Sharp Cv10ctxw Manual

EN-19
ENGLISH
Point the remote control towards the units signal receiver window and press the desired button. A beep will sound when the unit receives the signal.
•	 Make	sure	nothing,	such	as	curtains,	blocks the signal receiver window.
•	For good reception of signal, the distance between operator and the unit should be no more than 5 meters.
CAUTION
•	 Do	not	expose	the	signal	receiver	window	to	direct	sunlight.	This	may	adversely affect its operation. If necessary, close the curtains to block out the...

EN-20
OPERATION OF WIRELESS REMOTE CONTROL
Notice: This is a general use remote controller, it could be used for the air 
conditioners with multifunction.
•	 Names	and	functions	of	wireless	remote	control Note: Be sure that there are no obstructions between receiver and remote controller; Don't	drop	or	throw	the	remote	control;	Don't	let	any	liquid	in	the	remote	control	and	put the remote control directly under the sunlight or any place where is very hot. 
ON/OFF buttonON/OFF
Remote control...

EN-21
ENGLISH
Remote control
+ button+
- button-
TIMER buttonTIMER
ON/OFFMODE
FAN
SLEEP TIMER+
-
AUTO
COOL
DRY
FANT-ON
T-OFFSLEEP
LOCK
SPEED
•  For presetting temperature increasing. 
Press this button, to set up the 
temperature, when unit is on . Continu-
ously press and hold this button for 
more than 2 seconds, the correspond-
ing contents will be changed rapidly, 
until unpress the button then send the 
information, Cº (ºF) is displaying all 
along. In Auto mode, the temperature 
can not be set up,...

EN-22
OPERATION OF WIRELESS REMOTE CONTROL
Guide for operation- General operation
1. After powered on, press ON/OFF button, the unit will start to run.
2.	Press	MODE	button,	select	desired	running	mode, enter into the corresponding operation directly.
3.	Pressing	+	or	-	button,	to	set	the	desired	temperature.	(It	is	unnecessary	set	the	temp.	at	AUTO	mode.)
4. Pressing FAN button, set fan speed, can select AUTO,	FAN	1,	FAN	2,	FAN	3	or	FAN	4.	(Note:	When	select	Fan	4,	the	fan	speed	is	same	as	fan	3	on	this...

EN-23
ENGLISH
MAINTENANCE
•	 Changing	batteries	and	notices
1. Slightly to press the place to take out the back cover of wireless remote control.(As	shown	in	figure)
2. Take	out	the	old	batteries.	(As	show	in	figure)
3. Insert	two	new	AAA1.5V	dry	batteries,	and	pay	attention	to	the	polarity.	(As	show	in	figure)
4. Attach the back cover of wireless remote	control.	(As	show	in	figure
NOTE: 
•	 When	changing	the	batteries,	do	not	use	old or different batteries, otherwise, it can cause the malfunction of the...

EN-24
Gas
12
2
MAINTENANCE
Mobile AC  
There are wheels at bottom of mobile air conditioner that enable the unit moves \
among rooms conveniently according to need.
Warning	  Plug off power plug from socket and cut off power before any maintenance to prevent electric shock or damage to units.
Clean air filter   If too much dust collected on filter, performance of air conditioner will reduce, thus it is better to clean filter at least once 2 weeks.
Note:   
Disassembly	 From	these	two	direction	to	take...

EN-25
ENGLISH
MALFUNCTION ANALYSIS
If malfunction occur, please check the following before maintenance:
TroublesPossible CausesSolutions
The air conditioner doesn't	start.The power supply is not connected well.
The power plug is not inserted tightly.
There is the malfunction of power plug or socket.
The fuse is broken.
1. Insert the power plug tightly.
2. Replace the power plug or socket.
3. Ask for the maintenance man to replace the fuse.
Although it was set to COOL mode, there is no cool wind.
1....

EN-26
SAFETY NOTICE
Location		Don't	place	the	unit	in	narrow	location.	Guarantee	better	ventilation	for	unit	to	prevent malfunction occurs. 
	Don't	place	the	unit	in	where	there	is	direct	sunburn	to	prevent	fade	and	reduce	of effect.
	The	unit	should	be	at	least	50cm	away	from	surface	of	flammable	thing.
	Don't	soak	the	unit	or	operateit	in	place	where	is	easyto	get	wet	to	prevent	creepage.
	Don't	operate	the	unit	in	following	location	for	malfunction	may	be	led:
	*Gas	place	*Fire*	where...

EN-27
ENGLISH
MALFUNCTION ANALYSIS
For disposal there are several possibilities:
a)	The	municipality	has	established	collection	systems,	where	electronic	waste	can	be	disposed	of	at least free of charge to the user.
b)	When	buying	a	new	product,	the	retailer	will	take	back	the	old	product	at	least	free	of	charge.
c)	The	manufacturer	will	take	back	the	old	appliance	for	disposal	at	least	free	of	charge	to	the	user.
d)	As	old	products	contain	valuable	resources,	they	can	be	sold	to	scrap	metal	dealers....

EN-28