Panasonic Network Camera Kx Hcm8 Operating Instructions

Operating Instructions
[For assistance, please call: 1-800-272-7033]                                 81
3.5.13 Restart
Restart window restarts Network Camera with the parameters saved. Restarting 
is required when the network parameters are changed.
1.Click [Restart] on Setup Page.
2.Click [Restart Now!].
Click [Cancel] to quit. The window returns to Setup Page. 

Operating Instructions
82
3.5.14 Update Firmware
Update Firmware window allows the user to install the latest version of the 
Network Camera internal operating system. In most cases, this will never be 
necessary. Changes may be necessary to accommodate new operating systems 
or new web browsers that are not shown on page 10. In those cases, Update 
Firmware would be available from the Network Camera Technical Support Site at 
http://panasonic.co.jp/pcc/en/. Check the current firmware version on Setup...

Operating Instructions
[For assistance, please call: 1-800-272-7033]                                 83
4.Click [Update Firmware] on Setup Page.
5.Click [Update Firmware].
Wait about one minute.
Note
If you click [Update Firmware], operation cannot be canceled. If canceled, 
refer to page 108. 

Operating Instructions
84
6.Click [Browse...] to select the firmware from the file selector.
A dialog box appears to choose the file.
7.Select a desired Firmware file (including the path information) and click 
[Open].
8.Make sure the desired firmware file name is selected correctly, and click 
[Update Firmware].
Restarting window is displayed, and Network Camera restarts 
automatically.
Restart operation takes about one minute.
Confirm that the Update Firmware Version number is the latest number on...

Operating Instructions
[For assistance, please call: 1-800-272-7033]                                 85
3.5.15 Reset to Factory Default
Reset to Factory Default window initializes all the parameters including the ID, 
Password, IP address and Subnet Mask except Date and Time setting to the 
factory default. Reconfirm the settings before doing the Reset to Factory Default 
operation.
1.Click [Reset to Factory Default] on Setup Page.
2.Click [Execute].
Click [Cancel] to quit. The window returns to Setup...

Operating Instructions
86
Section 4
Technical Guides 

Operating Instructions
[For assistance, please call: 1-800-272-7033]                                 87
4.1 Mounting
Four mounting methods are shown in the following figures. Confirm the top and 
bottom of Network Camera when mounting.
Note
Mounting and cabling instructions described in this Operating Instructions 
follow generally accepted guidelines suitable for residential installations. In 
some areas, commercial and industrial installations are regulated by local or 
state ordinances. For such...

Operating Instructions
88
Wall Mounting
Note
Rear Mounting Adaptor can be used in wall mounting. Refer to page 89 for 
Rear Mounting Adaptor. 1) Mount the Flexible Stand firmly to the wall or the beam using the three 
screws.
2) Attach Network Camera by screwing the threaded mount into the tripod 
mounting hole.
3) Adjust the position of Network Camera and secure the Flexible Stand. 
Do not over tighten.
1) 2) 3) 

Operating Instructions
[For assistance, please call: 1-800-272-7033]                                 89
Ceiling Mounting
1) Mount the Flexible Stand firmly to the ceiling or the beam using the 
three screws.
2) Attach the Rear Mounting Adaptor to the rear of Network Camera.
3) Attach Network Camera by screwing the threaded mount into the tripod 
mounting hole.
4) Adjust the position of Network Camera and secure the Flexible Stand. 
Do not over tighten.
1) 2)Rear Mounting
Adaptor3) 4) 

Operating Instructions
90
Notes
Make sure the Power Indicator is always in the upper right corner when 
you mount.
The upside down mounting may cause Network Camera to fall down.
CAUTION
Network Camera is intended for indoor use only. Prolonged exposure to direct 
sunlight or halogen light may damage the CMOS sensor.
Power Indicator
top
bottom
top
top
bottom
bottom
bottom
On the ceiling On the wall On the Stand