Panasonic Sv As10 Operating Instructions Manual

							
11
Remove the BatteryBe sure to turn the power off when you remove the battery.1Slide the door while releasing the 
lock. 1
Open the door.  2
2Release the Battery lock  A to 
remove the battery. When you do not use the camera for a 
long time, remove the battery.
 Never open the Card/Battery door  during the access. (P16) Otherwise, 
the data on the card may be damaged.
 The supplied battery is only for this  camera. Do not use it for other 
devices.
3Close the door.  1
Lock the door while sliding it.  2CAUTIONDanger of explosion if battery is 
incorrectly replaced. Replace only with 
the same or equivalent type 
recommended by the manufacturer. 
Dispose of used batteries according to 
the manufacturer’s instructions.
SV-AS10_PP.book  11 ページ  ２００３年７月３０日　水曜日　午後９時２４分 
						

							
12Charging the Battery1Connect the plug of AC adaptor to 
the outlet and connect the DC plug 
to the USB cradle.
2Charge the battery.• Align the connections.
 Be sure to turn the power off when charging the battery.
 Do not insert this unit in a wrong  direction.
 The charge lamp blinks in about 3  seconds after connecting this unit with 
USB cradle.
3When the charge lamp turns off, the 
battery is charged fully. It takes about 120 minutes.Remove this unit from the cradle 
while pressing the  RELEASE 
button.
THE SOCKET OUTLET SHALL BE 
INSTALLED NEAR THE EQUIPMENT 
AND SHALL BE EASILY 
ACCESSIBLE.
Text E.fm  12 ページ  ２００３年８月２日　土曜日　午後３時３１分 
						

							
13
Charging Information• It’s normal for the battery and the camera to be warm following normal 
use and charging. This is not a 
malfunction.
 Use the supplied cradle or AC adaptor  for this unit.
 Pull the plug out of the electrical outlet  after completing the charge.
 Do not disassemble or alter the cradle  or AC adaptor._ Battery indicatorThe remaining battery power is displayed 
on the LCD monitor in use.
The indication is changed as follows 
##
(blinking) 
according to the consumption of the 
battery. 
When the indicator is shown as 
(blinking), the battery will be 
exhausted in a few minutes. Charge the 
battery.
_ Charging time and available 
recording time(Recording condition)
 Shooting once every 30 seconds, flash 
every other shot
 Temperature 77°F (25°C)/Humidity  60%
 Using the supplied battery and the SD  Memory Card
The times shown above may vary 
depending on the condition. 
_ Charging environment and 
charging error Charge the battery in a place with the 
temperature 50 - 95°F (10 - 35°C). 
(The battery should also be the same 
temperature)
 The charge Lamp blinks while  charging. (Blinks approx. every 2 
seconds when charging is normal.) 
When the charge Lamp blinks more 
quickly or slowly (or turns off), some 
abnormality may have occurred. The 
blinking speed suggests the following 
states.Blinking approx. every 6 seconds:The ambient temperature or that of 
the battery itself is too high or too 
low. Charging proceeds, but will take 
a longer time.Blinking approx. every 0.5 seconds:Refer to P70. Turning off:Charging is completed. If the charge Lamp turns off when 
charging is not completed, the AC 
Adaptor or the battery is probably 
defective. Contact your nearest 
Panasonic dealer.
 For details, refer to P69.
Charging time Approx. 120 minutesContinuous 
recording time
(recordable 
number) Approx. 59 minutes 
(Approx. 110 still 
pictures)Playback time 
(Still Picture)
Approx. 121 minutesContinuous 
music playback 
timeApprox. 10 hours 
(When setting the 
power save and 
using stereo 
earphones.)
Text E.fm  13 ページ  ２００３年７月３１日　木曜日　午前１１時５７分 
						

							
14Insert the CardBe sure to turn the power off when you insert the card.1Slide the door while releasing the 
lock. 1
Open the door.  2
2Insert the card all the way in until it 
clicks. Check the direction of the card.
 Do not touch the connecting terminal 
on the rear of the card.
 If you do not insert the card all the way,  it may be broken.
3Close the door.  1
Lock the door while sliding it.  2 If you cannot close the Card/Battery 
door completely, remove the card 
once, then insert it again.
 We recommend using the cards made  by Panasonic. (Use genuine card only)
SV-AS10_PP.book  14 ページ  ２００３年７月３０日　水曜日　午後９時２４分 
						

							
15
Remove the CardBe sure to turn the power off when you remove the card.1Slide the door while releasing the 
lock. 1
Open the door.  2
2Press the card until it clicks to 
release and pull out the card.
3Close the door.  1
Lock the door while sliding it.  2
SV-AS10_PP.book  15 ページ  ２００３年７月３０日　水曜日　午後９時２４分 
						

							
16About Cards_Access to the cardWhen you access the card, 
(recognition/recording/reading/deleting) 
the Power/Card Access lamp blinks 
quickly.
When the Power/Card Access lamp is 
blinking, do not turn the power off or do 
not remove the battery and the card.
Otherwise, the card or its contents may 
be damaged, or the camera may not 
work properly.
The data of the card may be damaged or 
lost because of the electrical noise, static 
or breakdown of the camera or the card. 
Save your precious data to your PC. 
(P54)
_SD Memory Card (supplied)The SD Memory Card is a small, 
lightweight, removable external card. The 
SD Memory Card is equipped with a 
write-protect switch  1 that can inhibit 
writing and formatting. (When the switch 
is moved towards the  LOCK side, it is not 
possible to write or delete data on the 
card and format it. When the switch is 
unlocked, these functions become 
available.)
 Keep the Memory Card out of reach of  children to prevent swallowing.
SV-AS10_PP.book  16 ページ  ２００３年７月３０日　水曜日　午後９時２４分 
						

							
17
Basic Menu Operation1Press the Power Button for 1 second 
to turn the power on. 1
Select the recording mode [ ] or 
playback mode [ ].  2
2Press the MENU button to access 
the menu.
3Select the menu item using the Jog 
Ball.
4Select the desired feature using the 
Jog Ball.
5Press the Jog Ball to set.
To stop the operation, 
Press the 
MENU  button.
 If the Jog Ball is left without any  operation for about 30 seconds, the 
unit exits the menu automatically.
 When you press the  MENU button for 
about 1 second, the short cut menu 
appears. (P65, 66, 67)
SV-AS10_PP.book  17 ページ  ２００３年７月３０日　水曜日　午後９時２４分 
						

							
18About the Setup MenuItems 
Details of the setting
Vo l u m e  [ ] 
Beep ON: The operational sound turns on.
 Beep OFF: The operational sound turns off.
 Main volume: Adjust the volume of the speaker.
Format card [ ]  Warning: If the SD Memory Card is formatted, all data, including locked data, will be lost. Please 
review the contents of the SD Memory Card before formatting.
Icon display [ ] 
ON: Display the icon on the LCD monitor.
A: Recording mode  B: Playback mode
 OFF: Does not display the icon on the LCD monitor.
A: Recording mode  B: Playback mode
Clock set [ ]  Change the date and display style. (P19)
Reset file No. [ ]  The numerical designation the files are stored as will be reset. The next file will start from 
“0001”.
Reset settings [ ]  Reset to the initial setting of recording and 
setup menu. The clock setting does not change.
Display setup [ ] 
Brightness: Adjust the brightness of the LCD monitor.
 Color: Adjust the saturation of the LCD monitor.
Auto power off [ ] 
5 min: No operation for about 5 minutes leads to power off.
 Cancel: The unit will remain on until the battery is exhausted.This function does not work when connecting to PC, recording/playing back the motion 
image, playing the slideshow or music, or recording/playing back the voice memo.
ò
SV-AS10_PP.book  18 ページ  ２００３年７月３０日　水曜日　午後９時２４分 
						

							
19
Setting the Date/Time1Access the menu. 
(P17)
Select  Clock set  from Clock set  
[ ] on the  Setup menu.
2Set the year, month, day and time. When pressing the jog ball, year, 
month, day and time is set.
When rolling it up and down, the 
number is set.
 Press the  MENU button to exit from 
the menu.
_ Initial UseThe clock is not set when shipping. When 
you turn the power on, the clock setting 
screen appears. Adjust the time here.
 If you do not set the clock here, the 
clock is automatically set to “January 
1st, 2000 0:00”.
 You can set the year from 2000 to  2099.
 When you select  Display style from 
Clock set  in step 1, you can choose 
the indication style from the following.
 (e.g. September 1st, 2003 PM12:00)[Y/M/D]:2003/9/1 12:00[D/M/Y]:1/9/2003 12:00[M/D/Y]:Sep/1/2003 12:00PM
 When the fully charged battery is 
inserted in the camera for 1 hour or 
more, the clock setting is stored in 
the camera for about 10 hours even 
after the battery is removed.  (It is 
stored for about a maximum of 3 
months according to the time when the 
battery is inserted. If a battery which is 
not fully charged is inserted, time may 
become shorter.)
However, the clock setting is cancelled 
if more time has passed without the 
battery inserted. In this case, please 
set the date/time again.
SV-AS10_PP.book  19 ページ  ２００３年７月３０日　水曜日　午後９時２４分 
						

							
20Taking a Picture 
(Still Picture)
1Turn the power on. 1 The power/card access lamp is lit in 
red.Switch to the recording mode [ ]. 
2
2Access the menu. (P17)
Select  Still picture  from REC mode  
[].
3Press the shutter button to take a 
picture.
SV-AS10_PP.book  20 ページ  ２００３年７月３０日　水曜日　午後９時２４分