Samsung LCD TV Ltn406w User Manual

English-54
OPERATION
Setting the Sleep Timer 
Set the timer for the TV to turn off at the preset time automatically.   
1
Press the MENUbutton
to display the on-
screen menu.
Press the DOWN
button three times to
select “Setup”, then
press the ENTER
button.
3
Press theENTERbutton. Press theUP/DOWNbuttons repeatedly until
the correct time appears.
2
Press the DOWN
button to select
“Sleep”, then press the 
ENTERbutton.
Setting the On/Off  Timer Using the Menu 
•Easy Way to Set the Sleep Timer
Press the...

English-55
Using the V-Chip
The V-Chip feature automatically locks out programming that is deemed inappropriate for
children. The user must first enter a Pin (personal ID number) before any of the V-Chip
restrictions can be set up or changed. 
Setting Up Your Personal ID Number (Pin)
1
Press the MENUbutton
to display the menu.
Press the DOWN
button to select 
“Setup”, then press the
ENTERbutton.
2Press the DOWN
buttons to select
“V-Chip”, then press
the ENTERbutton.
3After entering a valid
Pin number,...

English-56 How to Set up Restrictions Using the “TV guidelines”
First, set up a personal identification number (Pin), and enable the V-Chip.
(See previous section.) Parental restrictions can be set up using either of two methods:
The TV guidelines or the MPAA rating.
How to Enable/Disable the V-Chip
Note: V-Chip cannot be used during PIP operation.
1
Press the MENUbutton
to display the menu.
Press the DOWN
button to select 
“Setup”, then press the
ENTERbutton.
2
Press the DOWN
button to select 
“V-Chip”,...

English-57
2
Press the DOWN
button to select 
“V-Chip”, then press
the ENTERbutton.
The “Enter Pin” screen
will appear. Enter your
4-digit Pin number. 
3
Press the DOWN
button, to select “TV
Guidelines”, then press
the ENTERbutton.
4
The “TV guidelines”
screen will appear.
Press the the UP/DOWN
buttons to select
one of the six age-based
categories:
TV-Y Young children
TV-Y7 Children 7 and over
--------------------------------------
TV-G General audience
TV-PG Parental guidance
TV-14 Viewers 14 and over...

English-58 How to Set up Restrictions using the MPAA Ratings: G, PG, 
PG-13, R, NC-17, X
The MPAA rating system uses the Motion Picture Association of America (MPAA) system,
and its main application is for movies. (Eventually, movie videocassettes will be encoded
with MPAA ratings.) When the V-Chip lock is on, the TV will automatically block any 
programs that are coded with objectionable ratings (either MPAA or TV-Ratings).
6
How to set the FV, D, L, S and V sub-ratings.
First, highlight one of these...

English-59 How to Reset the TV after the V-Chip
Blocks a Channel (“Emergency Escape”)
If the TV is tuned to a restricted channel, the V-Chip will block it. The screen will go blank and
the following message will appear: “Excessive rating”.
To resume normal viewing, tune to a different channel using the number buttons. Under certain
conditions (depending on the rating of the local TV programs) the V-Chip might lock out all the
channels.
In this case, use the Menu button for an “emergency escape”:
Select...

English-60
Chapter Five
PC DISPLAY
Using Your TV as a Computer (PC) Display
How to Set up Your PC Software (Windows only)
The Windows display-settings for a typical computer are shown below. However, the 
actual screens on your PC will probably look different, depending upon your particular
version of Windows and your particular video card. Even if your actual screens look 
different, the same, basic set-up information will apply in most cases.
(If not, contact your computer manufacturer or Samsung...

English-61 Adjusting the Screen Quality
The purpose of the picture quality adjustment is to remove or reduce picture noise. If
the noise is not removed by fine tuning alone, then do the frequency adjustments to the
utmost and fine tune again. After the noise has been reduced, re-adjust the picture so
that it is aligned on the center of screen.
Press the PC button on the remote control to select the PC mode.
1
Press the MENUbutton
to display the menu.
Press the DOWN
button to select
“Setup”, then press...

English-62 Changing the Screen Position
Press the PC button on the remote control to select the PC mode.
1
Press the MENUbutton
to display the menu.
Press the DOWN
button to select
“Setup”, then press the 
ENTERbutton.
2
Press the DOWN
button to select 
“Position”, then press
the ENTERbutton. 
3Press the
UP/DOWN
buttons to adjusting the
V-Position. 
Press the
LEFT/RIGHT
buttons to adjusting the
H-Position.
Press the MENUbutton
to exit.
PC DISPLAY
 venus-05-en  6/3/03 3:09 PM  Page 62 

English-63 To Initialize the Screen Settings  
Use to return the screen settings to the default values.  
1
Press the MENUbutton
to display the menu.
Press the DOWN
button to select
“Setup”, then press the 
ENTERbutton.
2
Press the DOWN
button to select 
“Image Reset”, then
press the ENTER
button. 
3Press the MENUbutton
to exit.
PC DISPLAY
 venus-05-en  6/3/03 3:09 PM  Page 63