Vivitek D858wtpb User Manual
Have a look at the manual Vivitek D858wtpb User Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 263 Vivitek manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
Preface – 51 – SPECIFICATIONS Specifications Model D856STPB D858WTPB Display type TI DMD 0.55” TI DMD 0.65” Resolution XGA 1024x768 WXGA 1280x800 Projection distance 0.66m ~ 1.69m Projection screen size 49.9 ~ 127.9 58.4 ~ 149.4 Projection lens Manual Focus/Fix Zoom Zoom ratio Fix Vertical keystone correction +/- 40 steps Projection methods Front, Rear, Desktop/Ceiling (Rear, Front) Data compatibility VGA, SVGA, XGA, SXGA, SXGA+, UXGA, Mac SDTV/EDTV/ HDTV 480i, 480p, 720p, 1080i, 1080p Video compatibility NTSC/NTSC 4.43, PAL (B /G/H/I/M/N/60), SECAM H-Sync 15, 30 – 90 kHz V-Sync 43 – 85 Hz Safety certification CE, CB Operation temperature 5° ~ 35°C Dimensions 306 mm (W) x 206 mm (D) x 104 mm (H) AC Input AC Universal 100-240, Typical @ 110VAC (100-240)/+-10% Power consumption Typical 280W (Normal) / Typical 240W (Eco) Stand By
DLP Projector—User’s Manual Projection Distance vs. Projection Size Projection Distance and Size Table D856STPB IMAGE DIAGONAL （INCH） IMAGE WIDTH (INCH) IMAGE HIGHT (INCH) PROJECTION DISTANCE （MM） FROM OFFSET-A ( MM ) 49.9 39.92 29.94 659.1 108.4 60 48 36 792.5 130.3 80 64 48 1056.6 173.7 100 80 60 1320.8 217.2 120 96 72 1585.0 260.6 127.9 102.32 76.74 1689.3 277.8 D858WTPB IMAGE DIAGONAL （INCH） IMAGE WIDTH (INCH) IMAGE HIGHT (INCH) PROJECTION DISTANCE （MM） FROM OFFSET-A ( MM ) 58.4 49.52 30.95 660.4 92.2 60 50.88 31.80 678.5 94.8 70 59.36 37.10 791.6 110.5 80 67.84 42.40 904.6 126.3 100 84.80 53.00 1130.8 157.9 120 101.76 63.60 1357.0 189.5 149.4 126.69 79.18 1689.4 235.9 — 52 —
Preface – 53 – Timing Mode Table SIGNAL RESOLUTION H-SYNC (KHZ) V-SYNC (HZ) COMPOSITE / S-VIDEOCOMPONENT RGB DVI/ HDMI NTSC － 15.734 60.0 O － － － PAL/SECAM － 15.625 50.0 O － － － 720 x 400 37.9 85.0 － － O O 640 x 480 31.5 60.0 － － O O 640 x 480 37.9 72.0 － － O O 640 x 480 37.5 75.0 － － O O 640 x 480 43.3 85.0 － － O O 800 x 600 35.2 56.0 － － O O 800 x 600 37.9 60.0 － － O O 800 x 600 48.1 72.0 － － O O 800 x 600 46.9 75.0 － － O O 800 x 600 53.7 85.0 － － O O 1024 x 768 48.4 60.0 － － O O 1024 x 768 56.5 70.0 － － O O 1024 x 768 60.0 75.0 － － O O 1024 x 768 68.7 85.0 － － O O 1280 x 800 49.7 59.8 － － O O 1280 x 800 62.8 74.9 － － O O 1280 x 800 71.6 84.8 － － O O 1280 x 1024 63.98 60.0 － － O O 1280 x 1024 79.98 75.0 － － O O 1280 x 1024 91.10 85.0 － － O O 1280 x 960 60.0 60.0 － － O O 1280 x 960 85.9 85.0 － － O O 1400 x 1050 65.3 60.0 － － O O 1440 x 900 70.6 75.0 － － O O VESA 1440 x 900 55.6 60.0 － － O O
DLP Projector—User’s Manual — 54 — SIGNAL RESOLUTION H-SYNC (KHZ) V-SYNC (HZ) COMPOSITE / S-VIDEOCOMPONENT RGB DVI/ HDMI 1600 x 1200 75.0 60.0 － － O O 640 x 480 35.0 66.68 － － O O 832 x 624 49.725 74.55 － － O O 1024 x 768 60.24 75.0 － － O O Apple Mac 1152 x 870 68.68 75.06 － － O O 480i 15.734 60.0 － O － O SDTV 576i 15.625 50.0 － O － O 480p 31.469 60.0 － O － O EDTV 576p 31.25 50.0 － O － O 720p 37.5 50.0 － O － O 720p 45.0 60.0 － O － O 1080i 33.8 60.0 － O － O 1080i 28.1 50.0 － O － O 1080p 67.5 60.0 － O － O HDTV 1080p 56.3 50.0 － O － O O: Frequency supported —: Frequency not supported * : Displayable level
DLP Projector—User’s Manual — 56 — REGULATORY COMPLIANCE FEDERAL COMMUNICATIONS COMMISSI ON INTERFERENCE STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pur- suant to part 15 of the FCC Rule s. These limits are designed to pr ovide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate ra- dio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equi pment does cause harmful interference to radio or television reception, which can be determined by turning the equipm ent off and on, the user is en- couraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit diffe rent from that to which the receiver is con- nected. -Consult the dealer or an experienced radio/ TV technician for help. CAUTION: Any changes or modifications not expressly approved by the grantee of this device could void the users authority to operate the equipment. RF exposure warning This equipment must be installed and operated in accordance with provided instructions and the an- tenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter. End-users and installers must be pr ovide with antenna installation instructions and transmitter operating conditions for satisfying RF exposure compliance. Safety Certifications CE, CB
Preface
–
57 –
APPENDIX I
RS-232C Protocol
RS232 Setting
Baud rate: 9600
Parity
check: None
Data bit:
8
Stop bit: 1
Flow Con-
trol None
Minimum delay for next command:
1ms
Control Command Structure
Header code Command code Data code End code
HEX Command Data 0Dh
ASCII ｀V’ Command Data CR
Operation Command
Note:
XX=00-98, projectors ID, XX=99 is for all projectors
Return Result P=Pass / F=Fail
n: 0:Disable/1: E nable/Value(0~9999)
Command Group 00
ASCII Function Description Return Result
VXXS0001 Power On P/F
VXXS0002 Power Off P/F
VXXS0003 Resync P/F
VXXG0004 Get Lamp Hours Pn/F
VXXS0006 System Reset P/F
VXXG0007 Get System Status 0:Reset
1:Standby
2:Operation
3:Cooling Pn/F
VXXG000
8Get F/W Version Pn/F
Command Group 01
ASCII Function Description Return Value
VXXG0101 Get Brightness n=0~100 Pn/F
VXXS0101n Set Brightness n=0~100 P/F
VXXG0102 Get Contrast n=0~100 Pn/F
VXXS0102n Set Contrast n=0~100 P/F
VXXG0103 Get Color n=0~100 Pn/F
VXXS0103n Set Color n=0~100 P/F
VXXG0104 Get Tint n=0~100 Pn/F
VXXS0104n Set Tint n=0~100 P/F
VXXG0105 Get Sharpness 0~31 Pn/F
DLP Projector—User’s Manual — 58 — VXXS0105n Set Sharpness 0~31 P/F VXXG0106 Get Color Temperature 0:Cold 1:Normal 2:Warm Pn/F VXXS0106n Set Color Temperature 0:Cold 1:Normal 2:Warm P/F VXXG0107 Get Gamma 0:PC 1:MAC 2:Video 3:Chart 4: B&W Pn/F VXXS0107n Set Gamma 0:PC 1:MAC 2:Video 3:Chart 4: B&W P/F Command Group 02 ASCII Function Description Return Value VXXS0201 Select RGB P/F VXXS0202 Select RGB2 P/F VXXS0203 Select DVI P/F VXXS0204 Select Video P/F VXXS0205 Select S-Video P/F VXXS0206 Select HDMI P/F VXXS0207 Select BNC P/F VXXG0220 Get Current Source Return 1:RGB 2:RGB2 3:DVI 4:Video 5:S-Video 6:HDMI 7:BNC Pn/F Command Group 03 ASCII Function Description Return Value VXXG0301 Get Scaling 0: Fill 1: 4:3 2: 16:9 3 :Letter Box 4 :Native Pn/F VXXS0301n Set Scaling 0: Fill 1: 4:3 2: 16:9 3 :Letter Box 4 :Native P/F VXXG0302 Blank Pn/F VXXS0302n Blank P/F
Preface – 59 – VXXG0303 Auto Keystone On Pn/F VXXS0303n Auto Keystone On P/F VXXG0304 Freeze On Pn/F VXXS0304n Freeze On P/F VXXG0305 Volume n=0~8 Pn/F VXXS0305n Volume n=0~8 P/F VXXG0308 Projection Mode 0:Front 1:Rear 2:Ceiling 3:Rear+Ceiling Pn/F VXXS0308n Projection Mode 0:Front 1:Rear 2:Ceiling 3:Rear+Ceiling P/F VXXG0309 Get vertical keystone value n= -40~40 Pn/F VXXS0309n Set vertical keystone value n= -40~40 P/F VXXG0311 Adjust the zoom n=-10~10 Pn/F VXXS0311n Adjust the zoom n=-10~10 P/F Command Group 04 (Remote Control) ASCII Function Description Return Value VXXS0401 UP arrow P/F VXXS0402 DOWN arrow P/F VXXS0403 LEFT arrow P/F VXXS0404 RIGHT arrow P/F VXXS0405 POWER P/F VXXS0406 EXIT P/F VXXS0407 INPUT P/F VXXS0408 AUTO P/F VXXS0409 KEYSTONE+ P/F VXXS0410 KEYSTONE- P/F VXXS0411 MENU P/F VXXS0412 STATUS P/F VXXS0413 MUTE P/F VXXS0414 ZOOM+ P/F VXXS0415 ZOOM- P/F VXXS0416 BLANK P/F VXXS0417 FREEZE P/F VXXS0418 VOLUME+ P/F VXXS0419 VOLUME- P/F VXXS0420 Enter P/F