Philips Bclever Sv1 Projector User Manual

>
Switch off and disconnect the projector before cleaning.
1Press the 
yStandby button twiceto switch off the projector.
–The Standby indicator star ts blinking red.
2Wait until the cooling fan has stopped (about 3 minutes after the projector has been put in
Standby) and disconnect the mains lead and all other cables.
Cleaning the cabinet
•When the cabinet is dusty, clean it by gently wiping with a soft cloth.
•A chamois leather slightly moistened with water is sufficient for cleaning the housing.
•Do...

>
When operation time reaches the last 100 hours of the average lamplife, the message ‘Warning:
lamplife has almost expired’will be displayed on the screen, each time the projector is switched
on.
The lamplife remaining can be checked using the OSD menu.
1Press Menu.
–The menu bar appears on the screen.
2Use Cursor Control to select Lamp counter in the ‘Set up’menu.
–The used lamplife hours are displayed.
–When the lamplife has expired the message ‘Warning: lamplife has expired’is displayed on
the...

<
5Unscrew screws B.
6Grasp the lamp holder handle and carefully pull the lamp holder out of the projector.
•Do not tilt. If the inner tube is broken glass par ticles may fall out.
•Keep lamp holder opening to your right. Do not touch lamp or point lamp holder opening
at anyone.
7Carefully remove the new lamp housing from its package.
•Always use the same type of lamp: LCA3122/00 (150 W), 12nc: 8670 931 22009.
•Do not touch lamp or point lamp housing opening at anyone.
•Do not drop, as the impact may...

>
If a fault occurs, first check the points listed below before taking the projector for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or ser vice
organisation.
Under no circumstances should you tr y to repair the projector yourself as this could invalidate the
guarantee.
–Possible cause
•Solution
General
–Mains lead is not correctly connected.
•Correctly connect mains lead.
–The filter holder is not installed correctly or is damaged.
•Install the filter...

>
In case of YPbPr connection
–’YPbPr’is not selected in the menu and ‘Auto Source’is activated. In this case ‘Auto Source’will not
recognize ‘YPbPr’.
•Select ‘YPbPr’as projection source in the ‘Set up’menu (‘Auto Component Selection’sub
menu).
In case of RGBsog (Scart) connection
–’RGBsog’is not selected in the menu and ‘Auto Source’is activated. In this case ‘Auto Source’will
not recognize ‘RGBsog’.
•Select ‘RGBsog’as projection source in the ‘Set up’menu (‘Auto Component Selection’sub
menu).
•Adjust...

Standby/Remote control indicator (ring around Standby On button)
–red: Power/Standby mode.
–green: operation mode.
–green blinking (slow): warming up.
–red blinking (slow): cooling down.
•Do not switch the projector off; it will restar t the lamp automatically within a few seconds.
–red/yellow blinking (slow) for 1 second: signal from remote control received in
Power/Standby mode;
–green/yellow blinking (fast) for 1 second: signal from remote control received in operation
mode.
Error indicator
– red:...