Toshiba Stratagy Dk Installation Guide

Installation--Stratagy DK
Important!The Strata DK may need to be reset to initialize some Strata programming
assignments. It is important that 
~014 make all such assignments before installing
the Stratagy DK.
1.Using Program 03-Flexible PCB Slot Assignments set/verify the following slot
assignments:
.
Set code 31 for the slot where Stratagy DK is installed (see Step 4 
).
tEnable the Strata DK to receive DTMF signalling from the Stratagy DK:
.
For 
DK424/DK280: Set codes 92, 93, or 94 for slot 00 for...

Stratagy DKInstallation
Table 2Stratagy DK Slot Assignment
DK424
NoteFor the 
DSSIBLF feature, the Stratagy DK must reside in a higher-numbered slot than
the PDKU card that the Stratagy DK will monitor (see Figure 3).
install the card in a universal slot starting with slot 12 (if a PDKU or PEKU is in slot 11) or slot 13 (if a
RSIU is in slot 11)Important! Do not install the Stratagy DK in slots 27, 
28, 37, 37, 38, 47, 48, 57, 57, 58, 67, 68,71, 77, or 78.
To enable end-to-end signaling, ensure that an...

Installation--_.---_ -_---Stratagy DK
Stratagy DK in Odd Number CabinetStratagy DK in Even Number Cabinet
Stratagy DK
PDKU
I I
! I
Cabinet 1
Cabinet 2
Cabinet 3
Cabinet 4
.-“1I I
-.
I I
! ?
:.. .- 1*
I I
I I.’
IPDKU
Stratagy DK
Figure 3Stratagy DK424/DK280 PDKU DSS/Busy Lamp Field Slot Assighment Examples
(console-slot-id configured as 0)
Step 5:Verify Stratagy DK is Functioning ProperlyNoteEach Stratagy DK has been pre-programmed at the factory for out-of-box (plug and
play) operation on the Strata...

Stratagy IIlKInstallationSide
ViewBackplane Connector
Figure 4Stratagy DK
Table 3Stratagy DK Status/Port LEDs
At boot-up:
DarkBlinking Amber
RedNo power
Power-on, self-test.
Failed self-test. The port LEDsindicate which test(s) failed:
Port LEDGreen
Test Failed
1DRAM
2RTC
3EEPROM
4EPROM Checksum
5Hard Disk
6Integration Processor
7DSP #1. . .
While system is 
operarlonal:
GreenSystem is operational.
Green withSystem is operational and hard drive
Blinking Amber is active.Hard Drive
IStrap
Dark
GreenPort...

installation11.----1_----.-I-.Stratagy DK
--
Step 6:Verify that Voice Playback, Basic Auto Attendant and Ports are
Functioning 
correctly
%Dial the extension number for each port, Stratagy should (for each port):
+Answer and play the Toshiba Plug and Play company greeting (“Thank you for
calling.. 
.“), greeting 1 in User ID mailbox 990.
+Continue to play the Toshiba Plug and Play caller instructions greeting (“To reach the
person.. 
.“), greeting 1 in User ID mailbox 991.
Step 7:Connect Portable/Desktop...

Stratagy DKInstallation
Remote Connection
Portable/Desktop Computer Modem
ipPrepare the portable/desktop computer by installing, connecting and configuring a
modem. The modem must be capable of communicating at a minimum of 2400 baud
CAUTION!Internal modems configured for COM ports 3 or 4,are not supported by
Stratagy Admin software.Stratagy Modem
The Stratagy DK can communicate through either an internal or external modem.
InternalThe Stratagy DK has an internal modem that communicates at up to 2400...

Strztagy BK~I_
3.Press any key to continue and the Stratagy Admin program is installed on drive C: in
subdirectory ADMIN3.
Step 9:Configure Stratagy Admin Software
Settings for the communication port in Stratagy Admin must match the corresponding
parameters set in the Stratagy System Configuration file on the Stratagy DK.
For example, if using COM 1 on the portable/desktop computer and serial Port 2 on the
Stratagy DK, the Stratagy Admin Serial Port definitions for 
COMl must be identical to the
serial...

Stratagy DKinstallationTo exit without saving your changes, you may press Esc at any time. The Stratagy Admin
Main screen is displayed.
Table 4Admin PC Configuration Fields
FieldAdvertising
Log FileSerial Port
Baud RateModem lnit
StringDescription/Default
Advertising string that displays when the Main Menu screen blanks after a specified number of
minutes of inactivity (per 
fmo-blank parameter in the install.cfg file).
Possible values:
60-character string. The single quotes are required....

InstallationStratagy DK._-.--__--_..-_~__--_--_---_-l_-_.___.
Step 10: Access Stratagy DK
Prior to accessing Stratagy, verify that Stratagy is operational by making a test call into the
system.
NoteMenu screens detailed in this section are available only in Admin version VSA.2G or
later.
1.From the DOS prompt (C:\ADMIN3), type: admin and press Enter.
The following screen is displayed:.
Important!The portable/desktop computer must be conjigured for the correct serial port in
Stratagy Admin prior to...

Siratfigy Dif-l-.--.--l--lll-_---Installation--
Remote AccessIf a modem is detected in 
Substep 3 on Page 14, Stratagy displays the following screen:
Stratagy Admin software version 
VSA.2G has two modes of accessing the Stratagy DK
remotely:
+Direct Dialing Mode - the Stratagy modem has a dedicated telephone line, enabling you
to dial into the number directly.
+Manual Dialing Mode - the Stratagy modem does not have a dedicated telephone line
and an operator must transfer the call to the modem number....