Panasonic Network Camera BL-C1A BL-C20A Information Guide

Operating Instructions
[For assistance, please call: 1-800-272-7033] 69
8.Confirm the settings, and click [Save].
 The new settings are saved.
 When finished, Success! is displayed.
9.Click [Go to Trigger page].
 The Trigger page is displayed.
Note
 If you are buffering images to the internal memory, the following 
operations also delete all buffered images.
– Turning off the camera.
– Saving the Date and Time page.
– Restarting, updating firmware or resetting the camera to factory 
default. 

Operating Instructions
70
4.3 Buffering or Transferring Images by Motion 
Detection Signal
The Trigger page allows you to enable image buffer/transfer by E-mail or FTP.
Note
 The level of motion detection depends on resolution, image quality, and 
the object being viewed. Check the level by performing motion detection 
recording. (See page 
83)
 Enabling Motion Detection delays the frame rate of the camera.
 A change to light or wind conditions may detect motions accidentally.
 Motion Detection may...

Operating Instructions
[For assistance, please call: 1-800-272-7033] 71
Note
 Click [Delete Buffered Images] to delete images already buffered. 
 Click [Save] to save the settings. The buffered images will be deleted.
 Clicking [Cancel] takes you back to the Trigger page without saving 
changes.
4.Set the time, and click [Next>].
Note
The timer works by an internal clock. Set the date and time before using timer 
buffer/transfer (see page 
48). 
 Clicking [

Operating Instructions
72
5.Set the image settings, and click [Next>].
 Clicking [

Operating Instructions
[For assistance, please call: 1-800-272-7033] 73
6.Set the image buffer frequency and the Motion deactivation time, and click 
[Next>].
Note
Due to the network environment, object and the number of simultaneous 
accesses, the camera may not record the number of images that you set. In 
this case, set the image buffer frequency longer.
 Clicking [

Operating Instructions
74
Motion 
deactivation 
time Set the length of time during which the Motion Detection 
cannot be triggered after saving images temporarily or 
transmitting them. This function is recommended to 
prevent sending too many E-mails to a cell phone.
 After detecting motions, the camera does not detect 
motions during motion deactivation time, so some images 
may not be captured.
Note
The internal memory cannot buffer images during motion 
deactivation time. Because of this, images...

Operating Instructions
[For assistance, please call: 1-800-272-7033] 75
7.Select the transfer method, and click [Next>].
 Clicking [

Operating Instructions
76
When you set [FTP] for Transfer Method
Select [FTP], and click [Next>]. The following page is displayed.
 Clicking [

Operating Instructions
[For assistance, please call: 1-800-272-7033] 77
SettingDescription
Server IP 
Address or 
Host Name
*1
*1Note that [Space], [], [], [&], [] are not available.
 If you set a server IP address, set 4 numbers (0—255) and 3 
periods, such as 192.168.0.253. Note that 0.0.0.0 and 
255.255.255.255 are not available. Or set a host name (1—
255 characters).
Po r t N o. Enter a number (1—65535). Usually set to 21.
Login ID*2
*2Note that [] is not available.
 If your ISP requires a login...

Operating Instructions
78
When you set [E-mail] for Transfer Method
Select [E-mail], and click [Next>]. The following page is displayed.
 Clicking [