Toshiba Stratagy Dk Installation Guide

/n.sfal/ation---....-_--...- -~-Stratagy DKA message reading Connect ionestablished appears briefly on the screen and a
version of the standard Main Menu displays (see Figure 7). Proceed to Step 11 “Configure
Stratagy DK”.
Step 11: Configure Stratagy DK
To configure the Stratagy DK, you may need to use the following Tools menu selections:
+Toshiba Plug and Play
+Telephone System Configuration
+Stratagy System Configuration.
For a complete description of the standard menu selections and field...

The following screen displays:Toshiba Plug and PlayThe Stratagy DK is pre-installed for the 
DK280. If you need to change this selection to a
different Strata DK telephone system, change it now using this selection. Otherwise, go to
“Telephone System Configuration” on Page 18.
Selecting this function will:
+change all the settings to the new Toshiba telephone system default values
+delete any User ID mailbox customizations
*install the Strata DK default mailboxes
NoteExisting messages and mailbox...

Installation--_---._ -I___---__-Stratagy DK-The Stratagy utility automatically defines the telephone system dial codes and tone
patterns, system integration patterns and default mailboxes for the specific telephone
system.
NoteIf you only want to change the PBX type, do not use this function. Instead, set the
@x-type parameter in the Stratagy System Configuration screen (see “pbx-type” on
Page 22 for details).
3.When the Toshiba telephone system is complete, press any key to reboot.
‘4The DOS prompt is...

Stratagy DKinstallation
3.After making the change, press ESC and the following screen displays:
Press 1; the changes are transmitted to Stratagy and Stratagy is shut down and restarted.
By shutting down and restarting Stratagy, the changes take effect.
. ..or press 2; the changes are transmitted to Stratagy but Stratagy is not shut down or
restarted. Until you restart Stratagy, the changes do not take effect.
. ..or press 3; the changes you have made are cancelled and not saved.
CAUTION!Care should be...

Stratagy DK3.Press ESC. The following menu is displayed:
Press 1; the changes are transmitted to Stratagy and Stratagy is shut down and restarted.
By shutting down and restarting Stratagy, the changes take effect.
. ..or press 2; the changes are transmitted to Stratagy but Stratagy is not shut down or
restarted. Until you restart Stratagy, the changes do not take effect.
. ..or press 3; the changes you have made are cancelled and not saved.
4.Press 3 to save the changes. Stratagy shuts down and...

Stratagy DKInsfallafion
Table 5Stratagy DK System Configuration Parameters -Definitions and Settings(Confinued)Parameter
:Descriptionconsole-slot-idIdentifies to Stratagy the physical slot in the Strata DK which contains the PDKU
programmed for DSS console in Program 03 (type 
64).The Stratagy DK monitors this slot
for the busy lamp field (see 
&s-active parameter), KSU system time, and Night Transfer
For Strata 
DK16e, DK16, DK24, DK56, and DK96: the console-slot-id is always set to 0(zero). Slot ID 0...

InstallationStratagy DK-Table 5
Stratagy DK System Configuration Parameters - Definitions and Settings(Continued)ParameterDescription
ksu-timeSynchronizes Stratagy IX’s system clock with the system clock of the supporting
Strata DK telephone system.
information obtained by Stratagy DK from the Strata DK system does not contain
“second” time; therefore, there may be a 1 
-60 second difference between the Strata DK
system and the KSU time displayed on the main menu of the Stratagy Admin program.
Important!...

Stratagy DKInstallafion--
’ Message Volume field is not
supported by Stratagy DK‘Alternate Rate field is replaced
by DSS Port field on Stratagy DK
Figure 8Options Screen with Sample Data
DSS PortThe 
DSS Port field corresponds to the “physical” port number of a Strata DK station. This field
enables the Stratagy DK to monitor the Busy Lamp field of a DSS console port to determine if
the station is busy before attempting to transfer.
Due to the Strata DK architecture, only 58 stations can be monitored....

lnstalla tionStratagy DKSome new tokens are available exclusively for the Stratagy DK. They are:
tKM - Enables a portable/desktop computer’s modem to communicate with the
Stratagy DK internal modem (2400 baud) by sending the call to User ID 993.
Example: 
@KM
*KT( ) - Directs calls to a designated User ID when DSS function is active (&s-active =
true), the DSS port is assigned in the “answering” mailbox, and the Night Transfer on the
DSS console is ON.
Syntax: 
KT(XXX)G(WY)where:
Box number used when...

Stratagy DKlnstalla tionStep 14: Stratagy DK Maintenance
To maintain the Stratagy DK, you will need:
+Tools (Main Menu selection)
+ Trace diagnostics
We recommend that before you finish the installation process, you back up your new database,
mailbox names and 
greetings.Tools
The following Tools menu selections will be needed for maintenance of the Stratagy DK (see
Figure 2):
+ Backup Utility
+ Restore Utility
+Upgrade Stratagy software
+Retrieve Trace File
+ Filecopy
Backup UtilityThe Stratagy Backup...