Sony Camera Cyber Shot Dsc Tx200v Instruction Manual

							GB
11
GB
Charging the battery pack
1Connect the camera to the AC Adaptor (supplied), 
using the micro USB cable (supplied).
2Connect the AC Adaptor to the wall outlet (wall socket).The Power/Charge lamp lights orange, and charging starts.
 Turn off the camera while charging the battery.
 You can charge the battery pack even when it is partially charged.
 When the Power/Charge lamp flashes and charging is not finished, 
remove and re-insert the battery pack.
Power cord 
(Mains lead) For customers in the USA, Canada
For customers in countries/regions 
other than the USA and CanadaPower/Charge lamp
Lit: Charging
Off: Charging finished
Flashing:
Charging error
Charging paused due to 
overheating 
						

							GB
12
 If the Power/Charge lamp on the camera flashes when the AC Adaptor is 
connected to the wall outlet (wall socket), this indicates that charging is 
temporarily stopped because the temperature is outside the recommended range. 
When the temperature gets back within the appropriate range, the charging 
resumes. We recommend charging the battery pack in an ambient temperature of 
between 10°C to 30°C (50ºF to 86ºF).
 The battery pack may not be effectively charged if the terminal section of the 
battery is dirty. In this case, wipe any dust off lightly using a soft cloth or a cotton 
swab to clean the terminal section of the battery.
 Connect the AC Adaptor (supplied) to the nearest wall outlet (wall socket). If 
malfunctions occur while using the AC Adaptor, disconnect the plug from the wall 
outlet (wall socket) immediately to disconnect from the power source.
 When charging is finished, disconnect the AC Adaptor from the wall outlet (wall 
socket).
 Be sure to use only genuine Sony brand battery packs, micro USB cable (supplied) 
and AC Adaptor (supplied).
 BC-TRN2 battery charger (sold separately) is able to quick-charge the NP-BN 
rechargeable battery pack supplied with this model. BC-TRN battery charger (sold 
separately) is not able to quick-charge the NP-BN rechargeable battery pack 
supplied with this model.
xCharging time (Full charge)
The charging time is approximately 115 min. using the AC Adaptor 
(supplied).
 The above charging time applies when charging a fully depleted battery pack at a 
temperature of 25°C (77°F). Charging may take longer depending on conditions of 
use and circumstances.
Notes
Note 
						

							GB
13
GB
xCharging by connecting to a computer
The battery pack can be charged by connecting the camera to a computer using 
a micro USB cable.
 Note the following points when charging via a computer:
– If the camera is connected to a laptop computer that is not connected to a power 
source, the laptop battery level decreases. Do not charge for an extended period 
of time.
– Do not turn on/off or restart the computer, or wake the computer to resume from 
sleep mode when a USB connection has been established between the computer 
and the camera. The camera may cause a malfunction. Before turning on/off, or 
restarting the computer or waking the computer from sleep mode, disconnect the 
camera and the computer.
– No guarantees are made for charging using a custom-built computer or a 
modified computer.
Note 
						

							GB
14
xBattery life and number of images that can be 
recorded and played back
 The above number of images applies when the battery pack is fully charged. The 
number of images may decrease depending on the conditions of use.
 The number of images that can be recorded is for shooting under the following 
conditions:
– Using Sony microSD memory card (Class 4 or faster) (sold separately)
– The battery pack is used at an ambient temperature of 25°C (77°F).
– [GPS setting] is set to [Off] (DSC-TX200V only).
– [Disp. Resolution] is set to [Standard].
 The number for “Shooting (still images)” is based on the CIPA standard, and is for 
shooting under the following conditions:
(CIPA: Camera & Imaging Products Association)
– [Panel Brightness] is set to [3(Normal)].
– Shooting once every 30 seconds.
– The zoom is switched alternately between the W and T ends.
– The flash strobes once every two times.
– The power turns on and off once every ten times.
 The battery life for movies applies shooting under the following conditions:
– Movie quality: AVC HD HQ
– When continuous shooting ends because of set limits (page 27), press the shutter 
button down again and continue shooting. Shooting functions such as the zoom 
do not operate.
Battery lifeNumber of images
Shooting (still images) Approx. 110 min. Approx. 220 images
Viewing (still images) Approx. 160 min. Approx. 3200 images
Shooting (movies) Approx. 55 min. —
Notes 
						

							GB
15
GB
xSupplying power
The camera can be supplied with power from the wall outlet (wall socket) by 
connecting to the AC Adaptor, using the micro USB cable (supplied).
You can import images to a computer without worrying about draining the 
battery pack by connecting the camera to a computer using the micro USB 
cable.
In addition, you can use the AC Adaptor AC-UD10 (sold separately) for 
shooting to supply power when shooting.
 Power cannot be supplied when the battery pack is not inserted in the camera.
 When the camera is connected directly to a computer or to a power outlet using the 
supplied AC Adaptor AC-UB10/UB10B, power supply is available only in 
playback mode. If the camera is in shooting mode or while you are changing the 
settings of the camera, power is not supplied even if you make a USB connection 
using the micro USB cable.
 If you connect the camera and a computer using the micro USB cable while the 
camera is in playback mode, the display on the camera will change from the 
playback screen to the USB connection screen. Touch   (Playback) button to 
switch to the playback screen.
Notes 
						

							GB
16
Inserting a memory card (sold separately)
1Open the cover.
2Insert the memory card (sold separately). With the camera lens facing upward, as illustrated, insert the memory 
card straight in until it clicks into place.
 Pushing down on the microSD memory card (in the direction of the 
battery insertion slot) while inserting it may damage the camera.
 Be careful when removing the microSD memory card, as it may pop out 
quickly.
3Close the cover.
4Check the icon displayed on the upper right screen and 
make sure the memory card is inserted correctly.
A: The memory card is inserted 
correctly.
B: The memory card is not inserted 
correctly. Confirm the direction of the 
memory card and reinsert it straight into 
the camera.
 Only one memory card can be inserted.
“Memory Stick 
Micro” media (M2)microSD memory 
card
Make sure that the correct 
side is facing up.
TerminalPrinting 
surface 
						

							GB
17
GB
xMemory cards that can be used
 In this manual, products in A are collectively referred to as “Memory Stick Micro” 
media, and products in B are collectively referred to as microSD memory card.
xTo remove the memory card/battery pack
Memory card: Push the memory card in once to eject the memory card.
Battery pack: Slide the battery eject lever. Be sure not to drop the battery pack.
 Never remove the memory card/battery pack when the access lamp (page 9) is lit. 
This may cause damage to data in the memory card/internal memory.
Memory cardFor still imagesFor movies
AMemory Stick Microa—
Memory Stick Micro (Mark2)aa
BmicroSD memory cardaa (Class 4 or faster)
microSDHC memory cardaa (Class 4 or faster)
Note 
						

							GB
18
Setting the clock
1Press the ON/OFF (Power) button.The camera is turned on. The power lamp lights up green only when the 
camera starts up.
Date & Time setting is displayed when you turn on the camera for the first 
time.
 It may take time for the power to turn on and allow operation.
2Select a desired language.
3Select a desired geographic location by following the 
on-screen instructions, then touch [Next].
4Set [Daylight Savings] or [Summer Time], [Date & Time 
Format] and [Date & Time], then touch [Next].
 Midnight is indicated as 12:00 AM, and noon as 12:00 PM.
5Touch [OK].
6Follow the instructions on the screen. If you set [GPS setting] to [On], the battery charge may be depleted 
faster.
 If you set [Disp. Resolution] to [High], the battery charge may be 
depleted faster.
ON/OFF (Power) button 
						

							GB
19
GB
Shooting still images
Shooting movies
 The sound of the lever operating will be recorded when the zoom function 
operates while shooting a movie.
 Continuous shooting is possible for approximately 29 minutes at one time at the 
camera’s default settings and when the temperature is approximately 25°C (77°F). 
When movie recording is finished, you can restart recording by performing the 
steps above from the beginning. Recording may stop to protect the camera 
depending on the ambient temperature.
Shooting still images/movies
1Press the shutter button halfway down to focus. When the image is in focus, a beep sounds and the z indicator lights.
2Press the shutter button fully down to shoot an image.
1Touch  (REC Mode) t  (Movie Mode).
2Press the shutter button to start recording. Do not cover the microphone with your fingers.
 Use the W/T (zoom) lever to change the zoom scale.
 When   (REC Mode) is not set to   (Movie Mode), you can start 
or stop recording by touching   (Movie button) on the screen.
3Press the shutter button again to stop recording.
Notes
Shutter button 
						

							GB
20
xSelecting next/previous image
Touch   (Next)/  (Previous) on the screen.
 To play back movies, touch   (Playback) in the center of the screen.
 To zoom in, slide the W/T (Zoom) lever to T side.
xDeleting an image
Touch  (Delete) t [This Image].
xReturning to shooting images
Touch   on the screen.
 You can also return to shooting mode by pressing the shutter button halfway 
down.
Viewing images
1Touch  (Playback). When images on a memory card recorded with other cameras are played 
back on this camera, the registration screen for the data file appears.