Smeg Sap112-8 Manual

Instructions for the User
52
To select a cleaning cycle with delayed start, after
setting the duration press the temperature selection
knob once.   and the current time will appear on
the display.
(Temperature knob)
Turn the knob right or left to increase or decrease the
time when you want to start the cleaning cycle.
(Temperature knob)
A few seconds after the required duration is set, 
and   will stay lit, and the oven will wait for the
starting time set for the cleaning cycle.
It is not possible to...

Instructions for the User
53
8.8 VAPOR CLEAN: assisted oven cleaning (on some models only)
VAPOR CLEAN is an assisted cleaning procedure which facilitates the removal
of dirt. Thanks to this process, it is possible to clean the inside of the oven very
easily. The dirt residues are softened by the heat and water vapour to make it
easier to remove them afterwards.
Before starting the assisted cleaning cycle, make sure that the oven does not
contain any foods or large spills from previous cooking...

Instructions for the User
54 Spray a water and washing up liquid
solution inside the oven using a spray
nozzle. Aim the spray towards the side
walls, roof, floor and deflector (the
coloured zone on the illustration to the
side shows where the solution can be
sprayed).
Do not spray excessive amounts of the water and washing up liquid solution. We
recommend spraying approx. 20 times at the most.
 Close the door and set the assisted
cleaning cycle.
8.8.2 Setting the assisted cleaning cycle
The assisted...

Instructions for the User
55
Parameters such as the duration and temperature of the cleaning cycle
cannot be modified.
8.8.3 End of the assisted cleaning cycle
The water remaining at the end of the assisted cleaning cycle cannot be left
inside the oven for long (for example overnight).
You are advised to wear a pair of gloves during these processes.
At the end of the cleaning cycle, open the door and wipe away the less stubborn
dirt with a microfibre cloth. Use an anti-scratch sponge with brass filaments...

Instructions for the User
56
9. EXTRAORDINARY MAINTENANCE
The oven may require extraordinary maintenance or replacement of parts
subject to wear such as gaskets, bulbs, etc. The following instructions describe
how to carry out these minor maintenance operations.
Before any intervention that requires access to live parts, disconnect the
power supply of the appliance.
9.1 Replacing the light bulb
If a light bulb needs to be replaced
because it is worn or burnt out, remove
the guide frames; see “8.5.1...

Instructions for the User
57
9.2 Removing the door
9.2.1 With moveable levers
Open the door completely.
Lift the levers A of the two hinges away
from them until they engage.
Grasp the door on both sides with both
hands, lift it forming an angle of around
30° and remove it.
If the hinges have not unlocked, repeat
the operation, raising the levers A and
keeping the door slightly raised.
To reassemble the door, put the hinges in
the relevant slots in the oven, making sure
that the grooved sections C are...

Instructions for the User
58
9.2.2 With pins
Open the door completely.
Insert two pins into the holes indicated A
in the two hinges towards the back of
them until they engage.
Grasp the door on both sides with both
hands, lift it forming an angle of around
30° and remove it.
To reassemble the door, put the hinges in
the relevant slots in the oven, making sure
that the grooved sections C are resting
completely in the slots.  Lower the door
and once it is in place remove the pins
from the holes in the...

Instructions for the User
59
9.3 Removing the door seal
For multifunction models only:
To permit thorough cleaning of the oven,
the door seal may be removed.
There are fasteners on all four sides to
attach it to the edge of the oven. Pull the
edges of the seal outwards to detach the
fasteners.
9.4 Removing the internal glass panels
The glass in the door should always be kept thoroughly clean. To facilitate
cleaning, it is possible to remove the door (see 9.2 Removing the door) and
place it on a canvas,...

Instructions for the User
60
Removing the internal glass panel:
 Remove the internal glass panel by
pulling it upwards, following the
movement indicated by the arrows. Doing
this detaches the 4 pins attached to the
glass from their slots in the oven door.
Removing the middle glass panels:
(pyrolytic models)
 There are two middle glass panels in
pyrolytic models, attached using 4 small
locks. Remove the middle panels by lifting
them upwards.
(Multifunction models)
 Multifunction models have a single...

Instructions for the User
61
9.5 What to do if...
The oven display is
completely off  Check the mains power supply.
 Check whether an omnipolar switch upstream
of the oven supply line is in the “ON” position.
The oven does not heat up Check whether it has been set in “showroom”
mode, for further details see “6.14 Secondary
menu”.
The controls do not
respond. Check whether it has been set in “child lock”
mode, for further details see “6.14 Secondary
menu”.
The cooking times are
longer than those...