Toshiba Satellite 5000ser Maintenance Manual

							FIELD REPLACEABLE UNIT DOCUMENTATION5000 Series
TOSHIBA
Tough Enough for Today’s World 3. Remove two M2x4 brass screws securing the CD control/
     touchpad button assembly. 4. Lift out the CD control/touchpad button assembly.
 5. Lift out the sub LCD assembly.CD CONTROL/SUB LCD REMOVALSENSOR SWITCH REMOVAL1. Remove four M2x4 brass screws securing the 
    sensor switch assembly.2. Lift out the sensor switch assembly.M2x4 brass screwsSensor
switchassySPEAKERS REMOVAL1. Peel off the glass tapes and mylar tapes securing the 
    left and right speaker cables. 2. Remove two M2x6 brass screws securing the left and 
    right speakers.3. Remove the left and right speaker covers and lift
    out the speakers.Mylar
tapesGlass
tapes  SatelliteTMM2x4 brass
screwsCD control/touchpad button assySub LCD assyLeft and Right speaker coversLeft and Right speakersM2x6 brass screws 
						

							FL INVERTER AND 15” LCD REMOVALFIELD REPLACEABLE UNIT DOCUMENTATION  SatelliteTM5000 Series
TOSHIBA
Tough Enough for Today’s World15” DISPLAY MASK REMOVAL1. Remove two mask seals at the bottom corners of the
    display assembly using a pair of fine-tipped tweezers.2. Remove two M2.5x6 flat head brass screws securing
    the display mask.
3. There are 22 latches securing the display mask.
    Carefully insert your fingers between the mask and the    LCD panel and pry open the latches starting from the    bottom six latches, to the five latches on the right  
    and left sides, ending with the six toplatches.LatchMask sealsDisplay
maskLCDLCD moduleM2x5 silver screwFL inverter boardM2x5
brassscrewsM2x5 
brassscrewsMask
sealsMask
sealsLCD/FL cableFL cable1. Remove one M2x5 silver screw securing the 
    FL inverter board.2. Carefully lift up the FL inverter board and 
    disconnect the LCD/FL cable from CN1 and the
    FL cable from CN2.
3. Remove four mask seals to expose four screws 
    securing the LCD module assembly.4. Remove four M2X5 silver screws securing the 
    LCD module.5. Carefully rotate out the top of the LCD module
    enough to access the display cable6. Peel off the tape securing the LCD/FL cable and    disconnect the cable.