Plus Projector V3 131 User Manual

E-61
Replacing the Lamp Cartridge
•The lamp that is used as a light source in the projector has a limited service life. The rated service life of the lamp is
about 1500 hours (when used in normal mode only). This could be shortened depending on conditions of use and
other factors.
Note that lamp life will be extended when the projector is often used in Eco mode. (The rated service life of the lamp
means the average value of lamp life for lamps that have been manufactured over a long period, and it is...

E-62
1
2
3
Replacing the Lamp Cartridge
Preparations: Turning the projector upside-down on top of a soft cloth, etc., so that it does not get scratched makes it easier to
replace the lamp cartridge. Turn the projector right-side up after replacing the lamp cartridge.
1Unplug the power cord.
2Turn the projector upside-down.
3Remove the lamp cover.
(1) Turn the lamp cover’s set screw counterclockwise and
loosen until the screw turns freely. (The screw does
not come off.)(2) Open the lamp cover a little,...

E-63
1
2
Replacing the Lamp Cartridge
5Mount the new lamp cartridge.
(1) Push the lamp cartridge in slowly.
(Line it up with the screw holes in the projector.)
6Mount the lamp cover.
(1) Set the tip of the lamp cover in place, then close the
lamp cover.
7Reset the Lamp Timer.
Connect the power cable, switch on the power, and then reset.
Select [Info.] → [Lamp Timer Reset] on the menu and press the ENTER button. There is a change to the initialization
verification display. Press the ENTER button again....

E-64
Specifications
ModelV3-131/V3-111
Optical
Method of projection : DLP™ (single chip DMD)
DMDV3-131:
0.7 inches 1024768 dots
V3-111:
0.55 inches 800600 dots
Lamp 120 W high pressure mercury lamp
Projection lens : Fixed focus, Manual focus F = 2.6, f = 23 mm (f = 0.91 inch)
Image sizeV3-131:
Minimum: 36 inch (at projection distance of 1.2m(3.9 feet) )
Maximum: 300 inch (at projection distance of 10.0m(32.8 feet) )
V3-111:
Minimum: 28 inch (at projection distance of 1.2m(3.9 feet) )
Maximum: 300 inch...

E-65
Table of Supported Frequency
The projector automatically identifies the signal input from the computer and selects the optimum resolution as shown on the table
below.
Manual adjustments may be required for some input signals. See “Picture Adj. / Fine Picture / H Position / V Position” on page E-
43, 44.
: Supported frequency
: Not supported frequency * The model name for XGA is V3-131 and SVGA V3-111.
* The projector does not support the ADC connector on Apple Macintosh.
V3-131
The display...

E-66
STANDBY
AUTO
SOURCESTANDBY PUSH
STATUS
Cabinet Dimensions
Unit: mm (inch)
158 (6.2) 35 (2.4)
209 (8.2)
[When projecting]7 (0.3) 

2003