Panasonic UF 8100 YC User Manual

Order Number: MGCS041006C0
H13
Facsimile
UF-7000/8000
UF-7100/8100
[ Version 2.0 ]
This service information is designed for experienced repair technicians only and is not intended for use by the general public.
It does not contain warnings or cautions to advise non-technical individuals of potential dangers in attempting to service a product.
Products powered by electricity should be serviced or repaired only by experienced professional technicians. Any attempt to service 
or repair the product or...

2
The contents of this Service Manual and the Specifications are subject to change 
without notice. 
Panasonic Communications Co., Ltd. reserves the right to make improvements in 
the product design without reservation and without notice.
Published in Japan.   Information regarding Lead-Free (PbF) solder:
    Distinction of PbF PCB:
PCBs (manufactured) using lead free solder will have a          mark following 
the PCB part numbers in a label on the PCB.
    Caution:
  Pb free solder has a higher melting...

3
Important Notice
Please read this notice completely BEFORE installing any optional 
accessories. As failure to properly install the additional board or 
connector with the power ON could damage the machines SDR or 
SC board.
Please follow the instructions below:
1. It is essential that you turn OFF the Main Power Switch located 
on the Rear Side of the machine.
2. It is essential that you unplug the AC Power Cord from the wall 
outlet. (During a Lightning Storm, to prevent electrocution 
disconnect the...

4
Important Notice for Installation
Caution:
Depending on your machines model, it may weight approximately 48.50 lb 
(22.0 kg)  without any options. 
To prevent injuries, use the appropriate number of personnel and lift or move 
the machine as illustrated.
Do not lift the machine by the Paper Tray as it may cause damage and/or bodily 
injury.
Note:
Refer to the Quick Guide when installing the machine.
Downloaded From ManualsPrinter.com Manuals 

5
Power and Ground Connection Cautions
Ensure that the plug connection is free of dust. In a damp environment, a contaminated
connector can draw a significant amount of current that can generate heat and
eventually cause fire over an extended period of time.
Always use the power cord provided with your machine. When an extension power cord
is required, always use a properly rated cord.
120 V/15 A or AC 220 - 240V/10 A
If you use a cord with an unspecified current rating, the machine or plug may emit...

6
Never touch a power cord with wet hands. Danger of electric shock exists.
If the power cord is broken or insulated wires are exposed, replace immediately with a specified cord onl
y.
Using a damaged cord can cause fire or electric shock.
Stop operation immediately if your machine produces smoke, excessive heat, unusual noise, or smell,
or if water is spilt onto the machine. These conditions can cause fire. Immediately switch Off and
unplug the machine.
Do not disconnect or reconnect the machine while...

7
Do not place a magnet near the safety switch of the machine. A magnet can activate the
machine accidentally resulting in injuries.
Do not use a highly flammable spray or solvent near the machine. It can cause a fire.
When copying a thick document, do not use excessive force to press it against the
document glass. The glass may break and cause injuries.
Never touch a labeled area found on or near the heat roller. You can get burnt. If a sheet
of paper is wrapped around the heat roller, do not try to...

Table of Contents
8
Specifications Table................................ 9
1.1. Fax, Printer, Network Scanner and 
Internet Fax Functions ............................. 9
1.2. System Combination .............................. 23
1.3. Options List ............................................ 24
Maintenance, Adjustments and 
Check Points.......................................... 25
2.1. Preventive Maintenance ........................ 25
2.2. Required Tools....................................... 27
2.3....

9
NOV 2004 Ve r.  2 . 0
UF-7100/8100 UF-7000/8000
1 Specifications Table
1.1. Fax, Printer, Network Scanner and Internet Fax Functions
1.1.1. Fax Function
ItemsDescription
Remarks
UF-7000/7100 UF-8000/8100
Main Specifications
1 Compatibility Super G3 / G3 ITU-T Std & Non-Std
2 Modem Speed 33.6 - 2.4kbps  T.30/V.34/V.17/V.29/V.27ter
3 Coding Scheme JBIG/MMR/MR/MH
4ECM YesConforms to ITU-T Rec. T.30 
ECM
5 Short Protocol Yes (B, D)
6 Transmission Speed Approx. 2.7 secITU-T Image No. 1 
(A4, Std...

10
UF-7100/8100
NOV 2004 Ve r.  2 . 0
UF-7000/8000
Scanner Mechanism
1 Scanning Device CIS (ADF)
2Scanning Resolution /
Speed
Std: 203 x 98 (8 x 3.85)
dpi x lpi (pels/mm x lines/
mm)LT R :  1 . 4  s e c
A4 : 1.5 secLT R :  0 . 7  s e c
A4 : 0.7 sec
Excludes: Initializing Time, ADF 
slipping factor, and Data XMT 
Time.
(Letter size for USA and Canada; 
A4 size for Other Destinations) Fine: 203 x 196 (8 x 7.7)
dpi x lpi (pels/mm x lines/
mm)LT R :  2 . 8  s e c
A4 : 3.0 secLT R :  1 . 4  s e c
A4 : 1.5...