Samsung Syncmaster 214t Quick Start Guide

							  
  
  
  
  
  
  
  
  
  
  
  
  
   
     
SyncMaster 214T
 
						

							 
 
  
Notational 
 
 
 
 
 
Failure to follow directions noted by this symbol could result in bodily\
 harm or damage to 
equipment.  
 
 
Prohibited Important to read and understand at all times 
Do not disassemble Disconnect the plug from the outlet 
Do not touch Grounding to prevent an electric shock 
 
 
 
 
 
  Power 
  
When not used for extended period of time, set your computer to DPMS.  
If using a screen saver, set it to the active screen mode.  
 
						

							 
 
 Do not use a damaged or loose plug. 
!This may cause an electric shock or fire.  
 
 
 
  Do not pull the plug out by the wire nor touch the plug with wet hands. \
!This may cause an electric shock or fire.  
 
 
 
  Use only a properly grounded plug and receptacle. 
!An improper ground may cause electric shock or equipment damage.  
 
 
 
  Insert the power plug firmly so that it does not come loose. 
!A bad connection may cause fire.  
 
 
 
  
  Do not excessively bend the plug and wire nor place heavy objects upon 
them, which could cause damage.   
!This may cause an electric shock or fire.  
 
 
 
  
  Do not connect too many extension cords or plugs to an outlet.   
!This may cause fire.  
 
 
 
 
 
  Installation  
  
  Be sure to contact an authorized  Service Center when installing your set in a 
location with heavy dust, high or low temperatures, high humidity, and 
chemical substances, or where it will be operated for 24 hours continuou\
sly 
such as an airport, train station or etc.  
 
Failure to do so may cause serious damage to your set.
 
 
Put your monitor in a location with low humidity and a minimum of dust. \
!Failure to do so may cause an electric shock or fire inside the monitor.\
  
 
						

							 
 
Do not drop the monitor when moving it. 
!This may cause damage to the product or human body.  
 
 
Install the monitor base in a showcase or shelf so that the end of the 
base does not project beyond the showcase or shelf. 
!Dropping the product may cause damage to the product or personal 
injury.  
 
 
Do not place the product on an unstable or small surface area.  
!Place the product on an even, stable surface, as the product may fall 
and cause harm to someone walking by, specifically children.  
 
 
Do not place the product on the floor.  
!Someone, specifically children could trip over it.  
 
 
Keep any flammable objects such as candles, insecticides or cigarettes 
away from the product. 
!Otherwise, this may cause a fire.  
 
 
Keep any heating devices away from the power cable. 
!A melted coating may lead to electric shock or fire.  
 
 
Do not install the product in places with poor ventilation, for instance\
, a 
bookshelf, closet, etc. 
!Any increase in internal temperature may cause fire.  
 
 
Set down the monitor carefully. 
!The monitor could be damaged or broken.  
 
 
						

							 
Do not place the monitor face down. 
!The TFT-LCD surface may be damaged.  
 
 
Installing a wall bracket must be  done by a qualified professional. 
!Installation by unqualified personnel may result in injury.  
!Always use the mounting device specified in the owners manual.  
 
 
When installing the product, make sure to keep it away from the wall  
(more than 10cm/4inch ) for ventilation purposes.  
!Poor ventilation may cause an increase in the internal temperature of 
the product, resulting in a shortened component life and degraded 
performance.  
 
 
 
 
 
  Clean  
  
When cleaning the monitor case or the surface of the TFT-LCD screen, wipe with 
a slightly moistened, soft fabric. 
 
 
Do not spray water or detergent directly on the monitor. 
!This may cause damage, electric shock or fire.  
 
 
Use the recommended detergent with a smooth cloth.   
 
 
If the connector between the plug and the pin is dusty or dirty, clean i\
t 
properly with a dry cloth. 
!A dirty connector may cause an electric shock or fire.  
 
 
Make sure to unplug the power cord before cleaning the product. 
!Otherwise, this may cause electric shock or fire.  
 
						

							 
 
Unplug the power cord from the power outlet and wipe the product using 
a soft, dry cloth. 
!Do not use any chemicals such as wax, benzene, alcohol, thinners, 
insecticide, air freshener, lubricant or detergent.  
 
 
Contact the  Service Center  or Customer Center for interior cleaning 
once a year. 
!Keep the products interior clean. Dust which has accumulated in the 
interior over an extended period of time may cause malfunction or fire. \
 
 
 
 
 
 
  Others  
  
Do not remove cover (or back). 
!This may cause an electric shock or fire.  
!Refer servicing to qualified service personnel.  
 
 
If your monitor does not operate normally - in particular, if there are \
any 
unusual sounds or smells coming from it - unplug it immediately and 
contact an authorized dealer or service center.   
!This may cause an electric shock or fire.  
 
 
Keep the product away from places exposed to oil, smoke or moisture; 
do not install inside a vehicle.  
!This may cause malfunction, an electric shock or fire.  
!Especially avoid operating the monitor near water or outdoors where the \
monitor could be exposed to snow or rain.  
 
 
If the monitor is dropped or the casing is damaged, turn the monitor off\
 
and unplug the power cord. Then contact the  Service Center. 
!The monitor may malfunction, causing an electric shock or fire.  
 
 
 
						

							 
 
Do not try to move the monitor by pulling only the wire or the signal 
cable. 
!This may cause a breakdown, electric shock or fire due to damage to 
the cable.  
 
 
Do not move the monitor right or left by pulling only the wire or the 
signal cable. 
!This may cause a breakdown, electric shock or fire due to damage to 
the cable.  
 
 
Do not cover the vents on the monitor cabinet. 
!Bad ventilation may cause a breakdown or fire.  
 
 
Do not place water containers, chemical products or small metal objects \
on the monitor. 
!This may cause malfunction, an electric shock or fire.  
!If a foreign substance enters the monitor, unplug the power cord and 
contact the  Service Center  .  
 
 
Keep the product away from combustible chemical sprays or 
inflammable substances.  
!This may cause an explosion or fire.  
 
 
Never insert anything metallic into the monitor openings.   
!This may cause an electric shock, fire or injury.  
 
 
Do not insert metal objects such as chopsticks, wire and gimlet or 
inflammable objects such as paper and match into the vent, headphone 
port or AV ports. 
!It may cause a fire or an electric shock. If an alien substances or wate\
r 
flows into the product, turn the product off, unplug the power connector\
 
from the wall outlet and contact  Service Center.  
 
 
Disconnect the plug from the outlet duri ng storms or lightening or if it is 
not used for a long period of time. 
!Failure to do so may cause an electric shock or fire.  
 
						

							 
 
Adjust the resolution and frequency to the levels appropriate for the 
model. 
!Inappropriate resolution may cause undesirable picture quality.  
 20 inch - 1600 X 1200 @60 Hz
 
 
Watching the monitor continuously at a too close angle may result in 
eyesight damage. 
 
 
To ease eye strain, take at least a five-minute break after every hour o\
f 
using the monitor . 
 
 
Do not install the product on an unstable, uneven surface or a location \
prone to vibrations.  
!Dropping the product may cause damage to the product or personal 
injury. Using the product in a location prone to vibrations may shorten \
the lifetime of the product or may catch fire.  
 
 
When moving the monitor, turn off and unplug the power cord.  
Make sure that all cables, including the antenna cable and cables 
connected to other devices, are disconnected before moving the 
monitor. 
!Failure to disconnect a cable may damage it and lead to fire or an 
electric shock.  
 
 
Place the product out of childrens reach, as they could damage it by 
hanging onto it. 
!A falling product could cause physical damage even death.  
 
 
When not using the product for an extended time period, keep the 
product unplugged 
!Otherwise, this may cause heat emission from the accumulated dirt or 
degraded insulation, leading to electric shock or fire.  
 
 
Do not place childrens favorite objects (or anything else that may be \
tempting) on the product.  
!Children may try to climb on the product to retrieve an object. The 
product could fall, causing physical damage or even death.  
 
If you view a fixed screen for an extended period of time, residual imag\
e 
or blurriness may appear. 
!Change the mode to energy save or set a screensaver to moving picture 
when you need to be away from the monitor for an extended period of 
time.  
 
						

							HAS Stand : Height Adjustable & Pivot Stand (214T : 100mm)
PIP/PBP : Uses MagicTune to adjust  PIP for the best viewing position
Adopts MagicColor Pro to make adjustments of  a variety of colors at an expert level
Color Weakness : Enables those with color weakne ss to view the screen as easily as those 
with normal vision. 
Auto Rotation applied (Imp lemented by MagicRotation)
SyncMaster 214T 
 
 
Please make sure the following items  are included with your monitor. 
If any items are missing,  contact your dealer.  
Contact a local dealer to bu
y optional items.
 
 
 
 Unpacking 
  
  Monitor
 
 
    Manual  
 
 
						

							 Quick Setup Guide Warranty Card
 
(Not available in all locations) Users Guide, Monitor Driver, 
Natural Color, MagicTune™, 
Ma
gicRotation software 
     Cable
  
D-sub Cable  Power Cord  DVI Cable
 
   Sold separately
Set-Bracket Screws (4EA) 
 
 
 
 Front