Siemens Sf 64t355 Operating Instructions

en21
– Water is left in the appliance at the end 
of the programme. 
– Waste water hose 
is blocked or kinked.
– Waste water pump blocked,  cover on the waste water pump  
is not locked in position  
(see Waste water pump).
–Fi lters blocked.
– The programme has not yet ended.  Wait until programme  
ends or implement “Reset”  
function.
Refill indicator for salt  X and/or rinse-
aid  `  is not lit.
– Refill indicator/s switched off. 
– Adequate salt/rinse-aid available. 
Refill indicator for special...

en 
22
Dull, discoloured glasses, film cannot be  
washed off. 
– Unsuitable detergent. 
– Glasses not dishwasher-proof. 
Streaks on glasses and cutlery, glasses  
have metallic appearance. 
– Too much rinse aid. 
Plastic parts discoloured. 
– Too little/unsuitable detergent. 
– Too weak programme selected. 
Rust spots on the cutlery. 
– Cutlery not rust-resistant. 
– Salt content in the rinsing water too 
high, as salt dispenser lock not  
fastened firmly or salt was spilled while  
being refilled....

en23
The dishwasher must be connected  
correctly, otherwise it will not function 
properly. The specifications for the inlet  
and outlet as well as the electrical  
connected loads must correspond with the 
required criteria as specified in the  
following paragraphs or in the installation  
instructions. 
Install the appliance in the correct  
sequence: 
– Checking appliance on delivery 
– Installing the appliance 
– Waste water connection 
–Fr
esh water connection
– Electrical connection
Safety...

en 
24
Technical specifications 
Weight: 
max. 53 kg
Voltage:
230 V, 50 Hz 
Connected load: 
2,3 kW
Fuse: 
10/13 A 
Water pressure:
at least 0.05 MPa (0.5 bar), maximum  
1MPa (10bar). At a higher water 
pressure: connect pressure-reducing valve  
ahead. 
Inlet rate: 
minimum 10 litres/minute 
Water temperature: 
cold water; hot water max. temperature  
60 °C. 
Installation 
The required installation dimensions can  
be found in the installation instructions.  
Level the appliance with the aid of the...

en25
Electrical connection 
– Connect the appliance only to 230 V 
and 50 Hz alternating current via  
a correctly installed socket with 
protective conductor. See rating plate  
for required fusing  9*.
– The socket must be near the appliance  and freely accessible following  
installation.
– The connection may be modified by  technicians only.
– A power cord extension may be  purchased from customer service only.
– Use only a residual current operated  circuit-breaker which features  
the symbol  ‚....

en 
26
Both the packaging of new appliances and  
the old appliances themselves contain 
valuable raw materials and recyclable  
materials. 
Please dispose of the individual parts  
separated according to type. 
Please ask your dealer or inquire at your  
local authority about current means of  
disposal. 
Packaging 
All plastic parts of the appliance are  
identified with internationally standardised  
abbreviations (e.g. >PS< polystyrene).  
Therefore, plastic waste can be sorted out  
when the...

   

 


 
DownloadedfromDishWasherManualcomManuals    

 
  


  







  
 


 

 
9000 210 888 en (9009) 450I