Vivitek Dw864 User Manual

DX864 / DW866 series 

— i — 
Ver.：1 
Copyright  
This  public ation,  inclu ding  all  p hoto gr aphs,  illustratio ns  an d  so ftwa re,  is  p rotected  un der  i nter natio nal  
copyright l aws, wit h all  rights r eser ve d. Neithe r this ma nu al, no r a ny o f the  mate rial co ntaine d h er ein, m ay 
be  reproduced  without  written  consent of  the author. 
©  Copyright  2012 
Disclaimer 
The  in fo rmatio n  in  this  document  is  subject  to  change  without  n otice.  Th e  man ufacture r  makes  no  
rep rese...

— ii — 
Important Safety Information 
 Important: 
It is strongly recommended that you read this section carefully before using the projector. These 
safety and usage instructions will  ensure that you enjoy many  years of safe use of the projector. 
Keep  this manual for future reference. 
Symbols Used 
W arning  symbols are  used  on the unit  and  in this manual  to alert  you of  hazardous  situations.  
The  following  styles are  used  in this manual  to alert you to important  information. 
Note:...

–iii – 
Projector Installation  Notice 
 Place the projector  in a horizontal  position 
The tilt angle  of the  projector  should  not exceed  15 degrees, nor  should  the  projector  be 
installed  in any way other  than  the desktop  and  ceiling mount,  otherwise  lamp life  could  decrease 
dramatically,  and  may lead  to other unpredictable  damages. 
     
 Allow  at least 50  cm clearance  around  the exhaust  vent. 
    
   
 
 Ensure  that the intake vents do  not recycle hot air  from...

— iv — 
Verify Installation  Location 
 To  supply  power,  the  3-blade  (with  earthing  lead)  socket should  be  used to ensure  proper 
grounding  and  equalized  ground  potential  for  all  of the  equipment  in the Projector  System. 
 The  power  code provided  with the Projector  should  be  used. In  case of any  missing item, other 
qualified  3-blade  (with earthing  lead)  power  cord can  be used  as substitution; however,  do  not use 
2-blade  power  cord. 
 Verify  if the voltage  is...

–v – 
Power Safety 
 Only use the  supplied  power  cord. 
 Do  not place  anything  on the  power  cord. Place the power  cord  where  it will  not be in the  way of 
foot  traffic. 
 Remove  the  batteries from  the remote  control  when  storing or  not in use  for  a prolonged  period. 
Replacing the Lamp 
Repl acing  the  lamp  can  be  h azar dous  if  do ne  incor rectly.  See Replacin g  the  Projection  Lam p on  pa ge 63 
for  clear  and  safe  instructions for  this procedure.  Before...

— vi — 
Main Features 
 Lightweight  unit,  easy to  pack away  and transport. 
 Compatible with  all  major video standards including  NTSC, PAL, and SECAM. 
 A high  brightness rating  allows  for presentations in daylight  or in  lit rooms. 
 Supports resolutions up to UXGA at 16.7  million colors to deliver crisp, clear images. 
 Flexible  setup allows  for  front, rear projections. 
 Line-of-vision projections remain square, with  advanced keystone correction for angled 
projections. 
 Input...

–vii – 
Table of Contents 
GET TING ST ART ED .................................................................................................................................. 1 
PA CKING CHECKL IS T.................................................................................................................................. 1 
Standa rd  Accessories.......................................................................................................................... 1 
Option al...

— viii — 
LAN Con nection................................................................................................................................. 50 
W iFi Conn ecting ................................................................................................................................ 52 
Con necting  a USB Device .................................................................................................................. 54 
DIS PLA Y  MEDIA...

– 1 – 
GETTING STARTED 
Packing  Checklist 
Carefully unpack the projector and check that the following  items are included:  
 
DLP PROJECTOR W ITH LENS CAP  
Standard  Accessories 
   
REMOTE CONTROL  
(W ITH TW O AAA BATTERIES) 
RGB CABLE POW ER CORD 
   
CD-ROM  
(THIS USER’S MANUAL) 
QUICK START GUIDE WARRANTY CARD 
Optional Accessories 
 
 
 
W IFI DONGLE CARRYING CASE  
Contact your dealer immediately if any items are missing, appear damaged, or if the unit does not work. It 
is recommend that you...