Panasonic Rechargeable Shaver Es 7109 Operating Instructions

Operating Instructions 
Manuel d’utilisation
Rechargeable Shaver 
Rasoir rechargeable
Model No. ES7109 N° de modèle ES7109
Before operating this unit, please read these instructions completely.Il est recommandé de lire attentivement ce manuel avant d’utiliser l’appareil.
English	2
Français	12
Español	22

ES7109_USA.indb   12007/07/12   12:56:22 


English
IMPORTANT	SAFETY	INSTRUCTIONS
When using an electrical appliance, basic 
precautions should always be followed, including 
the following:
Read all instructions before using this appliance.
DANGER	To	reduce	the	risk	of	electric	
shock:
1. Do not reach for an appliance that has fallen 
into water. Unplug immediately.
.  Charger unit is not for immersion or for use in 
shower.
3.  Do not place or store appliance where it can fall 
or be pulled into a tub or sink. Do not place in 
or drop...

3
English

Important
Before	useThis Wet/Dry shaver can be used for wet shaving with shaving lather or for dry shaving. You can use this watertight shaver in the shower and clean it in water. The following is the symbol of Wet shaver. The symbol means that the hand-held part may be used in a bath or shower.
Treat yourself to wet lather shaves for at least three weeks and notice the difference. Your Panasonic Wet/Dry shaver requires a little time to get used to because your skin and beard need about a...

4
English
Parts	identification










statuschargedr ycleanselect









 Protective cap  System outer foil3  System outer foil release buttons4  Foil frame5  Inner blades6  Foil frame release buttons7  Switch lock button
8  OFF/ON switch9  LCD panel  Appliance socket  Trimmer  Trimmer handle  Adaptor (RE7-40)  Power cord  Appliance plug
  Self-cleaning recharger (Referred to as the “Recharger”.)  Detergent cartridge  Water tank  Socket  Arm  Water tank...

5
English
Charging	with	the	self-cleaning	rechargerCharge
Thoroughly wipe off any drops of water on or around the recharger so that it is dry before charging it.
2
3
45
6
11Attach	the	detergent	
cartridge	and	the	
water	tank	to	the	
self-cleaning	
recharger.	
Page	7
22Insert	the	appliance	
plug.
33Plug	in	the	adaptor.
44Pull	up	the	arm	until	it	
clicks.
55Remove	the	protective	
cap	
	and	then	attach	
the	shaver.
Turn the shaver off before attaching.Check that the outer foil is not deformed or damaged...

6
English
Reading	the	LCD	panel
The LCD panel shows the remaining battery capacity from 0% to 
100%, in 0% increments.
While charging After charging is completed
10 minutes after charging is completed
 glows.
The indicators blink once every second.
The indicators blink once every  
seconds.
When the battery capacity is low
You can shave 1 to  times after “0%” appears. (This will differ depending on usage.)•
“0%” appears and  blinks.A full charge will supply enough power for approx. 14...

7
English
Cleaning	with	the	self-cleaning	rechargerCare
Preparing	the	self-cleaning	rechargerRemove the shaver and the appliance plug from the self-cleaning recharger.


2
1
34
11Remove	the	water	
tank	and	then	open	
the	water	tank	cap.
22Wash	away	the	old	cleaning	liquid	and	
then	rinse	the	water	
tank.
33Pour	tap	water	into	
the	water	tank.
Do not let the water rise above the maximum water line. This may cause the cleaning liquid to spill.
44Securely	close	the	
water	tank	cap	and	
then	attach	the...

8
English
Cleaning	the	shaver
1
2
34
5
select
statuschargedryclean
11Insert	the	appliance	
plug.
22Plug	in	the	adaptor.
Remove any soap or water on the shaver if it has been washed with hand soap or any other detergent.
•
33Pull	up	the	arm.	
44Remove	the	protective	
cap	
	and	then	attach	the	
shaver.Turn the shaver off before attaching.Check that the outer foil is not deformed or damaged when you are attaching the shaver.
55Push	down	the	arm.	
••
66Press	[select]	to	select	the	course.	
Each time you...

9
English

111Cleaning	with	the	self-cleaning	recharger	(continued)1
1 
Follow the steps outlined below if the status lamp blinks or glows during the “Clean/Dry/Charge” course or the “Clean/Dry” course.
BlinksGlows
Correctly set the detergent cartridge and then restart a course.
Remove the shaver from the self-cleaning recharger and then check that the [clean] lamp has gone out. (Be careful as the blade may be hot or wet.) Check that the water tank is correctly attached, the water tank cap is securely...

10
English
Replacing	the	system	outer	foil	and	the	inner	
blades
system outer foilonce every year
inner bladeonce every two years
Replacing	the	system	outer	foil1. Press the system outer foil release buttons and lift the system outer foil upwards as illustrated.
.  Insert the system outer foil by 
pushing it downwards until it clicks.
Replacing	the	inner	blades1.  Press the foil frame release buttons and lift the foil frame upwards as illustrated.
.  Remove the inner blades one 
at a time as...