Samsung Syncmaster 920lm Quick Start Guide

							  
  
  
  
  
  
  
  
  
  
  
  
  
   
     
 
 
 
Install driver  
 
   
 
 
  
SyncMaster 920NW  
 
						

							 
 
  Notational 
  
 
 
 
 
 
Failure to follow directions noted by this symbol could result in bodily harm or damage to 
the equipment.  
 
 
 
Prohibited Important to read and understand at all times 
Do not disassemble Disconnect the plug from the outlet 
Do not touch Ground to prevent an electric shock 
 
 
 
 
 
  Power 
  
When not used for an extended period of time, set your computer to DPMS.  
If using a screen saver, set it to active screen mode.    
The images here are for reference only, and are not applicable in all cases (or countries).
 
						

							 
 
 Do not use a damaged or loose plug. 
zThis may cause electric shock or fire.  
 
 
 
  Do not pull the plug out by the wire nor touch the plug with wet hands. 
zThis may cause electric shock or fire.  
 
 
 
  Use only a properly grounded plug and receptacle. 
zAn improper ground may cause electric shock or equipment damage.  
 
 
 
  Insert the power plug firmly so that it does not come loose. 
zA bad connection may cause fire.  
 
 
 
  
  Do not excessively bend the plug and wire nor place heavy objects upon 
them, which could cause damage.  
zThis may cause electric shock or fire.  
 
 
 
  
  Do not connect too many extension cords or plugs to one outlet.  
zThis may cause fire.  
 
 
 
  
  Do not disconnect the power cord while using the monitor.  
zA surge may be caused by the separation and may damage the monitor. 
 
 
 
  
  Do not use the power cord when the connector or plug is dusty.  
zIf the connector or plug of the power cord is dusty, clean it with a dry 
cloth.  
zUsing the power cord with a dusty plug or connector may cause electric 
shock or fire.  
 
 
 
 
 
						

							 
  Installation  
  Be sure to contact an authorized Service Center, when installing your monitor in 
a location with heavy dust, high or low temperatures, high humidity, and exposed 
to chemical substances and where it operates for 24 hours such as at airports, 
train stations etc. 
 
Failure to do so may cause serious damage to your monitor. 
 
 
Place your monitor in a location with low humidity and a minimum of 
dust. 
zFailure to do so may cause electric shock or fire inside the monitor.  
 
 
Do not drop the monitor when moving it. 
zThis may cause damage to the product or the person carrying it.  
 
 
Install the monitor base in a showcase or shelf so that the end of the 
base does not protrude from the showcase or shelf. 
zDropping the product may cause damage to the product or the person 
carrying it.  
 
 
Do not place the product on an unstable or small surface area. 
zPlace the product on an even and stable surface, as the product may fall 
and cause harm to someone walking by, specifically children.  
 
 
Do not place the product on the floor. 
zTake care, as someone, specifically children may trip over it.  
 
 
Keep any flammable objects such as candles, insecticides or cigarettes 
away from the product. 
zOtherwise, this may cause fire.A melted coating may cause electric 
shock or fire.  
 
 
Keep any heating devices away from the power cable. 
zA melted coating may lead to electric shock or fire.  
 
 
Do not install the product in places with poor ventilation, for instance, a 
bookshelf, closet, etc. 
zAny increase in the internal temperature may cause fire.  
 
						

							 
 
Put down the monitor carefully. 
zFailing to do so may damage the monitor.  
 
 
Do not place the monitor face down. 
zThis may damage the TFT-LCD surface.The installation of the bracket 
must be done by a qualified professional.  
 
 
Installing a wall bracket must be done by a qualified professional. 
zInstalling the bracket by unqualified personnel may result in injury.  zAlways use the mounting device specified in the owners manual.  
 
 
When installing the product, make sure to keep it away from the wall 
(more than 10 cm/4 inches) for ventilation purposes. 
zPoor ventilation may cause an increase in the internal temperature of the 
product, resulting in a shortened component life and degraded 
performance.  
 
 
Keep the plastic packaging (bag) out of childrens reach. 
zThe plastic packaging (bag) may cause suffocation if children play with 
it.  
 
 
 
 
 
  Clean  
  
When cleaning the monitor case or the surface of the TFT-LCD screen, wipe with 
a slightly moistened, soft fabric. 
 
 
Do not spray water or detergent directly onto the monitor. 
zThis may cause damage, electric shock or fire.  
 
						

							 
 
Use the recommended detergent with a smooth cloth.  
 
 
If the connector between the plug and the pin is dusty or dirty, clean it 
properly using a dry cloth. 
zA dirty connector may cause electric shock or fire.  
 
 
Make sure to unplug the power cord before cleaning the product. 
zOtherwise, this may cause electric shock or fire.  
 
 
Unplug the power cord from the power outlet and wipe the product using 
a soft, dry cloth. 
zDo not use any chemicals such as wax, benzene, alcohol, thinners, 
insecticide, air freshener, lubricant or detergent.  
 
 
Contact the SAMSUNG customer care center or Customer Center for 
interior cleaning once a year. 
zKeep the products interior clean. Dust which has accumulated in the 
interior over an extended period of time may cause a malfunction or fire.  
 
 
 
 
 
  Others  
  
Do not remove the cover (or back). 
zThis may cause electric shock or fire.  
zRefer to a qualified servicing company.  
 
 
If your monitor does not operate normally - in particular, if there is any 
unusual sound or smell coming from the monitor - unplug it immediately 
and contact an authorized dealer or the Service Center.  
zThis may cause electric shock or fire.  
 
 
Keep the product away from places exposed to oil, smoke or moisture; 
do not install inside a vehicle. 
zThis may cause a malfunction, electric shock or fire.  
 
						

							zIn particular, avoid operating the monitor near water or outdoors where 
the monitor could be exposed to snow or rain.  
 
 
If the monitor is dropped or the casing is damaged, turn the monitor off 
and unplug the power cord. Then contact the Service Center . 
zThe monitor may malfunction, causing electric shock or fire.  
 
 
Disconnect the plug from the outlet during storms or lightning or if it is 
not used for a long period of time. 
zFailure to do so may cause electric shock or fire.  
 
 
Do not try to move the monitor by pulling only the wire or the signal 
cable. 
zThis may cause a breakdown, electric shock or fire due to damage to 
the cable.  
 
 
Do not move the monitor right or left by pulling only the wire or the 
signal cable. 
zThis may cause a breakdown, electric shock or fire due to damage to 
the cable.  
 
 
Do not cover the vents on the monitor cabinet. 
zBad ventilation may cause a breakdown or fire.  
 
 
Do not place water containers, chemical products or small metal objects 
on the monitor. 
zThis may cause a malfunction, electric shock or fire.  zIf a foreign substance enters the monitor, unplug the power cord and 
contact the Service Center.  
 
 
Keep the product away from combustible chemical sprays or 
inflammable substances. 
zThis may cause an explosion or fire.  
 
 
Never insert anything metallic into the monitor openings.  
zThis may cause electric shock, fire or injury.  
 
						

							 
 
Do not insert metal objects such as chopsticks, wire and tools or 
inflammable objects such as paper or matches into the vent, headphone 
port or AV ports or etc. 
zThis may cause electric shock or fire. If an alien substances or water 
enters the product, turn the product off, unplug the power connector 
from the wall outlet and contact the Service Center.  
 
 
When viewing a fixed screen for an extended period of time, residual 
image or blurriness may appear. 
zChange the mode to energy saving mode or set a screensaver to a 
changing picture when away from the monitor for an extended period of 
time.  
 
 
Adjust the resolution and frequency to the level appropriate for the 
model. 
zAn inappropriate resolution may cause undesirable picture quality.  
 
19 inch Wide (48 cm) - 1440 X 900 
 
 
Viewing the monitor continuously at a too close angle may result in 
damage to your eyesight. 
 
 
To ease eye strain, take at least a five-minute break after every hour of 
using the monitor. 
 
 
Do not install the product on an unstable, uneven surface or a location 
prone to vibrations. 
zDropping the product may cause damage to the product or the person 
carrying it. Using the product in a location prone to vibrations may 
shorten the lifetime of the product or may cause the product to catch fire. 
 
 
When moving the monitor, turn off and unplug the power cord.  
Make sure that all cables, including the antenna cable and cables 
connected to other devices, are disconnected before moving the 
monitor. 
zFailure to disconnect cables may damage it and cause fire or electric 
shock.  
 
 
Place the product out of childrens reach, as they could damage by 
hanging onto it. 
zA falling product may cause injury to the person or even fatality.  
 
 
When not using the product for an extended period of time, keep the 
product unplugged. 
 
						

							zOtherwise, this may cause heat emission from the accumulated dirt or 
degraded insulation, causing electric shock or fire.  
 
 
Do not place your childrens favorite toys or any other objects of interest 
on the product. 
zChildren may try to climb on the product to retrieve an object. The 
product could fall, causing injury or even fatality.  
 
 
When lifting up or moving the monitor, do not lift the monitor upside 
down while holding only the stand. 
zThis may cause your monitor to fall, and become damaged or cause 
personal injury.  
 
 
 
 
  Good Postures When Using the Monitor 
  
Try to maintain a good posture when using the monitor. 
zKeep your back straight.  zKeep a distance of about 45 ~ 50 cm between your eyes and 
the monitor screen. Look at the screen from slightly above it, 
and have the monitor directly in front of you. 
zTilt the monitor upwards by 10 ~20 degrees. Adjust the monitor 
height so that the top of the monitor is slightly below eye level. 
zAdjust the monitor angle so that there is no reflected light on 
the screen.Try to maintain your arms perpendicular to your 
armpits. 
zKeep your arms level with the back of your hands. 
zKeep the angle of the elbow perpendicular. zKeep the angle of the knees at more than 90 degree. Do not let 
your feet fall up from the floor. Adjust the arm position so that it 
is below the heart.  
 
 
 
						

							 
 
 
Please make sure the following items are included with your monitor. If any items are missing,  contact your dealer. 
Contact a local deale
rto buy optional items.   
 
 
 
 
 Unpacking 
   
 Without stand 
  
  Monito
r 
   
 With stand 
  
  Monitor & Sim
ple Stand Bottom
 
 
  
 Manual