Samsung Ht Db760 Instruction Manual

							To open the remote control cover, push the
top of the cover, then slide downward.
10
Insert Remote Batteries
The remote control can be used up to approximately 23
feet/7 meters in a straight line. It can also be operated at
a horizontal angle of up to 30°from the remote control
sensor.
Range of Operation of the Remote Control 
Remove the battery
cover on the back of
the remote by
pressing down and
sliding the cover in
the direction of the
arrow.1Insert two 1.5V AAA
batteries, paying
attention to the correct
polarities (+ and –).2Replace the battery
cover.3
Follow these precautions to avoid leaking or cracking cells:
•Place batteries in the remote control so they match the polarity:(+) to (+)and (–)to (–).
•Use the correct type of batteries.Batteries that look similar may differ in voltage.
•Always replace both batteries at the same time.
•Do not expose batteries to heat or flame.
Caution
PREPARATION
 1p~32p(DB760)-GB  1/3/04 4:38 PM  Page 13
 
						

							11
Connecting the Speakers
Before moving or installing the product, be sure to turn off the power and disconnect the power cord.
Subwoofer
•The position of the subwoofer is not so critical. 
Place it anywhere you like.
•Usually, it is placed by a corner near the front speakers.
Front/Rear Speakers  
•Place these speakers in front of your listening
position, facing inwards (about 45°) toward you.
•Place the speakers so that their tweeters will be at
the same height as your ear.
•Align the front face of the front speakers with the
front face of the center speaker or place them
slightly in front of the center speakers.
Center Speaker
•It is best to install it at the same height as the front
speakers.
•You can also install it directly over or under the TV.
Position of the DVD Player
•Place it on a stand or cabinet shelf, or under
the TV stand.
Selecting the Listening Position
The listening position should be located about 2.5 to 3
times the distance of the TVs screen size away from the
TV. Example: For 32 TVs 2~2.4m (6~8feet)
For 55 TVs 3.5~4m (11~13feet)
RL
C
SW
 1p~32p(DB760)-GB  1/3/04 4:38 PM  Page 14
 
						

							12
CONNECTIONS
Front/Rear Speaker (L)
Blue
Gray RedGreen
White
PurpleCenter Speaker
SubwooferFront/Rear Speaker (R)
Back of the Main Unit
Black
Press down the terminal
tab on the back of the
speaker.1Insert the black wire into the
back terminal (–) and the gray
wire into the gray (+) terminal,
and then release the tab.2Connect the wires to the output jacks of
the same color on the back of the main
unit, making sure that the polarity (+/–)
is correct.
Example: Connect the center speakers green
wire to the center speaker output jack
(green) on the back of the main unit.
3
Gray
Back of the SpeakerBack of the Main Unit
•Connect the front/rear, center, and subwoofer speakers to the speaker terminals on the back of the main unit.
•Do not let children play with the speakers. 
They could get hurt if a speaker falls.
•When connecting the speaker wires to the speakers,
make sure that the polarity (+/–) is correct.
•Never touch the speaker terminal while the power is on.
Doing so may result in a risk of electric shock.
Caution
•If you place a speaker near your TV set,
screen color may be distorted because of
the magnetic field generated by the
speaker. In this case, place the speaker
away from your TV set.
Note
 1p~32p(DB760)-GB  1/3/04 4:38 PM  Page 15
 
						

							Mounting the Speakers to a Wall
1
Attach the wall bracket holders (A) to the wall and fasten the holder
screws (B) as shown in the illustration.
• For an optimal sound field, the distance between the speakers should be 40 inches, and each
speaker should be at least 20 inches away from the side wall.
2
Check the left and right speakers, fasten the speaker to the bracket (C)
using the fixing screw (D), and then insert the bracket into the holder as
shown in the illustration. (Insert the speaker cords before inserting the
bracket into the holder.)
3
Complete the speaker setup as shown in the illustration.
B
A
T V
T V
D
C
Left Speaker
Right Speaker
• If the wall is concrete, purchase and use anchor bolts.
13
 1p~32p(DB760)-GB  1/3/04 4:38 PM  Page 16
 
						

							14
Connecting the Video to TV
Composite Video (Good Quality)
Connect the supplied video cable from the VIDEO OUT jack on the back panel of the
system to the VIDEO IN jack on your television.
Scart (Best Quality)
If you television is equipped with an SCART input, connect an Scart Jack (not supplied) from
the AV OUT jack on the back panel of the system to the SCART IN jack on your television.
SCART
INVIDEO
IN
TV
•On the rear panel SCART cable is indicated as “AV OUT.” Note
CONNECTIONS
For using the SCART cable
• If Scart is equipped for your TV, set RGB-COMPOSITE selector of
the center unit to RGB. You can get a better picture quality by
using Scart setting.
• If Scart (RGB Input) is not equipped for your TV, set RGB-
COMPOSITE selector to COMPOSITE.
COMPOSITE RGB
COMPOSITE
RGB
 1p~32p(DB760)-GB  1/3/04 4:38 PM  Page 17
 
						

							Connecting the Antennas
15
Connect the FM antenna supplied to the FM 75ΩCOAXIAL terminal as a
temporary measure.
Slowly move the antenna wire around until you find a location where reception
is good, then fasten it to a wall or other rigid surface.
• If reception is poor, connect an outdoor antenna.
Before attaching a 75Ωcoaxial cable (with a standard
type connector), disconnect the supplied FM antenna.
FM antenna connection
1
2
FM Antenna (supplied)
 1p~32p(DB760)-GB  1/3/04 4:38 PM  Page 18
 
						

							The cooling fan dissipates the heat generated inside the unit so that the unit can be operated
normally. The cooling fan is activated automatically to supply cool air to the unit.
Please observe the following cautions for your safety.
•Make sure the unit is well-ventilated. If the unit has poor ventilation, the temperature inside the unit could rise
and may damage it.
•Do not obstruct the cooling fan or ventilation holes. (If the cooling fan or ventilation holes are covered with a
newspaper or cloth, heat may build up inside the unit and fire may result.)
Cooling Fan
16
CONNECTIONS
Connect the AM loop antenna supplied to the AM and       terminals.
If reception is poor, connect an outdoor single vinyl-covered wire to the AM
terminal. (Keep the AM loop antenna connected).
AM(MW/LW) antenna connection
123
1
2
Snap the tabs on the loop into the
slots of the base to assemble the
AM loop antenna.AM Loop Antenna 
(supplied) If AM reception is poor, connect an outdoor AM
antenna(not supplied).
 1p~32p(DB760)-GB  1/3/04 4:38 PM  Page 19
 
						

							17
Press AUXon the remote control to select ‘DIGITAL IN’.
•Each time the button is pressed, the selection changes as follows: DIGITAL IN➝ AUX 1➝ AUX 2.
•You can also use the FUNCTIONbutton on the main unit.
The mode switches as follows: DVD/CD➝ DIGITAL IN➝ AUX1➝ AUX2➝ FM➝ MW➝ LW.
Connecting External Components
Connect the Digital Input (OPTICAL) to the Digital Output on the external
digital component.1
2
DIGITAL OUT
Example: Digital signal components such as a DVD or CD Recorder.
Connecting an External Digital Component
Optical Cable
(not included)
 1p~32p(DB760)-GB  1/3/04 4:38 PM  Page 20
 
						

							Press AUXon the remote control to select AUX 1 or AUX 2.
•Each time the button is pressed, the selection changes as follows: DIGITAL IN➝ AUX 1➝ AUX 2.
•You can also use the FUNCTIONbutton on the main unit.
The mode switches as follows: DVD/CD➝ DIGITAL IN➝ AUX1➝ AUX2➝ FM➝ MW➝ LW.
Connect Audio In on the DVD player to Audio Out on the external analog component.
•Be sure to match connector colors.
1
2
LR
18
Example: Analog signal components such as a VCR, Camcorder, and TV.
Connecting an External Analog Component
Audio CableIf the external
analog component
has only one Audio
Out, connect either
left or right.
CONNECTIONS
 1p~32p(DB760)-GB  1/3/04 4:38 PM  Page 21
 
						

							•Each time the button is pressed, the TV indicator (red) and
the DVD Receiver indicator (green) will flash alternately.
•You can operate the TV while the TV indicator is flashing
and the DVD player while the DVD indicator is flashing.
•Buttons Enabled for TV Operation: POWER, CHANNEL,
VOLUME, TV/VIDEO, and Numeric (0-9) buttons.
•By default, the remote control is set to work with Samsung
TVs. See page 65 for more information on the operation of
the remote control.
Press MODEbutton.
To Operate the TV and DVD Player
with a Single Remote Control
23
Press the MODE
button so that the
TV indicator on
the remote
control flashes.
TVDVD RECEIVER
TVDVD RECEIVER
Press the
POWERbutton to
turn on the TV.
56
Press the MODE
button so that the
DVD RECEIVER
indicator on the
remote control
flashes.
Press DVD
button to select
DVD/CD mode.
19
Before Using Your DVD Player
Your DVD player is capable of playing DVD, VCD, CD, MP3 and JPEG discs.Depending on the disc
you are using, these instructions may vary slightly. Read the instructions carefully before using.
•By default, the video format is set to PAL.
•Each time the button is pressed, the video format
switches between NTSC and PAL.
•Each country has a different video format standard. 
•For normal playback, the video format of the disc must
be the same as the video format of your TV. 
Turn off the main unit and then press NTSC/PAL.
Selecting the Video Format
1
Plug the power
cord into the AC
power supply.
4
Press TV/VIDEO
button to select
VIDEO mode.
 1p~32p(DB760)-GB  1/3/04 4:38 PM  Page 22