IBM Thinkpad A30 A30p A31 A31p Dock Manual

							2030 LCD panel
For access, remove these FRUs, in order:
v“1010 Battery pack”on page 62
v“1020 Mini PCI adapter”on page 63
v“1030 Communication daughter card (CDC)”on page 66
v“1040 Backup battery”on page 73
v“1060 Hard-disk drive”on page 75
v“1070 Ultrabay Plus device”on page 77
v“1080 Ultrabay 2000 device”on page 78
v“1100 Keyboard”on page 80
v“1110 Keyboard CRU insulator”on page 85
v“1120 Keyboard bezel”on page 87
v“1130 Hinge cover”on page 91
v“1160 Ultrabay Plus slot”on page 96
v“1200 LCD assembly”on page 108
v“2010 Front bezel”on page 123
v“2020 Inverter card”on page 125
Remove the UltraPort adapter if it has been screwed onto
the LCD. To do this, remove the screws from the ends of
the screw from both side of the adapter as shown in figure

1a. Remove the connector cover for the others as shown
in figure
1b.
1a1b
(continued)
Removing and replacing a FRU
ThinkPad A30, A30p, A31, A31p127 
						

							2
2
Step Screw (quantity) Torque

2M2×5.7 mm, nylon-coated (4) 0.245 Nm
(2.5 kgfcm)
4
3
(continued)
Removing and replacing a FRU
128MT 2652/2653/2654 
						

							For 14.1-in. LCD panel
6
8
8
5
7
Step Screw (quantity) Torque

8M2×3.6 mm, nylon-coated (4) 0.245 Nm
(2.5 kgfcm) Removing and replacing a FRU
ThinkPad A30, A30p, A31, A31p129 
						

							For 15.0-in. LCD panel
6
5
7
Cable routing:When installing the LCD, route the
connector cable as in the following figure:
Removing and replacing a FRU
130MT 2652/2653/2654 
						

							2040 Antenna assembly
NoteThis FRU is not available for all models. Some
ThinkPad computers may not have this FRU.
For access, remove these FRUs, in order:
v“1010 Battery pack”on page 62
v“1020 Mini PCI adapter”on page 63
v“1030 Communication daughter card (CDC)”on page 66
v“1040 Backup battery”on page 73
v“1060 Hard-disk drive”on page 75
v“1070 Ultrabay Plus device”on page 77
v“1080 Ultrabay 2000 device”on page 78
v“1100 Keyboard”on page 80
v“1110 Keyboard CRU insulator”on page 85
v“1120 Keyboard bezel”on page 87
v“1130 Hinge cover”on page 91
v“1160 Ultrabay Plus slot”on page 96
v“1200 LCD assembly”on page 108
v“2010 Front bezel”on page 123
v“2020 Inverter card”on page 125
v“2030 LCD panel”on page 127
Strip off the insulation tapes
1securing the cables.
1
(continued)
Removing and replacing a FRU
ThinkPad A30, A30p, A31, A31p131 
						

							4
3
4
2
Step Screw (quantity) Torque

2M2.5×4.8 mm, nylon-coated (1) 0.392 Nm
(4 kgfcm)
5
5
Removing and replacing a FRU
132MT 2652/2653/2654 
						

							When installing the antenna assembly, do as follows:
1. Attach the antenna and route the cable.
Note:Attach the gray cable(MAIN)to the left side and
the black cable(AUX)to the right side of the
LCD cover.
2. Secure the cables with insulation tape in the order
shown
1and
2.
12
(continued)
Removing and replacing a FRU
ThinkPad A30, A30p, A31, A31p133 
						

							3. Attach the hinges
4. Then attach the bracket
5and
tighten the screw
6.
3
3
4
5
Removing and replacing a FRU
134MT 2652/2653/2654 
						

							3010 ThinkPad Dock PCI cover
Before replacing the PCI cover:
There are two types of ThinkPad Dock, as follows:
vThinkPad Dock: FRU no. 08N1546 (PCI cover: FRU no.
05K6246)
vThinkPad Dock with extension plate: FRU no. 08N1537
(PCI cover: FRU no. 08N7317)
Confirm the FRU no. of the ThinkPad Dock first and
choose the proper PCI cover FRU for the ThinkPad Dock
you are servicing.
Removing and replacing a FRU
ThinkPad A30, A30p, A31, A31p135 
						

							Note:The following illustration shows how to remove the
PCI cover of ThinkPad Dock (FRU no. 08N1546).
Do the same to remove the PCI cover of ThinkPad
Dock with extension plate (FRU no. 08N1537).
1
2
1
(Bottom view)
Removing and replacing a FRU
136MT 2652/2653/2654