Remington SPR 210, SPR 220 Instruction Manual

1
Ow ner
’s
Manual
Ow ner
’s
Manual
Owner’s Manual for: Owner’s Manual for:
Remington Model SPR 210 and SPR 220
SideBySide Shotguns
PAGE 2 ........THE TEN COMMANDMENTS OF FIREARM SAFETY
PAGE 7 ........IMPORTANT PARTS OF THE FIREARM 
PAGE 10........ASSEMBLY INSTRUCTIONSPAGE 11........LOADING AND UNLOADING
PAGE 13
......FIRING
PAGE 15
......DISASSEMBLY INSTRUCTIONS
Remington Model SPR 210 and SPR 220
SideBySide Shotguns
IMPORTANT!READ ALL WARNINGS AND
INSTRUCTIONS IN THIS
MANUAL BEFORE USING THIS SHOT
GUN...

23
2
Safety is Critical to Performance.
A superbly crafted gun is only as good as the hands that hold it. You can never be too careful. Shooting 
accidents are often caused by careless oversights such as failing to control the direction of the muzzle, failing to
fully engage the safety, leaving ammunition in the chamber or using improper loads. These oversights can result
in the destruction of life, limb or property. There’s no calling back a bullet once it’s been fired, so it’s 
critical that you know...

3 3
3rd COMMANDMENT
Never Rely on Your Firearm’s Safety Mechanism to Justify Careless Handling.
If your firearm is equipped with a manual safety mechanism, do not rely on the safety as an excuse for improp
er or careless handling of the firearm.  The safety mechanism is merely a supplement to your proper handling of
the firearm.  The safety mechanism may be broken or altered.  Even if you think you have previously engaged
the safety in the “safe” position, it may have been inadvertently disengaged...

4
7th COMMANDMENT
Always Wear Eye and Ear Protection.
Wear protective shooting glasses and hearing protectionwhen shooting.  Be sure to wear eye protection when
disassembling or cleaning a firearm to protect your eyes from springs and other tensioned parts.  Continued
exposure to shooting noise can permanently damage your hearing.
8th COMMANDMENT
Be Sure the Barrel is Clear of Obstructions Before Shooting.
With your firearm completely unloaded, open the action and make sure there are no obstructions or...

5
Use the Security Lock Provided with your Shotgun
This shotgun comes with a security lockto assist in protecting against unauthorized use.  See Picture 1.
The shotgun must be unloaded when the security lock is in place on the shotgun.  
WARNING: Using the
security lock cannot substitute for securing your firearm and ammunition in separate, locked locations.
The security lock operates as follows:
1.To open the Trigger Lock put the Key into the notches of the Trigger Lock Nut and unscrew it...

7
6
Use the Security Lock Provided with your Shotgun  (cont’d)
3. Screw the Trigger Lock Nut on the Trigger Lock Screw (clockwise) and tighten the nut with the key.  
DO NOT TIGHTEN THE NUT TOO TIGHT OR YOU COULD DAMAGE THE LOCK SCREW (See 
Picture 5).
4. To remove the Trigger Lock, unscrew the Trigger Lock nut with the key and detach the Trigger Lock Screw
(See 
Picture 6)
WARNING
Always store the key to the security lock: (1) in a separate location away from the shotgun; (2) in a secure location...

7
Important Parts of the Firearm
Congratulations on your choiceof a Remington®Model 210 or Model 220 shotgun.  With proper care and if used
in accordance with the Ten Commandments of Firearm’s Safety and this owner’s manual, your shotgun should give
you many years of dependable use and enjoyment.  The following picture depicts the main parts of your shotgun
and will aid in understanding the instructions in this Owner’s Manual.
This picture shows the main parts of a Remington Model SPR210 shotgun. The...

8
External Control Parts  (cont’d)
Top Lever:The top lever is located just forward of the safety mechanism. (See Picture 9).  The top lever is used
to break open the action to load and/or unload the shotgun, and to assemble and disassemble the shotgun.  To break
open the action, fully push the top lever to the right.  (See 
Picture 10).
WARNING
When operating the top lever, you must: 1) make sure the safety mechanism is in the “on” or “safe” position; (2) keep your fingers away from the
trigger(s) and...

9
External Control Parts  (cont’d)
The Barrel Selector (for Model 210 singletrigger shotguns only):Once the shotgun is loaded, you may
manually set the shotgun to fire a specific barrel first by using the barrel selector.  The barrel selector is a button on
the trigger. (See 
Picture 13).  When the button is pushed fully to the right (listen for an audible “click”), the first
pull of the trigger will fire the right barrel, and the second pull of the trigger will fire the left barrel.  When the barrel...

10
Instructions For Assembly Of Shotgun
WARNING
Before you begin to assemble the shotgun, you MUST (1) look down the barrel from the breech end toward the muzzle end to make sure there
is no ammunition in the chambers or obstruction in the barrels, and (2) make sure the safety is in the “safe” position.
Your shotgun was shipped with the barrel assembly (barrel and fore end) detached from the receiver assembly.
To assemble the shotgun, follow these instructions:
1. Remove the plastic bags or wrapping...