Panasonic Shaver Wet Dry Es 8078 Operating Instructions

IN USA CONTACT:
Panasonic Consumer Electronics Company
Division of Panasonic Corporation of North America
One Panasonic Way 2F-3  Secaucus, NJ 07094
IN PUERTO RICO CONTACT:
Panasonic Sales Company
Division of Panasonic Corporation of Puerto Rico, Inc.
San Gabriel Industrial Park 65
thInfantry Avenue KM9.5
Carolina, Puerto Rico 00630 
IN CANADA CONTACT:
AU CANADA, CONTACTER:
Panasonic Canada Inc.
5770 Ambler Drive, Mississauga, Ontario L4W 2T3
(905) 624-5010
Vancouver: (604) 278-4211
Calgary: (403)...

3 2
Index
IndiceENGLISH Page 8
FRANÇAIS Page 17
ESPAÑOL Página 28
IMPORTANT SAFETY INSTRUCTIONSWhen using an electrical appli-
ance, basic precautions
should always be followed,including the following:
Read all instructions before
using this appliance.WARNING
To reduce the risk of burns, fire, electric
shock, or injury to persons:
1.
Do not use this shaver with
damaged shaving blades and/or
foil, as facial injury may occur.
2.
Close supervision is necessary
when this shaver is used by,
on or near...

45
R
status chargelow mid high
charge
status recharge[ES8075]
P
Q
KA
BN
O
E C
D
F
G
H L
M
[ES8078/77/76]
I I
J
b
I
c
I
a
1
6
2
statusc
h
a
r
g
edryclean
select
XZYAA
AB
W
V
S
AC
T
U
4
status chargelow mid high
status chargelow mid high
charge
status recharge
charge
status recharge
(A) (B) (C) (D)
[ES8078/77/76] [ES8075]
5
7
(b)
(a)
8
9
Course completion summary (
E E)
Course selection indications
CourseOn self-cleaning recharger
Courses that can be
changed halfway through
clean
glow
glowdry charge...

7 6
s
e
le
c
t
s
ta
tu
sc
h
a
rg
ed
ryc
le
a
n
18
[ES8078]
[ES8077]
[ES8076]
[ES8075]
status chargelow mid highcharge
status recharge
19
3 4
17
20
21
a b
gc e
d
f
22
13
# $
14
# $
1011

12
15
2
1
16

 1@&4@@@@64
 
 
 
 
Ö”´
 

9
cleaning recharger securely (see
fig. 13, 14, 15).
2. Insert the appliance plug into the
socket (see fig. 16-1).
3. Firmly insert the adaptor into the
AC outlet (see fig. 16-2).
In some areas, a special plug
adaptor may be required.
4. Pull up the arm of the self-clean-
ing recharger until it clicks (see
fig. 17-3).
5. Remove the protective cap and
set the shaver firmly onto the self-
cleaning recharger until it clicks
(see fig. 17-4).
• The Self-cleaning recharger is
set on the (Charge) mode when
the...

11
among many other shaving aids (gel,
soap, cream, etc.). Do not put a thick
layer of shaving foam as it may af-
fect shaver’s performance. If the
shaving head is clogged with foam,
simply rinse it under running water.Using the trimmer(see fig. 9)
Slide the trimmer handle up to open
the trimmer.
Place the trimmer at a right angle to
your skin and move it downward to
trim sideburns.Cleaning your shaver1 Cleaning with the self-cleaning
recharger
Preparing the self-cleaning
recharger
Warning – Do not wash...

13
Replacing the Detergent Cartridge
Note: In order to maintain maximum
cleaning performance, it is
important to replace the water
in the water tank at the same
time you replace the cartridge.
It is recommended to clean the
shaver with the self-cleaning
recharger after every shave.
Change the cartridges when the
status lamp is illuminated. Before
exchange, make sure to inspect the
cartridges with following procedure.
Checking the status lamp
In cases when the status lamp blinks,
carry out the following...

15
WARNING for Lithium Battery:
Fire, explosion, and severe burn
hazard.Do not crush, disassemble, heat
above 100°C (212°F), or incinerate.How to remove the built-in
rechargeable battery before
disposal of the shaver
(see fig. 22)
WARNING – Do not attempt to re-
place the battery for the purpose
of reusing the shaver. This could
result in the risk of fire or electric
shock.
The battery in this shaver is not in-
tended to be replaced by consum-
ers. However, the battery may be re-
placed at an authorized...

17
16
•When the shaver is washed with-
out the self-cleaning recharger,
wash it in tap water. Do not use salt
water or boiling water. Also, do not
use cleaning products that are de-
signed for toilets, bathrooms or
kitchen appliances. Do not sub-
merge the shaver for a long time.
•Do not wipe any part of the shaver
with thinner, benzine or alcohol.
Clean it by using a cloth dampened
with soapy water.
•Do not take the housing apart as
this can affect the watertight con-
struction.
•Do not clean with water...

19
le chargeur auto-nettoyant (voir
les fig. 13, 14, 15).
2. Insérez la fiche mâle de l’appareil
dans la prise électrique (voir fig.
16-1).
3.
4. Tirez le bras du chargeur auto-
nettoyant vers le haut jusqu’à ce
que vous entendiez un déclic (voir
fig. 17-3).
5. Retirez le capuchon protecteur et
enclenchez le rasoir fermement
sur le chargeur auto-nettoyant
jusqu’à ce que vous entendiez un
déclic (voir fig. 17-4).
•Le chargeur auto-nettoyant se
met en mode (Charge) lorsque
le rasoir est allumé.
•Ne tirez...