Trillium Talk To 1032 System Manual

: ! n a one internal and two external party conference. 
n a three internal party conference. 
.: 
To Set Up a Conference - 1 external party, 2 
internal par-ties 
When an outside call is already in progress, an 
internal party may be added to the call; 
n Press the hold key. 
n Press and release the hookswitch (a continuous tone 
is heard). 
6’ :q 
m Handsfree Sets may remain on-hook. 
‘; , 
Ensure the microphone indicator is On. 
Press the speaker key. 
n Dial the station number of the party to be...

To answer an All Stalioil Page - (Meet Me Answer) 
n Lift your handset. 
n Dial* 1. 
You are now connected to the calling party. 
External Loudspeaker Paging 
This feature allows any Set user to make an 
announcement through a customer-provided external 
paging system. 
To Make an Announcement 
H Lift the handset 
m Handsfree Sets may remain on-hook. 
Ensure the microphone indicator is On. 
Press the speaker key. 
n Dial 59. A short tone is heard. 
n Make your announcement. 
Private Speed Call 
n...

To dial private numbers off-hook 
n Lift the handset. 
n Press an unused line key. 
n Press the appropriate key on the Display (10 to 26). 
Common Speed Call 
A maximum of 80 telephone numbers, each up to 
16 digits in length can be programmed as common 
speed call numbers. Programmed telephone numbers 
may contain feature access codes for Centrex, PABX 
and custom calling networks. Long distance telephone 
numbers can be accessed by all Set users even if Class 
B toll restrictions are programmed....

background music is available through the speaker of 
your Set or through the external paging system (if 
connected). 
Calls placed on hold will hear the background music 
automatically. 
. 
n Replace the handset. 
To turn background music off repeat the above 
procedure. 
W Replace the handset. 
To turn the external music off, repeat the above 
procedure. 
Night Transfer 
The System has been preprogrammed during the 
installation procedure, so that selected TalkTo 1032 Sets 
will ring when Night...

Your Set is equipped with a number of indicator 
lamps which show the status of your Talk70 1032 
System. The differences between flashing rates and tones 
will become clearer as you become more familiar 
with your Set. 
The corresponding line is idle and mav be used 
Call in progress on corresponding line at another Set. 
The corresponding line is selected at your Set. 
A call is on hold at another Set. 
Incoming telephone call or incoming door call. 
m m m m I 
A call is on hold at your Set. 
n n n n n...

Outside Lines IO (9 with Door Answer) 
TalkTo Stations :. ,32 
Intercom Speech Paths .3 
Door Modules ,2 
Power Fail Transfer .3 Units maximum: 
1 Unit transfers 4 outside lines to 4 standard telephones. 
2 Units transfers 8 outside lines to 8 standard telephones. 
3 Units transfers 10 outside lines to 10 standard telephones. 
AC Power Requirements 115 Volts-+ 10% @O/60 Hz) 1 Amp max. 
Paging Output Level ,200 mV rms into 600 ohms 
Music Input Level .50 mV rms max. 
C.O. Loop Limit 1500 ohms 
Station...

This section assists in locating and correcting any 
faults which may occur during the installation and 
programming of your Ta/kTp 1032 System. 
Probable Cause 
Incorrect wiring. 
Probable Solution 
Make sure there are no open or short connections along 
that run of station wiring. Refer to the station wiring 
tables in the TalkTo 7032 Installation Guide. 
Cable disconnected. Check to see that the Set’s modular cord is plugged into 
the modular jack. 
Main Distribution Frame connection Ensure that all...

i 
. 
i 
. . 
Probable Cause 
Faulty telephone line connection to the KSU. 
Probable Solution 
Ensure that the RJ21 telephone line connector is properly 
wired and firmly connected to the KSU as outlined in the 
TalkTo Installation Guide. If the problem persists, 
report the fault to the telephone company. 
Probable Cause 
KSU BATTERY switch is OFF. 
Probable Solution 
Set the KSU BATTERY switch to ON and r.epeat the 
programming steps. 
The # key was not pressed 
Make sure the # key is pressed after...

-. , ,‘f 
. . 
20 
1 
18  

I’ 
19