Steinberg Cubase SX/SL 3 Audio Effects And VSTi Manual
Here you can view all the pages of manual Steinberg Cubase SX/SL 3 Audio Effects And VSTi Manual. The Steinberg manuals for Music Production System are available online for free. You can easily download all the documents as PDF.
Page 101
CUBASE SX/SL The included VST Instruments 2 – 101 •Monologue has an effects section with chorus, phaser, and flanger effects, plus separate delay and overdrive units. •Monologue has a X/Y matrix pad for additional realtime modulation with access to all Monologue parameters. Osc 1 and 2 Parameter Description Waveform (pop-up menu)This is where you select the waveform: Saw, Square and Sub for oscillator 1 and Saw, Square and Triangle for Oscillator 2. Coarse Sets the coarse pitch in semitones. The...
Page 102
CUBASE SX/SL 2 – 102 The included VST Instruments Mix Filter Envelope Parameter Description Osc 1 Sets the pre-filter level for oscillator 1. Noise Sets the pre-filter noise level. Osc 2 Sets the pre-filter level for oscillator 2. Parameter Description Mode Sets the filter type. Available filter types are 24 dB Low pass, 18 dB Low pass, 12 dB Low pass, 6 dB Low pass, 12 dB Band pass and 12 dB High pass. Cutoff Sets the filter cutoff frequency. How this parameter operates is governed by the filter...
Page 103
CUBASE SX/SL The included VST Instruments 2 – 103 LFO X/Y Pad Effects Parameter Description Waveform (pop-up menu)Here, you can select the waveform for the low frequency oscillator. Available waveforms are: Triangle, Square, Sawtooth, Sample & Hold and Random. Rate Adjusts the frequency of the LFO, thus changing the rate of the modulation. Depending on the LFO sync parameter, you can edit the rate in Hertz or in note values. Sync When “Sync” is “on” the LFO speed will be synchronized to the...
Page 104
CUBASE SX/SL 2 – 104 The included VST Instruments Mix Controls the balance between dry and wet (effect) signal. Set to 0, the effect will be off. Set to 50, the balance between dry and wet signal is 50/50. Overdrive Controls the amount of overdrive (distortion) added to the signal. A slight amount of overdrive will create punch and bottom. Higher amounts will add distortion. Delay Sets the delay time in musical values. The delay effect is always in sync with the song tempo. Spread Controls the...
Page 105
CUBASE SX/SL The included VST Instruments 2 – 105 Master Parameter Description Glide Mode The available modes are: “held”, “on” and “off”. With “held” se- lected, a glide effect only occurs for notes played legato. Rate Controls the glide rate – the time it takes for a note to reach its destination pitch. PB Range Controls the range of a pitch bend midi controller. Range can be set between 1 and 24 semitones for a total of two octaves. Env Trigger When set to “Multi”, each keystroke will re-trigger the...
Page 108
CUBASE SX/SL 108 Index A A1 Synthesizer 80 Apogee UV22 HR 60 B Bitcrusher 58 C Chopper 59 Chorus 45 D DaTube 10 Dither 60 DoubleDelay 7 Dynamics 18 E Embracer Synthesizer 95 F Flanger 46 L LM-7 92 M Magneto 24 Metalizer 48 MIDI Gate 29 Mix6To2 72 ModDelay 9 Monologue Synthesizer 100 MultibandCompressor 31 O Overdrive 11 P Phaser 49 Q Q 37 QuadraFuzz 12 R Reverb A 67 Reverb B 68 Ringmodulator 51 RoomWorks 69 Rotary 53 S SMPTE Generator 67 SPL DeEsser 16 StepFilter 39 SurroundDither 73...