Home > Siemens > Dishwasher > Siemens Sf 64t355 Operating Instructions

Siemens Sf 64t355 Operating Instructions

Here you can view all the pages of manual Siemens Sf 64t355 Operating Instructions. The Siemens manuals for Dishwasher are available online for free. You can easily download all the documents as PDF.

Page 11

en11
Adjusting  
the height of the basket * 
* depending on model 
If required, the height of the upper utensils  
basket 
1 can be adjusted to provide 
more space for tall utensils  
either in the upper or lower basket. 
Appliance height 81 cm 
Select one of the two following procedures  
according to the design of the top basket 
for your appliance model: 
Top basket with side levers 
– Pull out the top basket  1 out. 
–To  lower the basket, press in the left 
and then the right  
lever on the outside...

Page 12

en 
12
You can use tablets as well as powder  
or liquid detergents for dishwashers, but 
never use washing up liquid. The dosage  
can be individually adjusted with powder  
or a liquid detergent according 
to the degree of soiling. Tablets contain  
an adequately large amount of active  
ingredients for all cleaning tasks. Modern,  
pow erful detergents predominantly  
use a low-alkaline formulation with 
phosphate and enzymes. Phosphates  
bond the lime in the water. Enzymes break  
down starch and...

Page 13

en13
Tip 
If the utensils are only lightly soiled,  
slightly less than the indicated amount  
of detergent is usually adequate.  
Suitable detergents and care products  
can be purchased online via our website  
or via customer service (see back page). 
Combination detergent 
Apart from conventional detergents (Solo),  
a number of products are offered with  
additional functions. These products 
contain not only the detergent but also  
rinse-aid and salt replacement substances  
(3in1) and, depending...

Page 14

en 
14
The max. possible number of programmes is illustrated 
in this overview. 
The corresponding programmes and their arrangement c an be found on the fascia.
Programme selection 
You can select a suitable programme  
according to the type of utensils and  
degree of soiling. 
Information for test institutes 
Test institutes can request the conditions  
for running comparison tests by sending  
an e-mail to  
[email protected].  
Quote the appliance number (E ­Nr.) 
and the production date...

Page 15

en15
* depending on model 
Additional options can be set with the  
buttons 
H.
Ÿ  Express Wash/ Speed 
Perfect * 
The >>Express Wash/ Speed Perfect

Page 16

en 
16
Optical display while  
the programme is running * 
* depending on model 
While the programme is running, a light  
spot shines on the floor under  
the appliance door. Do not open  
the dishwasher door until the light point  
is no longer visible on the floor. 
If the appliance is installed at eye-level,  
with flush furniture front, the light point  
is not visible.  
Remaining running time display 
When the programme is selected, the  
remaining running time of the programme  
is indicated on...

Page 17

en17
ã= Warning
At the end of the programme please open  
the door fully and not partially  
when emptying the dishwasher. Any  
escaping water vapour could damage  
sensitive worktops. 
Interrupting the programme 
– Open the door. 
–Switchoffthemain switch  (.
TheLEDs go out. Theprogramme  
is saved.  
If the door was opened on an  
appliance which has a warm water  
connection or is heated, first leave 
the door ajar for several minutes  
and then close. Otherwise, expansion  
(pressure) may cause the...

Page 18

en 
18
A regular inspection and maintenance of  
your machine will help to prevent faults. 
This saves time and prevents problems. 
Overall condition of the machine 
– Check spray arm for grease and 
limescale deposits.
If you find such deposits: 
– Fill detergent dispenser with detergent.  Start the appliance without utensils in  
the programme with the highest rinsing  
temperature.
Clean the appliance with detergents/ 
appliance cleaners which are particularly  
suitable for use with dishwashers. 
–...

Page 19

en19
Spray arms 
Limescale and contaminants in the rinsing  
water may block nozzles  
and bearings on the spray arms 
12 
and 1:.
– Check outlet nozzles on the spray  arms for blockages.
– Unscrew the upper spray arm  12.
– Remove the lower spray arm  1: 
upwards.
– Clean spray arms under running water. 
– Re-engage or screw on spray arms. The majority of  faults which could occur in  
daily operation can be rectified by the  
user. This ensures that the appliance is 
quickly available for use again....

Page 20

en 
20
Waste water pump 
Large food remnants in the rinsing water  
not retained by the filters may block  
the waste water pump. The rinsing water 
is then not pumped out and covers  
the filter.  
In this case: 
– First disconnect the appliance from 
the power supply.
– Remove the filters  1J.
– Scoop out water, use a sponge if  required.
– Loosen screw on the cover (Torx T 20)  and remove the cover.
– Check inner compartment and remove  any foreign objects.
– Re-insert cover and screw tight. 
–...
Start reading Siemens Sf 64t355 Operating Instructions

Related Manuals for Siemens Sf 64t355 Operating Instructions

All Siemens manuals