Sega Virtua Striker 3 Kit Installation Service Manual

							19 [GAME DATA]
DRAW COUNT: Displays the total number of draw games.
VS WINS MAXIMUM: Displays the maximum number of wins in the vs. mode.
VS WINS HISTOGRAM: Displays the histogram of the total number of wins in the
vs. mode.
Press TEST Button to return to the MENU screen.
BOOKKEEPING Screen (4/4)
BOOKKEEPING 4/4
DRAW COUNT     XX
VS WINS MAXIMUM     XX
VS WINS HISTOGRAM     XX
PRESS TEST TO EXIT 
						

							20 [VS WIN RANK (2/2)]
Displays the ranking of each team's victory percentage sequentially in order.
WIN RATE: Displays team's percentage of victories to the total number of vs.
games in vs. mode.
WIN: Displays each team's total number of victories in the vs. mode.
LOSE: Displays each team's total number of losses in the vs. games.
DRAW: Displays each team's total number of draws in the vs. games.
Press TEST Button to return to the MENU screen. e.  VS DATA
[TEAM USED RANK (1/2)]
TEAM USED RANK displays the ranking data of teams as per team selection
frequency.
USED_NUM: Displays team selection frequency.
USED_RATE: Displays the ratio of selection of each team against all teams.
Press TEST Button to proceed to the next screen (2/2). Allows the team data in the vs. mode to be checked. 
						

							21 f.  BACKUP DATA CLEAR
This allows the contents of [d. BOOKKEEPING] and [e. VS DATA] to be
cleared.  The ranking data of [e. VS TEAM DATA] returns to the ranking
described in this Manual.
When clearing, use the SERVICE Button to bring the arrow to "YES (CLEAR)"
and press the TEST Button.  When the data has been cleared, "COMPLETED" is
displayed.  To return to the MENU mode, press the TEST Button again.
When not clearing, bring the arrow to "NO (CANCEL)" and press the TEST
Button to return to the MENU mode with data unchanged.
BACKUP DATA CLEAR ScreenBACKUP DATA CLEAR
> YES (CLEAR)
   NO (CANCEL)
PRESS SERVICE TO SELECT.
PRESS TEST TO EXECUTE. 
						

							22
4.  GAME BOARD
Do not expose the Game Board so as to avoid causing an accident
or malfunctioning.
Static electricity discharge can damage electronic parts on the IC
Board.  Before starting work by opening the Shield Case Lid, be
sure to touch grounded metallic surfaces to discharge physically
charged static electricity.
When replacing the Game Board, refer to the CVT Manual and
Instruction Manual.
PART NO. DESCRIPTION
840-0071D-01 ASSY CASE NAT PCI DIMM BD USA
840-0071D-02 ASSY CASE NAT PCI DIMM BD EXP
840-0071D-03 ASSY CASE NAT PCI DIMM BD KOR
840-0071D-04 ASSY CASE NAT PCI DIMM BD AUS
840-0046A-01 ASSY CASE NAOMI 2 MAIN BD USA
840-0046A-02 ASSY CASE NAOMI 2 MAIN BD EXP
840-0046A-03 ASSY CASE NAOMI 2 MAIN BD KOR
840-0046A-04 ASSY CASE NAOMI 2 MAIN BD AUS
840-0001F ASSY CASE NAO DIMM BD COM
610-0617 GD-ROM DRIVE UNIT NAOMI
1
2
3
12
1
2
3+ 
						

							23
PART NO. DESCRIPTION
840-0001F ASSY CASE NAO DIMM BD COM
KEY CHIP
840-0061B-01 DIMM BD NAT VS3
442-00061B-01 (STICKER 840-0061B-01)
Attached place
1
2
1
2
12 + 
						

							24
Handling the GD-ROM Disk
Do not contaminate the disks with your
fingerprints or dust particles. Contaminated
disks may lower audio and video quality.
When cleaning the disks, do not use volatile
chemicals (benzine, thinner, etc.), cleaning
sprays, and antistatic agents.
Do not use cracked, warped, or damaged
disks.
Do not attach papers or seals onto the disks;
do not scratch the disks.
Do not use the disks with a sign of peeled seals, tapes, etc.
Observing these instructions, do not insert such a non-usable disk
into the GD-ROM drive. Otherwise the inserted disk can not be
ejected.
When cleaning a heavily contaminated disk, use clean cloth that
has been soaked in water and squeezed. Then remove moisture
with dry cloth.
When holding a disk, be careful not to contaminate it with your
fingerprints.
How to Hold a Disk
With both hands:
Put your thumbs and forefingers of both
hands on the disk's 4 circumference tips.With one hand:
Insert your forefinger into a
central hole and at the same
time put your thumb and middle
finger on the disk's 2
circumference tips.
5.  SOFT KIT
How to Handle the Key Chip
The key chip is a precision device. Handle it carefully because it
may be damaged by heat, shock, and static electricity.
Use the key chip with the GD-ROM disk of the corresponding
game that has been shipped together with the key chip.
STOP
IMPORTANT
Use clean cloth to wipe
the disk gently and into a
radial direction. 
						

							25
PART NO. DESCRIPTION
610-0630-0006 GD SOFT KIT VS3 ENG
GDS-0006 * NAOMI 2 GDROM VS3
KEY CHIP
420-6621-0006E SERVICE MANUAL VS3 ENG
253-5507 DISK CASE WITH IC HOLDER
1
2
3
4
1
2
3
4
1234 +++ 
						

							50
80
514150 50 31
8 38 -1 36 16
A UD IO  P O W ER  A M P 2 CHJS T  V H 4 P
TRA NSFO RM ER  0 V12 0V  0 V 1 7V  0 V 1 7V
1P  CW HIT E(U /P )
1
32
P  C
5 6 0-5 4 07
JS T  V LP  CJ S T  V L
+12VG N DGN DGN D+3.3 V+5VG N D+3.3 V+5VG N D400-5 397
SW  R EG U F O R J VS
6 00 -6 74 3-0 50
600 -7 14 1-0 50600 -7 15 5
P  C
8 38-1 3683-9 1
3
21
30 10 50 50 
120 V ac In p ut
[E xtra ]
5 k p o t
S PEA KER  O UTPU TS
To P IN  8of J a m ma
To E xtraY ello w  W ir eC O IN  C O UN TER
JA M MA C O NNEC TIO NS U SED  A RE:° V ID EO  O UT° S W IT C H  IN PU TS° S W IT C H  G RO UN D R ET U RN S° C O IN  C O UN TER  O UTPU T
N O TE:  T H ER E A RE T O  B E N OCO NNEC TIO NS M ADE T O  T H EJA M MA IN TER FA CE O TH ER  T H A NTH E A BO VE F O REM EN TIO NED .
1020304050
607080AB
CDE
 N A O M I  K IT  U N IV ER S A L
W IR IN G D IA GRA M   ( 1 /1 )
CN 6
Pho nop lu gs
7 1917292
10 30 50 50 34256
30 
10  
50
3 0 
1 0 
5 0
6
1
[G D  R O M  D RIV E]
1        V CC2        V CC3        N C4       1 P S W 65       1 P S W 76       1 P S W 87       N C8       2 P S W 69       2 P S W 710    2 P S W 811    N C12    N C13    G N D14    G N D
JP 1
M UST  B E S E T  T O   IN TO  U SE  I N PU TS O N C N 3
O UT
IN