Remington SPR 210, SPR 220 Instruction Manual

							Choke Tubes
WARNING
Never install or remove choke tubes while the firearm is loaded. Only install or remove choke tubes with the firearm unloaded, the action open
and the trigger block safely engaged.
Screw in Chokes Symbols/Markings
(This is an option – not all Model 100 shotguns have this feature)
The end of the choke tubes are marked with slashes to identify the choke construction:
/  Full
//  Improved Modified
///  Modified
////  Improved Cylinder
CI  Cylinder
WARNING
MAKE SURE YOU FULLY TIGHTEN THE CHOKE TUBE.
Shooting with a loose choke tube can cause damage to your shotgun.
Additional Information On Screw Choke Tubes:
A.Only tighten or loosen choke tubes with flat key wrench supplied with shotgun. Note: wrench (and extra
choke tube or tubes if supplied) are under the cardboard in front of the shotgun receiver in the box.
B.Never shoot the shotgun with a partially installed choke tube.
C.Model 100 shotguns are available with fixed choke or screw choke barrels. There are two types of screw
chokes available: lead shot choke tubes and steel shot choke tubes. When installed, steel shot choke
tubes protrude approximately 
3/4” from the muzzle end of the barrel and the mating lip will be flush with
the end of the barrel. When installed, lead shot choke tubes fit flush with or slightly below the muzzle end
of  the
barrel. If you have lead shot choke tubes and intend to shoot steel shot cartridges or slugs, then you must
use only the IC or Cylinder tubes. DO NOT fire steel shot or slugs in Modified, Improved Modified or Full
lead shot choke tubes. If you have steel shot choke tubes, you may fire steel shot cartridges through any
of those choke tubes. DO NOT fire slugs in Modified, Improved Modified or Full lead shot choke tubes or
steel shot choke tubes.
D. Correctly installed choke tubes: Lead shot choke tubes should fit flush or slightly below the muzzle end
of the barrel. Steel shot choke tubes will protrude out from the barrel about 
3/4” and the mating lip will be
flush with barrel end.
E.Before using the shotgun make sure that the choke tubes are installed correctly.
F. Keep choke tubes lubricated and installed. Never fire the gun without a choke tube installed. Handle choke
tubes carefully since the leading edge is very thin.
21 
						

							23
22
Notes on Shot Material and Chokes:
1. Shells using Bismuth or TungstenMatrix shot are subject to the same barrel and choke tube limitations
as lead shot. Shells using TungstenIron shot or HeviShot are subject to the same barrel and choke tube
limitations as steel shot.
2. On fixed choke guns, shells loaded with steel, TungstenIron or HeviShot should be fired only in
IC or Cylinder barrels. DO NOT fire steel, TungstenIron or HeviShot shells in fixed barrels with
Modified, Improved Modified or Full choke barrels. Lead, Bismuth and TungstenMatrix may be fired in
all fixed choke barrels.
3. On fixed choke guns, slugs may be fired in only IC and Cylinder barrels. DO NOT fire slugs in fixed choke
barrels with Modified, Improved Modified or Full chokes.
If you would like to buy extra choke tubes (skeet, trap, extra full, etc.) call (321)6391432. 
						

							23
WARNING
Children are attracted to and can operate
firearms that can cause severe injuries or
death.  Prevent child access by always keeping guns locked
away and unloaded when not in use. If you keep a loaded
firearm where a child obtains and improperly uses it, you
may be fined or sent to prison.
ADVERTENCIA
A los ninos los atroen las armaside de fuego y
los pueden hacer funcionar. Ellos pueden
causarses lesiones graves y la muerte.  Evite que los ninos
tengon acceso a los armas de fuego guardandolas siempre
con llave y descargadas cuando no las este utilizando. Si
usted tiene un arma de fuego cargado en un lugar en que
un nono tiene acceso a ella y la usa indebidamente.
Le pueden dar una multa a enviarlo a la carcel.
REMINGTON I.S.P.
c/o USSG
402 Richard Road
Rockledge, FL 32955
Manufacturer:
Izhevsky Mekhanichesky Zavod
8, Promyshlennaya str.,
426063 Izhevsk, Russia 
						

							Remington is a trademark registered in the United States Patent and Trademark Office by Remington Arms Company, Inc.