Sharp Projector Pg F310x User Manual

27
Basic
Operation
3 Adjusting the Height
The height of the projector can be ad-
justed using the adjustment feet at the
front and rear of the projector.
When the screen is above the projec-
tor, the projection image can be made
higher by adjusting the projector.
1
2
3
• Do not apply too much pressure on the pro-
jector when the front adjustment foot comes
out.
• When lowering the projector, be careful not to
get your fingers caught in the area between
the adjustment foot and the projector.
•
Hold the...

28
0
KEYSTONEADJUST END
Correcting Trapezoidal
Distortion
When the image is projected either from
the top or from the bottom towards the
screen at an angle, the image becomes
distorted trapezoidally. The function for
correcting trapezoidal distortion is
called Keystone Correction.
• The Keystone Correction can be adjusted up
to an angle of approximately ±40 degrees and
the screen can also be set up to an angle of
approximately ±40 degrees (when the resize
mode is set to “NORMAL” (see page  30)).
Note
1...

29
Basic
Operation
Displaying the Black Screen
and Turning off the Sound
T emporarily
Adjusting the Volume
Switching the Input Mode
Press  COMPUTER , DVI , S-VIDEO  or
VIDEO  on the remote control to select
the input mode.
• When you press  INPUT on the projector or  DVI
on the remote control, the INPUT list appears.
Press  P/R  to switch the INPUT mode.
Select the appropriate input mode for
the connected equipment.
Press  VOL +/–  on the remote control or
– O /Q + on the projector to adjust the vol-...

30
Resize Mode
This function allows you to modify or customize the resize mode to enhance the input image. De-
pending on the input signal, you can choose a desired image.
Press RESIZE .•See page 43 for setting on menu screen.RESIZE button
COMPUTER
STRETCH
For 4:3 screen For 16:9 screen
Input signal
Image type
NORMAL FULL BORDER
4:3 aspect ratio
5:4 aspect ratio
16:10 aspect ratio 16:9 aspect ratio
: 
Cutout area on which images cannot be projected
:  Area where the signals are off screen
*The Image...

31
Basic
Operation
VIDEOVIDEO/DTV
**
**
*
*
* *
4:3 aspect ratio
Squeeze
Letter box
16:9 aspect ratio 16:9 aspect ratio
(4:3 aspect ratio in 16:9)
For 4:3 screen For 16:9 screen
Input signal
Image type NORMAL
Video/DTV
480 I,  480P,
576 I,  576P,
NTSC, PAL, SECAM
720P, 1035 I,
1080 I,  1080P
540P
:  Cutout area on which images cannot be projected
:  Area on which the image is not included in the original signals
*The Image Shift function can be used for these images.
BORDER STRETCH
AREA ZOOM
V
-STRETCH 

32
Operating with the Remote Control
Displaying and Setting the
Break Timer
Press BREAK TIMER .•The timer starts to count down from 5
minutes.1
2
Press  P/R /O /Q  to adjust the
length of the break time.
• Increases with  P or  Q
5 minutes  s 6 minutes  s 60 minutes•Shortens with  O or  R4 minutes  s 3 minutes  s1 minute
• The break time can be set in units of one
minute (up to 60 minutes).
On-screen display
Canceling the break timer display function
Press  BREAK TIMER .
•Break Timer does not function...

33
Useful
Features
Press   MAGNIFY  on the remote
control.
• Enlarges the image.
•P ressing   or   MAGNIFY  enlarges
or reduces the projected image.
Note
 1 2 3 4
Press
.
Press.
•Y
ou can change the location of the en-
larged image using  P, R , O  and  Q.
Press  RETURN  on the remote con-
trol to cancel the operation.
• The magnification then returns to  ×1.
Note
• The selectable magnifications differ
depending on the input signal.
• In the following cases, the image will
return to the normal size (...

34
Using the Remote Control as the Wireless Computer Mouse
When connecting the projector and the computer with a USB cable, you can use
the remote control as the computer mouse.
If the computer is placed too far away from the projector to be connected via the
USB cable, the remote receiver (optional, AN-MR2) makes it possible to operate
the projector with the remote control.  For details, see the operation manual of
the receiver.
Connecting with a USB cable
or
Remote receiver 
(optional, AN-MR2)To USB...

35
Useful
Features
The following shows the items that can be set in the projector.
Menu Items
Picture Mode
Contrast 0 0
0
0
BrightColorTint0
Sharp
Standard
SEL./ADJ. ENTER END 0
0
Red
Blue
Picture
SCR - ADJ PRJ - ADJ Help
Picture Mode
CLR Temp
BrilliantColor
TMC.M.S. Setting
C.M.S. Standard
SEL./ADJ. ENTER END
Progressive
Lamp Setting
0
1
On
3D Progressive
Bright
Reset
Picture SCR - ADJ PRJ - ADJ Help
PAGE 2
Main menu Sub menuPicture
Page  40Page  40
Page  41
Page  41
Page  41
Page  41
Page  41
Page  42...

36
Menu Items (Continued)
SEL./ADJ. ENTER END
Auto Power Off
System Sound
System Lock
hOn On
Auto Restart On
STANDBY Mode Standard
0min
0
Lamp Timer(Life) 100%
Auto Sync On
Picture SCR - ADJ
PRJ - ADJHelp
Speaker OnAudio Input Audio 1RS-232C 9600bpsFan Mode Normal
Disable
Main menu Sub menuPRJ - ADJPage 45
STANDBY Mode
System Sound [On/Off]
Speaker [On/Off]
System Lock
[Enable/Disable]
Lamp Timer(Life)Page  45
Auto Restart [On/Off]Page  45
Auto Power Off [On/Off]Page  45
Page  45
Page  45
Page  46
Page...