Vivitek D858wtpb User Manual

Copyright  
This publication, including all photographs, illustrations and software, is protected under international copy-
right laws, with all rights reserved. Neither this man ual, nor any of the material contained herein, may be 
reproduced without written consent of the author. 
© Copyright 2012 
Disclaimer 
The information in this document is subject to change without notice. The manufacturer makes no repre-
sentations or warranties with respect to the cont ents hereof and specifically disclaims...

DLP Projector—User’s Manual 
— ii — 
Important Safety Information 
Important: 
It is strongly recommended that you read this sect ion carefully before using the projector. These 
safety and usage instructions will ensure that you enj oy many years of safe use of the projector. 
Keep this manual for future reference. 
Symbols Used 
Warning symbols are used on the unit and in this ma nual to alert you of hazardous situations.  
The following styles are used in this manual to alert you to important...

 
 
  Preface 
Projector Installation Notice 
¾
  Place the projector in a horizontal position 
The tilt angle of the projector should not exceed 15 degrees , nor should the projector be in-
stalled in any way other than the desktop and ceiling mount, otherwise lamp life could decrease 
dramatically, and may lead to other  unpredictable damages. 
     
¾   Allow at least 50 cm clearance around the exhaust vent. 
  
 
  
 
 
¾   Ensure that the intake vents do not recycle hot air from the exhaust vent. 
¾...

DLP Projector—User’s Manual 
— iv — 
Verify Installation Location 
¾  To supply power, the 3-blade (with earthing lead) socket should be used to ensure proper 
grounding and equalized ground potential for all of the equipment in the Projector System. 
¾   The power code provided with the Projector should  be used. In case of any missing item, other 
qualified 3-blade (with earthing lead) power cord c an be used as substitution; however, do not use 
2-blade power cord. 
¾   Verify if the voltage is...

 
 
  Preface 
–
 v  – 
Choosing a Projector 
Edge blending application 
¾   Not only brightness, bright balances, lens but st ability is important too when choosing a projector. 
¾   A projector need 30 to 60 minutes warm up to adjust properly. 
¾   After lens shift, there should not be any optical  distortion such as trapezoidal and barrel shape 
distortions. 
¾   Quick dis-assemble lens need to  be firmly secured, the electric motor cannot be mistakenly shift. 
The screen should not be offset for long...

DLP Projector—User’s Manual 
Power Safety 
¾  Only use the supplied power cord. 
¾   Do not place anything on the powe r cord. Place the power cord where it will not be in the way of 
foot traffic. 
¾   Remove the batteries from the remote control when storing or not in use for a prolonged period. 
Replacing the Lamp 
Replacing the lamp can be hazardous if done incorrectly. See  Replacing the Projection Lamp on page 41 
for clear and safe instructions for this procedure. Before replacing the lamp: 
¾...

 
 
  Preface 
–
 vii  – 
Main Features 
•  Lightweight unit, easy to pack away and transport. 
•   Compatible with all major video standards including NTSC, PAL, and SECAM. 
•   A high brightness rating allows for presentations in daylight or in lit rooms. 
•   Supports resolutions up to UXGA at 16.7 million colors to deliver crisp, clear images. 
•   Flexible setup allows for front, rear projections. 
•   Line-of-vision projections remain square, with advanced keystone correction for angled...

DLP Projector—User’s Manual 
— viii  — 
Table of Contents 
GETTING STARTED ........................................................................\
.................................................................................. 1 
PACKING CHECKLIST........................................................................\
................................................................................... 1 
VIEWS OF PROJECTOR...

 
 
  Preface 
–
 ix  – 
LED ERROR MESSAGES........................................................................\
............................................................................. 48 
IMAGE PROBLEMS........................................................................\
...................................................................................... 48 
LAMP PROBLEMS........................................................................\...