Steinberg Cubase SX/SL 3 Remote Control Devices Manual
Here you can view all the pages of manual Steinberg Cubase SX/SL 3 Remote Control Devices Manual. The Steinberg manuals for Music Production System are available online for free. You can easily download all the documents as PDF.
Page 1
Remote Control Devices
Page 2
Manual by Anders Nordmark Quality Control: C. Bachmann, H. Bischoff, S. Pfeifer, C. Schomburg The information in this document is subject to change without notice and does not rep- resent a commitment on the part of Steinberg Media Technologies GmbH. The software described by this document is subject to a License Agreement and may not be copied to other media except as specifically allowed in the License Agreement. No part of this publication may be copied, reproduced or otherwise transmitted or...
Page 3
1 Introduction
Page 4
CUBASE SX/SL 1 – 4 Introduction About this document As described in the Operation Manual, the mixing functions in Cubase SX/SL can be remote controlled via MIDI. This document lists and de- scribes all currently supported MIDI remote devices. For details on how to select and set up a remote device, please refer to the chapter “Remote controlling the mixer” in the Operation Manual. There you will also find a description of the Generic Remote Device, which allows you to use any MIDI device as a...
Page 5
2 CM Automation Motor Mix
Page 6
CUBASE SX/SL 2 – 6 CM Automation Motor Mix Specifications The CM Motor Mix can control any number of channels in groups of 8. • Press the “” buttons (at the top of the View section) to se- lect channels 1-8, 9-16 etc. Hold down Shift and press “” to shift the fader assignment in steps of one channel. • Press F1 to disable/enable the fader motors. • Use the Select buttons (the row of buttons below the display) to se- lect a single track for detailed settings. • The Mute and Solo...
Page 7
CUBASE SX/SL CM Automation Motor Mix 2 – 7 • Press the Undo button to undo the last action in Cubase SX/SL. Hold down Shift and press the Undo button to “undo the undo”. In the Rotary section, use the Rotary dial to change the assignment of the four buttons below the dial (indicated in the ROTARY display): ROTARY: PA • equaliz button: Fader Set mode Panning • dynmics button: Fader Set mode Routing • delay button: Selected Channel mode Panning • special button: Selected Channel mode Routing...
Page 8
CUBASE SX/SL 2 – 8 CM Automation Motor Mix Fader Set mode Panning: • Page 1 - panning left/right • Page 2 - panning front/rear • Buttons below dials: monitor Fader Set mode Routing: • Page 1 - Output Bus • Page 2 - Monitor • Page 3 - Input Bus • Page 4 - Input Gain • Page 5 - Input Phase • Buttons below dials: monitor Selected Channel mode Panning: • Page 1 - panning left/right, panning front/rear • Buttons below dials: monitor Selected Channel mode Routing: • Page 1 - Output Bus, Monitor,...
Page 9
CUBASE SX/SL CM Automation Motor Mix 2 – 9 F2 button: Selected Channel mode EQ: • Page 1 - Gain, Frequency, Q and Enable for the lo band, Gain, Frequency, Q and Enable for the lo mid band • Page 2 - Gain, Frequency, Q and Enable for the hi mid band, Gain, Fre- quency, Q and Enable for the hi band • Buttons below dials: bypass EQs Holding down Shift and pressing the F2 button gives you a variation of Selected Channel mode EQ: • Page 1 - Gain and Frequency for all bands • Page 2 - Q and Enable...
Page 10
CUBASE SX/SL 2 – 10 CM Automation Motor Mix