Smeg Sap112-8 Manual
Here you can view all the pages of manual Smeg Sap112-8 Manual. The Smeg manuals for Oven are available online for free. You can easily download all the documents as PDF.
Page 61
Instructions for the installer 62 10.INSTALLING THE APPLIANCE 10.1 Electrical connection The identification plate bearing the technical data, serial number and brand name is visibly positioned on the appliance. Do not remove this plate for any reason. The appliance must be connected to earth in compliance with electrical system safety regulations. If a fixed connection is being used, fit the power line with an omnipolar circuit- breaker in accordance with the installation rules, located in a position...
Page 62
Instructions for the installer 63 10.2 Cable replacement Should the supply cable need replacing, remove the back guard by unscrewing the screws to gain access to the terminal. Replace the cable. The cable cross- section must be no less than 1.5 mm² (3 x 1.5) (see 10.1 Electrical connection). Make sure that the cables (for the oven or any hob) follow the best route in order to avoid any contact with the oven. WARNING:The tightening torque of the screws of the terminal supply wires must be 1.5 - 2 Nm. 10.3...
Page 63
Instructions for the installer 64 When installing in tall units, comply with the dimensions shown in figures 1 and 2, bearing in mind that the top/rear of the unit must have an opening 35-40 mm deep. Remove the screw covers on the frame and screw in the 2 screws A (fig. 5) to fix the appliance to the unit. Replace the screw covers. For installing beneath a countertop hob, allow for a rear and bottom clearance as shown in Figure 1 (ref. F). See the relevant instructions for fitting and securing the...
Page 64
Instructions for the installer 65 FIG. 2 FIG. 3 FIG. 4 FIG. 5
Page 65
914773863/ A