Ryobi Bt31001 Manual

							Page 51
The model number will be found on the data plate attached to the right side panel of the cabinet, next to the saw’s on board receptacle. Always
mention the model number in all correspondence regarding your TABLE SAW or when ordering repair parts.
RYOBI 10 in. (254 mm) TABLE SAW – MODEL NO. BT3100-1
PARTS LIST FOR FIGURE 64
KEY
NO. DESCRIPTIONQUAN.
1Leveling Foot............................................................................................................................................................................  4
2Hex Nut.................................................................................................................................................................................... 32
3Washer.................................................................................................................................................................................... 32
4Carriage Bolt............................................................................................................................................................................ 24
5Leg............................................................................................................................................................................................. 4
6Upper Brace.............................................................................................................................................................................. 2
7Screw........................................................................................................................................................................................  4
8Hex Nut...................................................................................................................................................................................... 8
9Upper Side Brace...................................................................................................................................................................... 2
10 Lower Leg Brace....................................................................................................................................................................... 4
11Storage Bracket......................................................................................................................................................................... 4
12 Washer.................................................................................................................................................................................... 12
13 Bolt............................................................................................................................................................................................ 4
Stand Fastener Package........................................................................................................................................................... 1
Operator’s Manual 
						

							
Page 43
983000-232
     11-04
RYOBI TECHNOLOGIES, INC.
1428 Pearman Dairy Road Anderson, SC 29625
Post Office Box 1207 Anderson SC 29622-1207
Phone 1-800-525-2579
www.ryobitools.com
OPERATORS MANUAL
10 in. (254 mm) Table Saw
Model BT3100-1
• SERVICE
Now that you have purchased your tool, should a need ever exist for repa\
ir parts or
service, simply contact your nearest Ryobi Authorized Service Center. Be\
 sure to
provide all pertinent facts when you call or visit. Please call 1-800-52\
5-2579 for your
nearest Ryobi Authorized Service Center. You can also check our web site\
 at
www.ryobitools.com for a complete list of Authorized Service Centers.
•MODEL NO.
The model and serial numbers of your tool will be found on the data plat\
e attached to the
tool. Please record the serial number in the space provided below.
•MODEL NUMBER BT3100-1
• SERIAL NUMBER
**Ampere rating
    (on tool data plate)0-2.0 2.1-3.4 3.5-5.0 5.1-7.0 7.1-12.0 12.1-16.0
Cord Length Wire Size (A.W.G.)
25' 16 16 16 16 14 14
50' 16 16 16 14 14 12
100' 16 16 14 12 10 —
CAUTION:  Keep the extension cord clear of the working
area. Position the cord so that it will not get caught on workpiece,
tools, or other obstructions while you are working with a power
tool.
**Used on 12 gauge - 20 amp circuit.
EXTENSION CORD CAUTION
When using a power tool at a considerable distance from a power
source, be sure to use an extension cord that has the capacity to
handle the current the tool will draw. An undersized cord will cause
a drop in line voltage, resulting in overheating and loss of power.
Use the chart to determine the minimum wire size required in an
extension cord. Only round jacketed cords should be used.
When working with a tool outdoors, use an extension cord that is
designed for outside use. This is indicated by the letters "WA" on
the cord's jacket.
Before using any extension cord, inspect it for loose or exposed
wires and cut or worn insulation.