ViewSonic Projector PJD6230 User Manual

ViewSonic 4 PJD6220/PJD6230/PJD6240Rear View 
Connection portsKensington lock
Rear IR remote control sensor
Ventilation holes
Bottom View
Elevator footCeiling mount (M4 x L7.5mm)
Tilt-adjustment foot
1
3
2
4
1234
12
3
123
„
This projector can be used with a ceiling mount for support. The ceiling mount is
not included in the package. 

ViewSonic 5 PJD6220/PJD6230/PJD6240Using the ProductControl PanelLED
Button Function
Lamp (Lamp LED indicator)
Refer to “LED Indicator Messages”.
Te m p  (Temperature LED indicator)
Refer to “LED Indicator Messages”. 
Four directional buttonsUse four directional buttons to select items or make adjustments to your  selection.EnterEnter to sub-menu and confirm the menu selection. Activate in Color Setting, LampCounter Reset and Factory Default menu operations.
Resync
Resynchronize the projector to the...

ViewSonic 6 PJD6220/PJD6230/PJD6240Connection Ports
LAN
For network control.
Audio OutConnect to a speaker or other audio input equipment.Computer OutConnect to a computer display, etc.Audio InConnect an audio output from video equipment to this jack.Computer InConnect image input signal (analog RGB or component) to this jack.Computer InConnect image input signal (analog RGB or component) to this jack.RS-232When operating the projector via a computer, connect this to the controlling computers
RS-232C...

ViewSonic7PJD6220/PJD6230/PJD6240Remote Control
Power
Turn the projector on or off.
Four directional buttons
-Use four directional buttons to
select items or make adjustments
to your selection.
- The right button acts as Blank 
Screen function. Cut off the screen 
temporarily. Press again to cancel 
the Blank Screen function.
MENUDisplay or exit the on-screen display
menus.Laser
Aim the remote at the viewing
screen, press and hold this button
to activate the laser pointer.
Four directional buttons...

ViewSonic 8 PJD6220/PJD6230/PJD6240Installing the Batteries1. Open the battery cover in the direction shown.
2. Install batteries as  indicated by the diagram
Inside the compartment.3. Close the battery cover into position.
„
Keep the batteries out of the reach of children. There is a danger of death by 
accidentally swallowing the batteries.
„
Do not recharge the used batteries or expose the batteries to fire or water.
„
Do not dispose of the used batteries along with household waste. Dispose of 
used...

ViewSonic 9 PJD6220/PJD6230/PJD6240Remote Control OperationPoint the remote control at the infrared remote sensor and press a button.„
Operating the projector from
the front
„
Operating the projector from
the rear
10
15
7m5m
5m
10
15
7m5m
5m
„
Do not point the laser pointer directly to the peoples eyes (especiallyn small 
children). There is a danger of injuiry to the eyes.
„
The remote control may not operate when there is sunlight or other strong light
such as a fluorescent lamp shining on the remote...

ViewSonic 10 PJD6220/PJD6230/PJD6240
Installation
Connecting the Projector
VGA Cable (D-Sub to D-Sub) VGA (D-Sub) to HDTV (RCA) Cable
Audio Cable S-Video Cable
RS-232 Cable Composite Video Cable
USB Cable Internet Cable15
26
37
48
Desktop type
Laptop type
41112
7
3
6525
8
„When connecting cable, power cords of both a projector and external 
equipment should be disconnected from AC outlet.„The figure above is a sample connection. This does not mean that all of 
these devices can or must be connected...

ViewSonic 11 PJD6220/PJD6230/PJD6240Powering On/Off the ProjectorPowering On the Projector:1. Remove the projector lens cap.
2. Complete the AC power cord and peripheral signal cable(s) connections.
3. Press   button to turn on the projector. The projector takes a minute or so to warm up. 
4. Turn on your source (computer, notebook, DVD, etc.). The projector automatically detects your source.
„
If you are connecting multiple sources to the projector simultaneously, press
the  Source  button.
Warning:
„...

ViewSonic 12 PJD6220/PJD6230/PJD6240Adjusting the ProjectorAdjusting the Projector HeightThe projector is equipped with an elevator foot to adjust the image height.
To raise or lower the image:1. To raise or lower the image, press the elevator button and raise or lower the frontof the projector. Release the button to lock the adjustment.2. To level the image on the screen, turn the tilt-adjustment foot to fine-tune the height.Adjusting the Projector Zoom and Focus1. Focus the image by rotating the focus...

ViewSonic 13 PJD6220/PJD6230/PJD6240Adjusting Projection Image SizeRefer to the graphic and table below to determine the screen size and projection distance.
Projection Distance (meters) Screen Size (for 4:3 aspect ratio diagonal length)
Wide (inches) Tele (inches)
1.2 30.08 27.34 2 49.96 45.57
3 74.94  68.35
5 124.90 113.92
10 249.80 227.83
30.08
(Min.)
49.96
74.94
124.90
249.80
(Max.)
227.83
113.9268.3545.57
27.34
1.2m
3.0m
5.0m
10.0m 2.0m
„
Position the projector in a horizontal position; other...