Trillium Talk To 308 Installation Procedures Manual

INDIVIDUAL FEATURE PROGRAMMINGl For each subsequent number to be programmed, pressthe speed key, dial the two digit access code, followed
by the speed call number to be programmed.
At the completion of programming:
l Press the speaker on/off key.l 
int. indicator stops flashing.
Common Speed Calling List
New numbers can be entered at anytime. Simply
press the 
speed key, dial the two digit access code, enter
the speed call number, and then press the 
speaker on/off
key.Speed call numbers can be access...

TROUBLESHOOTING
TroubleshootingThe purpose of this section is to assist maintenance
personnel in locating and clearing faults in the 
Talk70 308
System.The system is composed of the following major
components:
l KSU
l TalkTo 308 Setsl Door Answering Option
l Power Fail Option
l Communications cabling
l C.O./PABX linesIt is the intent of this section to assist the
maintenance personnel in determining which of the above
items are at fault and the corrective actions to be taken.
All 
TalkTo 308 System...

TROUBLESHOOTING22SET REPORTED
INOPERATIVE
.“ESaTHE TROUBLENOGO TOwSYSTEM CHECK
NOTE RETURN ANY DEFECTIVE “NITS FOR 
REPAlRYES
REPAlR4THE TROUBLE
DEFECTIVE
STATION 
WIRING
I
Station Check 

TROUBLESHOOTINGTO ACCESSC 0 /PAM LINES
1YES
INOI
f-9CORRECT WIRING
ANDRECONNECT KSU
THE TROUBLE
IYES
(Yk-)
C.O./PABX Line Access Chmk 

TROUBLESHOOTING
DOOR MODULE
THE TROUBLE
CHECK WIRINGDOOR ANSWER “NITTO DOOR MODULE
(k)NOTE RETURN ANY 
DEFEdTlVE UNITS FOR REPAIR
Door Answering - One Door Module
24 

TROUBLESHOOTINGf
DOOR ANSWERINGOPERATIVENOTE RETURN ANY DEFECTIVE “NITS FOR REPNR
Door Answering -Two Door Modules
25 

26 

SYSTEM PROGRAMMINGSystem Requirements -for Programming
For the system to be programmed to meet your re-quirements, it is necessary to decide what features are
needed, and what parameters are required for those
features selected. The following notes are intended to aid
you in choosing the correct features and parameters, For
reference purposes, please complete the accompanyingprogramming form.
(1) Hold Recall Time: Determines the time period
between putting a caller on hold and receiving a tone
reminder...

&STEM PROGRAMMING
Customer Feature Selection
‘Select one item per Line
HoldRecall(l)*1min02min03min0NoRecall0Tone Duration 
(2)*I55ms 0 75ms 0
Flash/Cancel (3) *Flash 0250 ms q 500ms 0 1 set 0 3 set Cl
Cancel q
500ms is recommended for calibrated flash
Pause on Number (4)Yes 
070809000
No 
0C.O./PABX LINE (5)
C.O. 0102G30
PABX qICI2030Incoming Call Only By Line (6)
YesqLine10Line20Line3q
No0Outgoing Call Restriction
By Station (7)
Stn/ClassYes 
0No 
0Night Transfer (8)
Yes 
0stn# q q mm
q mmmPrivate...