Samsung Ht Db760 Instruction Manual

To open the remote control cover, push the
top of the cover, then slide downward.
10
Insert Remote Batteries
The remote control can be used up to approximately 23
feet/7 meters in a straight line. It can also be operated at
a horizontal angle of up to 30°from the remote control
sensor.
Range of Operation of the Remote Control 
Remove the battery
cover on the back of
the remote by
pressing down and
sliding the cover in
the direction of the
arrow.1Insert two 1.5V AAA
batteries, paying
attention to the...

11
Connecting the Speakers
Before moving or installing the product, be sure to turn off the power and disconnect the power cord.
Subwoofer
•The position of the subwoofer is not so critical. 
Place it anywhere you like.
•Usually, it is placed by a corner near the front speakers.
Front/Rear Speakers  
•Place these speakers in front of your listening
position, facing inwards (about 45°) toward you.
•Place the speakers so that their tweeters will be at
the same height as your ear.
•Align the front face of...

12
CONNECTIONS
Front/Rear Speaker (L)
Blue
Gray RedGreen
White
PurpleCenter Speaker
SubwooferFront/Rear Speaker (R)
Back of the Main Unit
Black
Press down the terminal
tab on the back of the
speaker.1Insert the black wire into the
back terminal (–) and the gray
wire into the gray (+) terminal,
and then release the tab.2Connect the wires to the output jacks of
the same color on the back of the main
unit, making sure that the polarity (+/–)
is correct.
Example: Connect the center speakers green
wire to the...

Mounting the Speakers to a Wall
1
Attach the wall bracket holders (A) to the wall and fasten the holder
screws (B) as shown in the illustration.
• For an optimal sound field, the distance between the speakers should be 40 inches, and each
speaker should be at least 20 inches away from the side wall.
2
Check the left and right speakers, fasten the speaker to the bracket (C)
using the fixing screw (D), and then insert the bracket into the holder as
shown in the illustration. (Insert the speaker cords...

14
Connecting the Video to TV
Composite Video (Good Quality)
Connect the supplied video cable from the VIDEO OUT jack on the back panel of the
system to the VIDEO IN jack on your television.
Scart (Best Quality)
If you television is equipped with an SCART input, connect an Scart Jack (not supplied) from
the AV OUT jack on the back panel of the system to the SCART IN jack on your television.
SCART
INVIDEO
IN
TV
•On the rear panel SCART cable is indicated as “AV OUT.” Note
CONNECTIONS
For using the SCART...

Connecting the Antennas
15
Connect the FM antenna supplied to the FM 75ΩCOAXIAL terminal as a
temporary measure.
Slowly move the antenna wire around until you find a location where reception
is good, then fasten it to a wall or other rigid surface.
• If reception is poor, connect an outdoor antenna.
Before attaching a 75Ωcoaxial cable (with a standard
type connector), disconnect the supplied FM antenna.
FM antenna connection
1
2
FM Antenna (supplied)
 1p~32p(DB760)-GB  1/3/04 4:38 PM  Page 18
 

The cooling fan dissipates the heat generated inside the unit so that the unit can be operated
normally. The cooling fan is activated automatically to supply cool air to the unit.
Please observe the following cautions for your safety.
•Make sure the unit is well-ventilated. If the unit has poor ventilation, the temperature inside the unit could rise
and may damage it.
•Do not obstruct the cooling fan or ventilation holes. (If the cooling fan or ventilation holes are covered with a
newspaper or cloth,...

17
Press AUXon the remote control to select ‘DIGITAL IN’.
•Each time the button is pressed, the selection changes as follows: DIGITAL IN➝ AUX 1➝ AUX 2.
•You can also use the FUNCTIONbutton on the main unit.
The mode switches as follows: DVD/CD➝ DIGITAL IN➝ AUX1➝ AUX2➝ FM➝ MW➝ LW.
Connecting External Components
Connect the Digital Input (OPTICAL) to the Digital Output on the external
digital component.1
2
DIGITAL OUT
Example: Digital signal components such as a DVD or CD Recorder.
Connecting an External...

Press AUXon the remote control to select AUX 1 or AUX 2.
•Each time the button is pressed, the selection changes as follows: DIGITAL IN➝ AUX 1➝ AUX 2.
•You can also use the FUNCTIONbutton on the main unit.
The mode switches as follows: DVD/CD➝ DIGITAL IN➝ AUX1➝ AUX2➝ FM➝ MW➝ LW.
Connect Audio In on the DVD player to Audio Out on the external analog component.
•Be sure to match connector colors.
1
2
LR
18
Example: Analog signal components such as a VCR, Camcorder, and TV.
Connecting an External Analog...

•Each time the button is pressed, the TV indicator (red) and
the DVD Receiver indicator (green) will flash alternately.
•You can operate the TV while the TV indicator is flashing
and the DVD player while the DVD indicator is flashing.
•Buttons Enabled for TV Operation: POWER, CHANNEL,
VOLUME, TV/VIDEO, and Numeric (0-9) buttons.
•By default, the remote control is set to work with Samsung
TVs. See page 65 for more information on the operation of
the remote control.
Press MODEbutton.
To Operate the TV and...