Panasonic Sv Av100 Operating Instructions Manual

							SN
fåëí~ääáåÖ=jÉÇá~pí~ÖÉ=C=rp_=
aêáîÉê
Do not connect the USB cable until the USB driver has 
been installed.
NInsert the supplied CD-ROM into the 
personal computer’s CD-ROM drive.
≥The launcher for the installation is activated 
automatically. 
OClick [MediaStage & USB Driver].
≥When [MediaStage & USB Driver] screen 
appears, click [Next].
PRead License Agreement carefully, and 
click [Yes], if you accept the terms of the 
agreement.
QComplete the installation according to the 
message.
≥The USB Driver is installed automatically.≥If you use other than Windows XP, when the 
DirectX 8.1 setup screen appears, install it 
according to the message. (Failure to install 
DirectX 8.1 disables you from using MediaStage 
for AV100.)
≥After rebooting the computer, the MediaStage for 
AV100 is enabled.
O
P
AV100PP.book  61 ページ  ２００３年８月２２日　金曜日　午後４時３０分 
						

							SO
fåëí~ääáåÖ=rp_=aêáîÉê
When the USB driver is installed, the SD Video 
Camera will be recognized by the personal computer.
Do not connect the USB cable until the USB driver has 
been installed.
≥When [MediaStage & USB Driver] is already 
installed, you do not need to install [USB Driver].
NInsert the supplied CD-ROM into the 
personal computer’s CD-ROM drive.
≥The launcher for installation is activated 
automatically.
OClick [USB Driver].
PClick [Next].
QClick [Finish].
O
P
Q
AV100PP.book  62 ページ  ２００３年８月２２日　金曜日　午後４時３０分 
						

							SP
`çååÉÅíáåÖ=ïáíÜ=íÜÉ=m`
NOpen the AV Input/Output and USB 
Terminal Cover and DC Input Socket 
Cover.
≥When using AV Cradle, put the SD Video 
Camera in the AV Cradle after opening AV Input/
Output and USB Terminal Cover.
OConnect with AC Adaptor 1. (l12)
PConnect the [USB] Terminal 2 of the SD 
Video Camera to the USB Terminal of the 
personal computer 3 using supplied USB 
Cable 4.
≥The SD Video Camera works as a personal 
computer peripheral. (Operation of the SD Video 
Camera is disabled.)
≥The [Removable disk] icon appears in 
[My Computer].
≥Do not use any other USB Cables except the 
supplied one.
≥For other notes, see page 84.
When the SD Video Camera is connected for the 
first time.
≥[Found New Hardware Wizard] screen appears.
For Windows Me/98SE Users:1Click [Next].2Click [Finish].
For Windows XP Users:1Click [Next].≥When the supplied CD-ROM is inserted, click 
[Next] again.
2Click [Continue Anyway].3Click [Finish].
≥Since [Found New Hardware Wizard] screen 
appears again after this, repeat steps.
For Windows 2000 Users:
1Click [Yes].
≥Connect the USB cable after the USB driver is 
installed.
≥Use both the AC adaptor and the battery. Either 
one alone does not allow the SD Video Camera 
to be used with a personal computer.
2
1
4
3
N
OIP
Windows XP
Windows 2000
AV100PP.book  63 ページ  ２００３年８月２２日　金曜日　午後４時３０分 
						

							SQ
pí~êíáåÖ=íÜÉ=pçÑíï~êÉ
ªStarting the MediaStage for AV100
1Select [Start]>> [All programs 
(programs)]>> [Panasonic]>> 
[MediaStage]>> [MediaStage for AV100].
≥For other notes, see page 85.
aáëÅçååÉÅíáåÖ=íÜÉ=rp_=`~ÄäÉ=
ë~ÑÉäó
If you use Windows XP/2000, remove the USB Cable 
using the following method.
If you use Windows Me/98SE, check that the Card 
Access Lamp is out, then remove the USB Cable. 
(Keep the SD Video Camera turned on.)
NDouble click the  in task tray.
≥Hardware disconnect dialog box appears.
OSelect [Panasonic SD-Video CAMERA 
USB Interface]
 and click [Stop].
PClick [OK].
≥Click [OK], and you can safely disconnect the 
cable.
fÑ=óçì=åç=äçåÖÉê=åÉÉÇ=
ëçÑíï~êÉ=Eråáåëí~ääF
1Select [Start] (>>[Settings]) >>[Control 
Panel].
2Double-click [Add/Remove Programs].
3Select the software to be uninstalled and 
click [Change/Remove].
≥Uninstalling steps may vary depending on the OS. 
Please refer to the user manual of your OS.
N
O
P
1
AV100PP.book  64 ページ  ２００３年８月２２日　金曜日　午後４時３０分 
						

							SR
`çåëíêìÅíáåÖ=~=cçäÇÉê=ïÜÉå=
íÜÉ=jÉãçêó=`~êÇ=áë=ìëÉÇ=
ïáíÜ=~=m`
≥When the Memory Card with data recorded by the 
SD Video Camera is inserted into a personal 
computer, folders will be displayed as in the figure.
≥Use the MediaStage for AV100 for operating files 
in the Memory Card. (l85)
[DCIM]: The images (IMGA0001.JPG etc.) in 
this folder are recorded in the JPEG 
format. ([100-0001] or similar 
indication is displayed on the SD 
Video Camera.)
[MISC]: Files in which DPOF Data has been 
set to the image are in this folder.
Slide show data created by 
MediaStage for AV100 are in this 
folder. (AUTPLAY0.MRK etc.)
[SD_VIDEO]: MPEG2 motion images 
(MOV001.MOD etc.) and MPEG4 
motion image is recorded in ASF 
format (MOL001.ASF etc.). 
≥For other notes, see page 86.
AV100PP.book  65 ページ  ２００３年８月２２日　金曜日　午後４時３０分 
						

							SS
líÜÉêë
`Ü~êÖÉ=íÜÉ=ÄìáäíJáå=Ä~ííÉêó=
Ñçê=ã~áåí~áåáåÖ=íÜÉ=Ç~íÉ=
áåÑçêã~íáçå
This built-in battery is used for the memory of date and 
time. If [0] indicator is displayed when the power is 
on, the built-in battery may be exhausted. Charge 
using the following procedure:
NTake the battery out and plug in the AC 
adaptor. (
l12)
OTurn the power off and leave the SD Video 
Camera as it is for approx. 12 hours. 
≥The built-in battery can be used for about 6 months 
by 1 charge. (It changes with operating.)
≥After recharging the built-in battery, adjust the date 
and time. (l22)
rëáåÖ=íÜÉ=léíáçå~ä=
b~êéÜçåÉë
While recording or playing back on an SD Video 
Camera, the sound can be heard using optional 
earphones.
1Plug the Earphone terminal in to the [] 
Ter mi n al .
≥If the volume while playing back is loud or soft, you 
can adjust the volume by using the Volume 
Adjustment Lever on the SD Video Camera, or the 
Volume Adjustment Button on the Remote Controller. 
(Adjustment of volume cannot be performed while 
recording.) (l31)
≥If you use earphones be sure they have a length of 
cord less than 3 meters.
1
Í
N
O
AV100PP.book  66 ページ  ２００３年８月２２日　金曜日　午後４時３０分 
						

							ST
rëáåÖ=^ÅÅÉëëçêáÉë
ªInserting the Button-type Battery
Before using the Remote Controller, insert the 
supplied button-type battery.
NWhile pressing the Stopper 1, pull out 
the Battery Holder.
OInsert the button-type battery with the 
imprint (r) facing upward.
PInsert the Battery Holder into the Remote 
Controller.
≥When the button-type battery becomes weak, 
replace it with a new CR2025 battery. (A battery 
is normally expected to last about one year, 
however, it depends on operation frequency.)
≥Be sure to match the poles properly when 
inserting the battery.
WarningDanger of explosion if battery is incorrectly 
replaced. Replace only with the same or 
equivalent type recommended by the 
equipment manufacturer. Discard used 
batteries according to manufacturer’s 
instructions.
Risk of fire, explosion and burns. Do not 
recharge, disassemble, heat above 212xF 
(100xC) or incinerate. Keep the Button-Type 
battery out of the reach of children. Never put 
Button-Type battery in mouth. If swallowed call 
your doctor.
Replace battery with Panasonic PART NO. 
CR2025 only. Use of another battery may present 
a risk of fire or explosion.
Caution: Battery may explode if mistreated.
Dispose of used battery promptly. Keep away from 
children. 
Do not recharge, disassemble or dispose of in fire.
1
N
OIP
AV100PP.book  67 ページ  ２００３年８月２２日　金曜日　午後４時３０分 
						

							SU
ªUsing the Remote Controller
NDirect the Remote Controller at the 
Remote Controller Sensor 1 on the SD 
Video Camera and press the desired 
button.
≥Distance from the SD Video Camera: Within 
approx. 15 feet (5 meters).
≥Angle: Within approx. 15 degrees in all directions 
from the central axis.
≥The above operative ranges are for indoor use. 
Outdoors or under strong light, the SD Video Camera 
may not operate properly even within the above 
ranges.
ªAttaching the Hand Strap/Lens Cap
To protect the Lens surface, attach the Lens Cap.
1Pass the end of Lens Cap Cord through 
the hold A in the Lens Cap.
2Pass the Hand Strap through the Lens 
Cap Cord.
3Pass the shorter loop of the Hand Strap 
through the Strap Holder.
4Pass the longer loop of the Strap through 
the shorter loop.
5Attach the Lens Cap on the SD Video 
Camera.
≥Fit the part 2 of the Lens Cap to the part 1 of 
the SD Video Camera.
≥When you remove the Lens Cap, hook a finger 
into 3 and remove it.
≥Keep the Lens Cap out of the reach of children to 
prevent swallowing.
A
1
2
3
1N
2,3
5 4 1
AV100PP.book  68 ページ  ２００３年８月２２日　金曜日　午後４時３０分 
						

							SV
ªUsing the Stand
The Card Case can be used as a Movie Stand. It can 
be used for Portrait Picture Recording etc., or 
whenever you do not want to record with the SD Video 
Camera in your hand.
NOpen the Card Case.
OFit the leading protrusions 1 of the Stand 
and the grooves 2 of the SD Video 
Camera, and place the SD Video Camera 
on the Stand.
^ÑíÉê=rëÉ
1Turn off the SD Video Camera. (l17)
2Take out the Memory Card. (l14)
3Retract the LCD Monitor.
4Attach the Lens Cap on the SD Video 
Camera. (
l68)
If you do not use for a long time:
NRemove the AC Adaptor and take the 
battery out. (
l12)
OAttach the Lens Cap on the SD Video 
Camera. (
l68)
PPut the SD Video Camera into the 
Wearable Case.
12
O N
AV100PP.book  69 ページ  ２００３年８月２２日　金曜日　午後４時３０分 
						

							TM
fåÇáÅ~íáçåë=EoÉÅçêÇáåÖ=jçÇÉF
 1Program AE Mode (l38)5: Sports Mode
7:Portrait Mode
4:Low Light Mode
Ω:Spotlight Modeº: Surf & Snow Mode
 2Backlight Mode (l35) 3White Balance Mode (l36)AWB: Auto White Balance 
Adjustment
{:Indoor Mode (recording 
under incandescent light)
z:Outdoor Mode
|:Fluorescent light Mode1: The white balance setting 
that was previously set 
manually
 4Focus Setting (l37)AF: Auto Focus
MF: Manual Focus 5Operation Mode (l27, 28, 32)MPEG2: MPEG2 Motion Image 
Mode
MPEG4: MPEG4 Motion Image 
Mode
PICTURE: Still Picture Mode 6Electronic Image Stabilizer (l39) 7Zoom/D.Zoom Magnification (l35)
 8Manual Exposure Adjustment (l37)
 9Wind Noise Reduction (l39)10Card Mode
(Blue): MPEG2 Motion Image is 
ready to record
(Red): MPEG2 Motion Image is 
recording
(Red): SD Memory Card is not 
inserted/SD Memory 
Card is locked
(Blue): MPEG4 Motion Image is 
ready to record
(Red): MPEG4 Motion Image is 
recording
(Red): SD Memory Card is not 
inserted/SD Memory 
Card is locked
(Blue): Still Picture is ready to 
record
(Red): Still Picture is recording
(Red): SD Memory Card is not 
inserted/SD Memory 
Card is locked
1
76
8
2354
9
11 10
12131415
18
16
17
AV100PP.book  70 ページ  ２００３年８月２２日　金曜日　午後４時３０分