Samsung X105 User Guide

							Access Codes
107
Access Codes
There are several access codes that are used by your phone and 
its SIM card. These codes help you protect the phone against 
unauthorized use.
When requested for any of the codes explained below, key in 
the appropriate code (displayed as asterisks) and press the 
OK 
soft key. If you make a mistake, press the   key one or more 
times until the incorrect digit is cleared and then continue 
entering the correct code.
The access codes, except for the PUK and PUK2 codes can be 
changed using 
Security menu options (Menu 5.5). See 
page 83 for further details.
Important! Avoid using access codes resembling emergency 
numbers, such as 911, so that you do not dial an emergency 
number accidentally.
Phone Password
The Phone Lock feature uses the phone password to protect 
your phone against unauthorized use. The phone password is 
supplied with the phone and is factory set to 00000000.
To... Refer to...
Activate/deactivate the Phone 
Lock featurePage 84
(Menu 5.5.3).
Change the phone password Page 84
(
Menu 5.5.4). 
						

							Access Codes                
108
PIN
The Personal Identification Number or PIN (4 to 8 digits) 
protects your SIM card against unauthorized use. It is usually 
supplied with the SIM card.
If you enter an incorrect PIN three times in succession, the code 
is disabled and cannot be used until you re-enable it by entering 
the PUK (see below).
PUK
The 8-digit PUK (Personal Unblocking Key) is required to 
change a disabled PIN. The PUK may be supplied with the SIM 
card. If not, or you have lost it, contact your service provider.
To re-enable your PIN, proceed as follows.
1. Key in the PUK and press the 
OK soft key.
2. Enter a new PIN of your choice and press the 
OK soft key.
3. When the 
Confirm New PIN message is displayed, key in 
the same code again and press the 
OK soft key.
If you enter an incorrect PUK ten times in succession, the SIM 
card becomes invalid. Contact your service provider for a new 
card.
To... Refer to...
Activate/deactivate the PIN 
Check featurePage 83 
(Menu 5.5.1).
Change the PIN Page 84
(
Menu 5.5.2). 
						

							Access Codes
109
PIN2
The PIN2 (4 to 8 digits), supplied with some SIM cards, is 
required to access specific functions, such as setting the 
maximum cost of a call. These functions are available if 
supported by your SIM card.
If you enter an incorrect PIN2 three times in succession, the 
code is disabled and you cannot access the functions until you 
re-enable it by entering the PUK2.
To change the PIN2, refer to page 85 (
Menu 5.5.7).
PUK2
The 8-digit PUK2 (Personal Unblocking Key 2), supplied with 
some SIM cards, is required to change a disabled PIN2. If you 
lose the code, contact your service provider.
To re-enable your PIN2, proceed as follows.
1. Key in the PUK2 and press the 
OK soft key.
2. Enter a new PIN2 of your choice and press the 
OK soft key.
3. When the 
Confirm PIN2 message is displayed, key in the 
same code again and press the 
OK soft key.
If you enter an incorrect PUK2 ten times in succession, you will 
not be able to access the functions requiring the PIN2. Contact 
your service provider for a new card. 
						

							Access Codes                
11 0 
						

							WAP Browser
111
WAP Browser
Your phone comes equipped with a WAP (Wireless Application 
Protocol) browser, making it possible for you to access the 
Wireless Web.
About the WAP Browser
The WAP Browser allows you to:
 ●Access up-to-the minute information via your phone
 ●View specially designed text versions of popular Internet 
sites including Yahoo!, CNN Mobile and the Weather 
Channel
Browsing the Wireless Web using your phone is unlike using 
your computer, in that site provides have:
 ●Selected only the critical aspects of their site for wireless 
phone users
 ●Removed most graphics
Each time you start the WAP Browser, the phone connects to 
the Wireless Web and the service indicator icon appears on the 
display to inform you that you are:
 ●Are connected to the Wireless Web
 ●Will be billed accordingly (rates vary according to your 
service option)
The WAP Browser ends the network connection after a certain 
period of inactivity and automatically reconnects as necessary. 
For this reason, you may find that you are billed for several 
network connections within a single session. This is normal and 
is designed to minimize you bill. 
						

							WAP Browser                
11 2
Accessing the WAP Browser
To  e n t e r  t h e  t-zones menu to access the WAP browser:
1. When the idle Screen is displayed, press the 
Menu soft key 
to enter the menu mode.
2. Press the   or   until the Funbox menu option is displayed, 
and then press the Select soft key. You can also press the 
8 
key directly.
3. Press the   or   key one or more times to highlight 
t-
zones, then press the Select soft key. You can also press 
the 
1 key directly.
4. Press the   or   key one or more times to highlight the 
required option and then press the 
Select soft key.
Option Description
Home
Connects the phone to the network and loads 
the homepage of the Wireless Web service 
provider.
http://This option allows you to manually enter the 
URL address of the Web site that you wish to 
access. You can access this menu directly by 
pressing and holding down the key in the WAP 
Browser.
FavoriteAllows you to store the URL addresses of your 
favorite Web sites. You can access this menu 
directly by pressing and holding the 
 key 
while using the WAP Browser. To store a URL 
address, select an empty location and enter 
the address. Three submenus are available. 
Select 
Go to URL to access the site quickly, Edit to edit the selected address and Delete 
to delete the selected address. 
						

							WAP Browser
11 3
Starting the WAP Browser
To start the WAP Browser when the idle screen is displayed 
press the   key or press the Menu soft key, followed by the
 
8
, 1 and 1 keys.
A connection is established with your service provider and the 
corresponding homepage is displayed.
The content of the WAP Browser startup homepage depends on 
your Wireless Web service provider. To scroll through the 
screen, use the   and   keys.
Note: To access the startup homepage from any other screen in the WAP 
Browser, use the Home option. For more information on the WAP 
Browser menus, refer to...
Exiting the WAP Browser
To exit the browser at any time, simply press the   key or 
press and hold down the   key.
 Clear CacheClears the information stored in the cache 
(the phone’s temporary memory used to store 
the most recently accessed Web pages).
Push 
MessageIn this menu option, you can receive and 
access web messages from the server. The 
following options are available:
Inbox:  allows you to read the messages 
received from the web server.
Receive: allows you to set whether or not your 
phone receives web messages.
Delete All:  allows you to delete all of the web 
messages.
Option Description 
						

							WAP Browser                
11 4
Using the WAP Browser
Using the Soft Keys
A bar containing browser commands is located at the bottom of 
the WAP Browser display. The soft keys below the bar are used 
to execute these commands. The two keys are called soft keys 
because their functions changes depending on the WAP Browser 
application in use.
Navigating the Wap Browser
To... Then....
Scroll through and select 
browser itemsPress the  and   key until the   
symbol points to the required item, 
and then press the 
OK soft key to 
confirm the selection.
Select a numbered item Press the corresponding numeric key.
Return to the previous 
pagePress the 
Back soft key or the   key.
Return to the startup 
homepageSelect the 
Home menu option; for 
more information on this option, refer 
to page 116. 
						

							WAP Browser
11 5
Entering Text, Numbers or Symbols
When you are prompted to enter text, the current text entry 
mode is indicated on the screen. The following modes are 
available.
Note: To enter symbols, press the 1 key repeatedly until the required 
symbol is displayed.
Mode Description
A/a
Allows you to enter letters in the alphabet. 
Press the corresponding key until the 
required letter is displayed
1Allows you to enter numbers.
To... Then....
Change modes Press the  key one or more times.
Enter a space
Press the .
Edit textSet the cursor to the right of the 
character to be corrected
Press the   key as required. 
Enter the correct character(s). 
						

							WAP Browser                
11 6
Using and Selecting WAP Menu Options
Various menu options are available when you are using the WAP 
Browser to navigate the Wireless Web.
To access a menu option, proceed as follows:
1. Press and hold down the   key. A menu is displayed.
2. Highlight the required menu option by pressing the   and 
 keys.
3. Select the option by pressing the 
Select soft key.
4. If necessary, select the secondary option using the   and   
keys, and press the 
Select soft key to confirm.
Note: The menus may vary, depending on your version of the WAP 
Browser.
Reload
This option reloads the current page.
Home
This option takes you back at any time to the homepage of the 
Wireless Web service provider.
Go to URL
This option allows you to enter manually the URL address of the 
required Web page.
After entering an address, press the 
OK soft key to go there 
directly.