Toshiba Strata Vie General Description Manual

NOTE: 
This procedure is for programming pur- 
poses only! For normal operation, the 
station 17 EKT type must be set using 
Program 4XX. 
02.24 
In all procedures that follow, a single 
key designation is given if it is the same for 
both EKT types. If a difference exists, the 
matching lo- and 20-key designations are 
given first and the upper lo-key designations 
(off-hook) are then indicated inside brackets. 
02.30 
Preparation 
02.31 
Before Strata system data can be 
programmed, option selections...

PROGRAMIWING PROCEDURES 
SECTION 300-006-300 
MAY1986 
four CO line groups (dial 91, 92, 93, and 94) 
are required. Leave blank if one group (dial 9) 
is sufficient. 
4) Two CO Line Conference-mark an X next 
to AD5 to inhibit two CO line conference. 
Leave blank if two CO line conferencing is to 
be permitted. 
5) DP Make Ratio-mark an X next to AD3 if a 
33% make/break timing ratio is required. 
Leave blank if 40% is sufficient. 
6) MF Signal Time- mark an X next to AD2 if 
160 ms MF signal time is...

AD5 if the system is to busy out door phone C. 
Leave blank if it is not to show busy. from Hold feature. (Used only if AD3, AD1 and 
AD2 LEDs are OFF in 
Program 5#XX.) 
5) Door Phone B Busy-mark an X next to 
AD4 if the system is to busy out door phone B. 
Leave blank if it is not to show busy. 
6) Station 14 Door Phone/EKT-mark an X 
next to AD3 if station 14 is to be a door phone 
output. Leave blank if an EKT is to be used at 
+ 
this station. 1) If recall is desired, select a time period of 
16 -...

PROGRAMMINGPROCEOURES 
SECTION 300-006-300 
MAY1986 
Selection (OPX, Trunk Queuing) 
informs the system of the CO lines that 
should be considered for selection when a sta- 
tion dials 1, Each CO key represents itself. 
(Used only if the AD6 LED in 
Program 01 is 
OFF.) 
l Mark an X next to each CO key that is to be 
included in the “Dial 9” group. 
09X 
Program-Four CO Line (Dial 91, 92, 
93, 94) Groups Selection (OPX, Trunk Queu- 
ing) 
Informs the svstem of the CO lines that I 
should be considered...

in the OCC Authorization Code. These digits 
will also be ignored for Toll Restriction pur- 
poses when an OCC entry is made according 
to the above instructions. Enter the number of 
digits in the authorization code. 
105 
Program-Equal Access (10XxX) or 
Other Common Carrier (OCC) #2 
Informs the system of the second 5-digit 
code (Equal Access or OCC) that is ignored for 
Toll Restriction purposes. Enter the actual 
Equal Access or OCC digits to be recognized 
and ignored. 
106 
Program-OCC...

PROGRAMMING PROCEOURES 
SECTION 300-006-300 
MAY 1986 
allow (Program 1 X2) or deny (Program 1 X3) 
area code table for each toll restriction class. 
See the detailed programming chart for area 
code and off ice code entry procedures. 
The examples below are provided for addi- 
tional information. 
1) Normal restriction (allow all office codes 
within an area code) for stations in class 1. 
l Program 1XY is programmed to allow 
(112) area code 213. Class 1 stations are 
allowed to dial all office codes...

PROGRAMMING PROCEDURES 
SECTION 300-006-300 
MAY 1986 
FIGURE 2-FEATURE KEY ASSIGNMENTS 
status of their respective LEDs. The selections 
listed below must be repeated for each station. 
In all cases, mark an X where required. 
1) Privacy Override- mark an X next to PAU if 
the station is 
allowed the Privacy Override 
feature. 
NOTE: 
A maximum of two stations are permitted 
to use the Privacy Override feature. lf 
more than two are programmed, only the 
two lowest numbere.d stations will be 
allowed to...

PROGRAMMINGPROCEDURES 
SECTION 300-006-300 
MAY1986 
8) Group Page 3-mark an X next to DND if 
the station is 
included in Group Page 3. 
9) Group Page 2-mark an X next to ACB if 
the station is 
included in Group Page 2. 
10) Group Page l-mark an X next to CO6 if 
the station 
is included in Group Page 1. 
11) All Call Page Allowed-mark an X next to 
CO5 if the station 
is included in an All Call 
Page. 
12) Room Monitor/Warning Tone-mark an X 
next to CO4 if no warning tone will be heard 
when dialing...

X next to CO4 if Toll Restriction Class 2 is in 
effect 
at this station. 
4) Mark an X next to CO3 if Toll Restriction 
Class 1 
is in effect at this station. 
5) Mark an X next to CO2 if this station 
will be 
restricted 
from dialing 1 or 1 as the first or 
second digit. A toll restriction class cannot be 
used with this entry. 
6) Mark an X next to CO1 if the station 
will be 
allowed 
to dial p + 7-digit number. A toll re- 
striction class cannot be used with this entry. 
7) Mark an X next to INT if...

PROGRAMMINGPROCEDURES 
SECTION 300-006-300 
MAY  1986 
powered  up initially.  Therefore,  it is necessary 
to  clear  the memory  to prevent  meaningless 
numbers  from being  dialed. 
02.74  The Automatic  Dialing-System  mem- 
ory  is cleared  as follows: 
a)  Depress  the 
SET switch and allow  it to  lock. 
l The  SET  LED  lights. 
l The REP  LED on station  17 goes  on. 
b)  Depress  the m  key on station  17. 
l SPKR LED lights  steadily. 
c)  Dial  fl [J p  on  the  dial  pad. 
l The  SPKR  LED...