Sharp Ux A255 Thermal Transfer Plain Paper Fax With All Digi Operation Manual

Problems and Solutions
89
10. Trouble-
shooting
Reception and copying problems
Problem Solution
The fax machine doesnt 
receive documents 
automatically.Make sure that the reception mode is set to FAX. If 
you subscribe to a distinctive ring service, make 
sure that the Distinctive Ring function is set to the 
correct ring pattern. If you do not subscribe to a 
distinctive ring service, make sure that Distinctive 
Ring is set to OFF SETTING. (See Distinctive Ring 
on page 78.)
The printing paper comes...

Problems and Solutions
90
The quality of copies is 
poor and/or dark vertical 
lines appear.Any dirt or material on the scanning glass will 
cause spots to appear on copies and transmitted 
faxes. Clean the scanning glass as explained on 
page 85.
Reception/copying is 
interrupted.If reception or copying takes place continuously for 
a long time, the print head may overheat. Turn off 
the power and let it cool down. If overheating 
frequently occurs, try changing the print contrast 
setting to LIGHT...

Messages and Signals
91
10. Trouble-
shooting
Messages and Signals
Display messages
Note: If you have turned on the Caller ID function, see page 74 for display 
messages related to Caller ID.
ADD PAPER & /
PRESS START KEY
(alternating messages)Check the printing paper. If the tray is empty, add 
paper and then press the START/MEMORY key. If 
there is paper in the tray, make sure it is inserted 
correctly (take out the stack, align the edges evenly, 
and then reinsert it in the tray) and then press the...

Messages and Signals
92
LCR DOWNLOADING The fax machine has called OpenLCR and is 
receiving carrier rate data. This message only 
appears if you have registered with OpenLCR.
LINE ERROR Transmission or reception was not successful. Press 
the STOP key to clear the message and then try 
again. If the error persists, see Line Error on page 87.
MEMORY IS FULL/
SEE MANUAL
(alternating messages)The memory is full. You may have too many 
messages recorded in the answering machine. To 
erase messages, see page...

Messages and Signals
93
10. Trouble-
shooting
PRINT HEAD FAIL/
YOU NEED SERVICE
(alternating messages)The print head has failed and requires service.
READY TO SEND A document has been loaded and the fax machine is 
waiting for you to begin faxing or copying.
RECALLING This appears if you attempt to send a fax by 
automatic dialing and the line is busy or the receiving 
fax machine does not answer. Your fax machine will 
automatically reattempt the call. (See Automatic 
redialing on page 61.)
T.A.D....

Clearing Paper Jams
94
Clearing Paper Jams
Clearing a jammed document
If the original document doesn’t feed properly during transmission or copying, 
or DOCUMENT JAMMED appears in the display, first try pressing  . If 
the document doesnt feed out, remove it as explained below.
Important:
Do not try to remove a jammed document without releasing it as explained 
below. This may damage the feeder mechanism.
START/MEMORY
1Press 
 and slowly open the operation 
panel until it is half open.
2Flip up the green...

Clearing Paper Jams
95
10. Trouble-
shooting
1Open the operation panel (press 
).
2Gently pull the jammed paper out of 
the machine, making sure no torn 
pieces of paper remain in the print 
compartment or rollers.
3Rotate the front gear until the film is taut, and then close the operation 
panel (press down on both sides to make sure it clicks into place).
Clearing jammed printing paper
4Flip down the green levers on each side of the white roller. Rotate the 
front gear until the film is taut, and then...

Ordering Parts
96
Ordering Parts
To order parts, contact the parts distribution center located nearest 
you. When ordering a part, use the part order number shown below. 
Operation manual  TINSE4265XHTZ
Setup Guide TCADZ3319XHZZ
Handset cord QCNWG209BXHOW
Telephone line cord QCNWG208BXHZZ
Hand set DUNTK468BXHFW
Paper tray CPLTP3183XHR7
Paper tray extension  LPLTP3184XHZZ
Gears CGERH2566XH01
NGERH2568XHZZ
Part distribution centers 
Tritronics, Inc. 
1306 Continental Drive 
Abingdon, MD 21009Tel:...

FCC Regulatory Information
97
FCC Regulatory Information
This equipment complies with FCC rules, Part 68. On this equipment is a label 
that contains, among other information, the Registration Number and Ringer 
Equivalence Number (REN) for this equipment. If requested, this information 
must be provided to your telephone company. 
An FCC compliant telephone cord and modular plug is provided with this 
equipment. This equipment is designed to be connected to the telephone 
network or premises wiring...

98
SHARPDate Revised: .Date Issued :July. 3. 2001
MATERIAL SAFETY DATA SHEET (1/2)MSDS No. B-1026
Section 1. Product and Company Identification
Product Name :IMAGING FILM UX-5CR
Supplier Identification :Sharp Corporation
22-22 Nagaike-cho, Abeno-ku, Osaka, Japan
Manufacturer :DAINIPPON PRINTING CO. LTD.
591-2, Kamihirose, Higashikubo, Sayamashi, Saitama, 350-1321 JAPAN
Emergency telephone number :+81-42-952-9666
Local suppliers are listed below. Please contact the nearest supplier for additional...