Samsung Ht Ds100 Instruction Manual

PREPARATION
10
Subwoofer
Subwoofer Level
control
Crossover frequency
control
DIN Audio Input terminal 
Speaker Output Terminals 
Subwoofer Power button
< Front > < Right >
< Rear >< Rear >
Subwoofer Level control
Subwoofer Power button
DIN Audio Input terminal 
Crossover frequency control
Speaker Output Terminals 
PSWS1000T (Subwoofer of HT-DS1000)
PSWS1100T (Subwoofer of HT-DS1100)
 1p~44p(DS1000)-GB  9/16/04 9:14 AM  Page 13
 

11
Description
TVDVD RECEIVER
OPEN/CLOSE
DVD TUNER AUX
EZ VIEW
NTSC/PALSLOW SUB TITLE ASC
TUNING/CH
PL II
RETURN
M
EN
UINFO
MUTE
MODE
ENTER
SOUND EDITTEST TONE
SLEEP
LOGO REPEATCANCEL ZOOM
REMAIN
TUNER 
MEMORY
DCDi
PL II
EFFECT
VOLUMELSM
V-H/PMOVIE MUSIC SUPER5.1MO/ST TV/VIDEO
MODEDIMMER
RDS DISPLAY
PTY– PTY+PTY SEARCHTA
PL II MODE button
VOLUME button
MENU button TV, DVD POWER button
OPEN/CLOSE button
SUPER 5.1 button
Live Surround Mode button/
Virtual Headphone button Auto Sound Calibration button...

To open the remote control cover, push the
top of the cover, then slide downward.
12
Insert Remote Batteries
The remote control can be used up to approximately 23
feet/7 meters in a straight line. It can also be operated at
a horizontal angle of up to 30° from the remote control
sensor.
Range of Operation of the Remote Control 
Remove the battery
cover on the back
of the remote by
pressing down and
sliding the cover in
the direction of the
arrow.1Insert two 1.5V AAA
batteries, paying
attention to the...

13
Installing DVD player 
You can select and install either the Vertical or Horizontal Stand, depending on your preference.
REAR OF
VERTICAL STAND REAR OF MAIN UNIT Main unit
Main unitVertical Stand
Horizontal Stand Round support
Vertical Stand (supplied)
2
1
Fix the round support and Vertical
Stand with screws 3EA.
3
Locate the two indentations on the bottom
of the Main unit. Slide the Main unit onto
the two matching dowels on Vertical Stand.
4
Fix the Vertical Stand and the main
unit with screws 4EA....

14
CONNECTIONS
RSLS
C
LSWR
Rear Speakers
•Place these speakers behind your listening position.
•If there isnt enough room, place these speakers to face each other.
•Place them about 60 to 90cm (2 to 3feet) above your ear, facing
slightly downward.
*Unlike the front and center speakers, the rear speakers are used
to handle mainly sound effects and sound will not come from
them all the time.
Subwoofer
•The position of the subwoofer is not so critical. 
Place it anywhere you like.
•Usually, it is placed by...

15
Connecting the Speakers
Connect the front, rear and center speakers to the speaker output jack on the side of subwoofer.
Bottom of Main unit
(HT-DS1000)Rear of Subwoofer (PSWS1000E)
Center Speaker
Green
Gray
RedBlue
White
Rear Speaker (L)  Rear Speaker (R) 
Front Speaker (L) Front Speaker (R) 
Subwoofer: The subwoofer is active,  with a built-in a  150W amplifier,  and
outputs rich bass through 8 inch speaker units. You can listen to
the optimal LFE (bass) by using the subwoofer-only volume
control...

Bottom of Main unit
(HT-DS1100)Rear of Subwoofer (PSWS1100E)
Center Speaker
Rear Speaker (L)  Rear Speaker (R) 
Front Speaker (L) Front Speaker (R) 
16
CONNECTIONS
HT-DS1100
Green
Blue
White RedGray
Connecting the Speakers
Black
Press down the terminal
tab on the back of the
speaker.1Insert the black wire into the
black terminal (–) and the gray
wire into the gray (+) terminal,
and then release the tab.2Connect the correct color speaker cable
to the same color speaker output terminal
on the rear of the...

Better Quality
Good Quality
Connecting the Video Out to TV
17
The Component input may be marked ‘DVD input’
depending on the TV. 
•If the TV only supports a resolution of 576i(480i), the screen may be divided into 2 screens, or
display nothing.Note
Connect if the TV component input supports the resolution of over 576p(480p).
Connect the Video Out to the Video
In on the TV.1
Set the Video Input source on your TV
to the corresponding Video output on
your Home Theater.2
Method1When you connect to Video Out...

Best Quality
18
CONNECTIONS
Connect if the TV has an HDMI (or DVI) In jack.
Connect the HDMI Out to the HDMI 
(or DVI) Input on the TV. 1
Set the Video Input source on your TV
to the corresponding HDMI output on
your Home Theater.2
Method 3When you connect to HDMI Out
• If you connect the HDMI and Component outputs (PR, PB, Y) at the same time, the Component output
resolution changes automatically to the designated HDMI resolution.
Example: If the TV connected to HDMI can only support up to 576p(480p),...

Connecting the Video Out to TV
You can adjust the resolution switch to set the HDMI and component (PR, PB, Y) output resolution to
576p(480p)/720p/1080i.
Example: If the TV supports resolution up to 576p(480p) 
•If you connect the HDMI and Component outputs (PR, PB, Y) at the same
time, Component output resolution changes automatically to the
designated HDMI resolution. 
Caution
Selecting Resolution
Set the resolution switch to 576p(480p).
•A576p(480p) video signal is output through the HDMI and...