Smeg A1pyid7 Manual

Instructions for the user
89
10.2 Removing the door
Open the door completely.
Insert two pins into the holes on the hinges
towards the back of them until they engage.
Grasp the door on both sides with both hands,
lift it forming an angle of around 30° and
remove it.
To reassemble the door, put the hinges in the
relevant slots in the oven, making sure that
grooved sections C are resting completely in
the slots.  Lower the door and once it is in place
remove the pins from the holes in the hinges. 

Instructions for the installer
90
11.INSTALLING THE APPLIANCE
11.1 Installing in kitchen units
Veneers, adhesives or plastic coatings on adjacent furniture should be
temperature-resistant (no less than 90°C). If they are not sufficiently
temperature-resistant, they may warp over time. 
The appliance must be installed by a qualified technician and according to the
regulations in force.
Depending on the type of installation, this appliance belongs to class 2,
subclass 1 (Fig. A - Fig. B) or to class 1...

Instructions for the installer
91
11.2 Electrical connection
Make sure the voltage and the cross-section of the power supply line match the
specifications indicated on the identification plate positioned on the appliance.
Do not remove this plate for any reason. A copy of the plate is attached to the
instructions.
The appliance must be connected to the power supply by a qualified technician.
Before performing any operations, switch off the power supply to the appliance.
The appliance must be connected to...

Instructions for the installer
92
POSSIBLE 
CONNECTION TYPESCABLE TYPE
(if not present)
380 - 415 V 3N~5-pole5 x 2.5 mm² H05V2V2-F
380 - 415 V 2N~4-pole4 x 4 mm² H05V2V2-F
220 - 240 V 1N~3-pole3 x 6 mm² H05V2V2-F
•  Use H05V2V2-F cables withstanding temperatures of 90°C or higher.
•  The values indicated above refer to the cross-section of the internal
conductor.
•  The tightening torque of the screws of the terminal supply wires must be 1.5
- 2 Nm.
The aforementioned power cables are sized taking into...

Instructions for the installer
93
11.3 Positioning the skirt
WARNING: The skirt provided is an integral part of the product; it must be
fastened to the appliance prior to installation.
•  Position the skirt above the top, taking care
to align holes A with holes B.
•  Secure the skirt to the top by tightening
screws C.
11.4 Positioning and levelling the appliance
After making the electrical and/or gas connections, properly level
the appliance on the floor to ensure better stability. Screw or
unscrew the...

Instructions for the installer
94
11.5 Wall mounting instructions  (some markets only)
1 Fasten a hook bolt (not supplied) into the wall at
a height (h) of 800 mm from the floor.
The installer must provide the hook bolt when installing the appliance.
2 Attach the snap hook to the chain.
3 Attach the end of the chain to the hook bolt
fastened in the wall.
4 Finally, connect the snap hook to the appropriate
hole on the back of the appliance.