Home > Steinberg > Music Production System > Steinberg Cubase SX/SL 3 Audio Effects And VSTi Manual

Steinberg Cubase SX/SL 3 Audio Effects And VSTi Manual

Here you can view all the pages of manual Steinberg Cubase SX/SL 3 Audio Effects And VSTi Manual. The Steinberg manuals for Music Production System are available online for free. You can easily download all the documents as PDF.

Page 101

CUBASE SX/SL
The included VST Instruments 2 – 101
•Monologue has an effects section with chorus, phaser, and flanger 
effects, plus separate delay and overdrive units.
•Monologue has a X/Y matrix pad for additional realtime modulation 
with access to all Monologue parameters.
Osc 1 and 2
Parameter Description
Waveform
(pop-up menu)This is where you select the waveform: Saw, Square and Sub for 
oscillator 1 and Saw, Square and Triangle for Oscillator 2.
Coarse Sets the coarse pitch in semitones. The...

Page 102

CUBASE SX/SL
2 – 102 The included VST Instruments
Mix
Filter
Envelope
Parameter Description
Osc 1 Sets the pre-filter level for oscillator 1.
Noise Sets the pre-filter noise level.
Osc 2 Sets the pre-filter level for oscillator 2.
Parameter Description
Mode Sets the filter type. Available filter types are 24 dB Low pass, 18 dB 
Low pass, 12 dB Low pass, 6 dB Low pass, 12 dB Band pass and 
12 dB High pass.
Cutoff Sets the filter cutoff frequency. How this parameter operates is 
governed by the filter...

Page 103

CUBASE SX/SL
The included VST Instruments 2 – 103
LFO
X/Y Pad
Effects
Parameter Description
Waveform
(pop-up menu)Here, you can select the waveform for the low frequency oscillator. 
Available waveforms are: Triangle, Square, Sawtooth, Sample & 
Hold and Random.
Rate Adjusts the frequency of the LFO, thus changing the rate of the 
modulation. Depending on the LFO sync parameter, you can edit 
the rate in Hertz or in note values. 
Sync When “Sync” is “on” the LFO speed will be synchronized to the...

Page 104

CUBASE SX/SL
2 – 104 The included VST Instruments
Mix Controls the balance between dry and wet (effect) signal. Set to 0, 
the effect will be off. Set to 50, the balance between dry and wet 
signal is 50/50.
Overdrive Controls the amount of overdrive (distortion) added to the signal. 
A slight amount of overdrive will create punch and bottom. Higher 
amounts will add distortion.
Delay Sets the delay time in musical values. The delay effect is always in 
sync with the song tempo.
Spread Controls the...

Page 105

CUBASE SX/SL
The included VST Instruments 2 – 105
Master
Parameter Description
Glide Mode The available modes are: “held”, “on” and “off”. With “held” se-
lected, a glide effect only occurs for notes played legato.
Rate Controls the glide rate – the time it takes for a note to reach its 
destination pitch.
PB Range Controls the range of a pitch bend midi controller. Range can be 
set between 1 and 24 semitones for a total of two octaves.
Env Trigger When set to “Multi”, each keystroke will re-trigger the...

Page 106

CUBASE SX/SL
2 – 106 The included VST Instruments 

Page 107

Index 

Page 108

CUBASE SX/SL
108 Index
A
A1 Synthesizer 80
Apogee UV22 HR
 60
B
Bitcrusher 58
C
Chopper 59
Chorus
 45
D
DaTube 10
Dither
 60
DoubleDelay
 7
Dynamics
 18
E
Embracer Synthesizer 95
F
Flanger 46
L
LM-7 92
M
Magneto 24
Metalizer
 48
MIDI Gate
 29
Mix6To2
 72
ModDelay
 9
Monologue Synthesizer
 100
MultibandCompressor
 31
O
Overdrive 11
P
Phaser 49
Q
Q 37
QuadraFuzz
 12
R
Reverb A 67
Reverb B
 68
Ringmodulator
 51
RoomWorks
 69
Rotary
 53
S
SMPTE Generator 67
SPL DeEsser
 16
StepFilter
 39
SurroundDither
 73...
Start reading Steinberg Cubase SX/SL 3 Audio Effects And VSTi Manual

Related Manuals for Steinberg Cubase SX/SL 3 Audio Effects And VSTi Manual

All Steinberg manuals