （INCH） ( CM ) （INCH）( CM ) （INCH） ( CM ) ( MM ) 
60  48  121.9  36  91.4  76.8   195.1  92.2   234.1   128 
70 56 142.2 42 106.7 89.6    227.6  107.5   273.1   149.4 
72 57.6 146.3 43.2 109.7 92.2   234.1  110.6   280.9   153.6 
80 64 162.6 48 121.9 102.4  260.1...

– 75  – 
WXGA DW866 
DW866 
IMAGE 
DIAGONAL IMAGE WIDTH IMAGE HIGHT 
PROJECTION 
DISTANCE  
FROM 
PROJECTION 
DISTANCE 
TO 
OFFSET-A
（INCH） （INCH） ( CM ) （INCH） ( CM ) （INCH）( CM ) （INCH） ( CM ) ( MM ) 
60 50.9 129.3 31.8 80.8 78.4   199.0  87.0  221.0   92.9 
70 59.4 150.9 37.1 94.2 91.4   232.2  101.5   257.8   108.4 
72 61.1 155.2 38.2 97 94.0   238.8  104.4   265.2   111.5 
80 67.8 172.2 42.4 107.7 104.5  265.4  116.0   294.7   123.9 
84 71.2 180.9 44.5 113 109.7  278.6  121.8   309.4   130.0 
90...

— 76 — 
Timing  Mode  Table 
SIGNAL RESOLUTION H-SYNC  
(KHZ) 
V-SYNC 
(HZ) 
COMPOSITE 
/ S-VIDEO COMPONENT RGB DVI/ 
HDMI 
NTSC － 15.734 60.0 O － － － 
PAL/SECAM － 15.625 50.0 O － － － 
VESA 
720 x 400 37.9 85.0 － － O O 
640  x 480 31.5 60.0 － － O O 
640  x 480 37.9 72.0 － － O O 
640  x 480 37.5 75.0 － － O O 
640  x 480 43.3 85.0 － － O O 
800  x 600 35.2 56.0 － － O O 
800  x 600 37.9 60.0 － － O O 
800  x 600 48.1 72.0 － － O O 
800  x 600 46.9 75.0 － － O O 
800  x 600 53.7 85.0 － － O O 
1024  x 768 48.4...

– 77 – 
SIGNAL RESOLUTION H-SYNC  
(KHZ) 
V-SYNC 
(HZ) 
COMPOSITE 
/ S-VIDEO COMPONENT RGB DVI/ 
HDMI 
832  x 624 49.725 74.55 － － O O 
1024  x 768 60.24 75.0 － － O O 
1152  x 870 68.68 75.06 － － O O 
SDTV 
480i 15.734 60.0 － O － O 
576i 15.625 50.0 － O － O 
EDTV 
480p 31.469 60.0 － O － O 
576p 31.25 50.0 － O － O 
HDTV 
720p 37.5 50.0 － O － O 
720p 45.0 60.0 － O － O 
1080i 33.8 60.0 － O － O 
1080i 28.1 50.0 － O － O 
1080p 67.5 60.0 － O － O 
1080p 56.3 50.0 － O － O 
O: Frequency supported 
—: Frequency...

— 78 — 
Projector  Dimensions 
 
  
 
 
 
TEMPPOWERLAMP
2
6
1
m
m
(1
0
.3
)
1
2
2
m
m
(4
.8
)
1
3
0
m
m
(5
.1
1
)
285mm
( 11 . 2 2  )  

– 79 – 
REGULATORY COMPLIANCE 
FCC  W arning 
This equipment has been tested and found to comply with  the limits  for a Class B digital device 
pursuant to Part 15 of the FCC Rules. These limits  are designed to provide reasonable protection 
against harmful interference when the equipment is operated in a commercial  environment. 
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and 
used in accordance with the instruction manual, may cause harmful...

— 80 — 
APPENDIX I 
RS-232C Protocol 
RS232 Setting 
Baud rate: 9600 
Parity 
check: None 
Data bit: 8 
Stop bit: 1 
Flow 
Control None 
Minimum  delay for next  command: 1ms 
 
Control Command Structure        
                  
 
P1       P2 
Pin no.   Name   Pin no. 
1   NC   1 
2   RXD   3 
3   TXD   2 
4   NC   4 
5   GND   5 
6   NC   6 
7   RTS   7 
8   CTS   8 
9   NC   9 
 
 
 
 
 
   

– 81 – 
 Header code Command code Data code End code 
HEX  Command Data 0Dh 
ASCII ‘V’ Command Data CR 
Operation Command 
Note: 
CR mean Carriage Return 
XX=00-98, projectors ID, XX=99  is for all projectors 
Return Result P=Pass / F=Fail 
n: 0:Disable/1: Enable/Value(0~9999)  
  
Command Group 00 
ASCII Function Description Return Result 
VXXS0001 Power On   P/F 
VXXS0002 Power Off   P/F 
VXXS0003 Resync   P/F 
VXXG0004 Get Lamp Hours   Pn/F 
VXXS0005n Set Air filter  timer n=0~999999 P/F 
VXXG0005 Get...