Panasonic Lifi Hdtv Pt 50lcz70 Operating Instructions

11
Getting Start ed
Vent
Notes
Make sure the vents are not blocked. (This could cause damage.)
Indication on the back panel may change without notice.
•
•
Vent
Rear View 
12345678910
11 15 16
1312 14 17
1VHF/UHF Cable In Input terminal for an 
antenna or cable box 
signal.
2 HDMI Input 
Terminal 1
Audio 1Connect from other 
component. (HDMI 1)
3S Video/Video Input 
Connector 1 Connect from other 
component. (Video 1)
4Video Input 
Connector 2Connect from other 
component. (Video 2)
5HDMI Input 
Terminal...

12
Installation
Connected Equipment Introduction 
(Signal source)
Watching TV
VHF/UHF Antenna
NTSC (National Television System Committee): Conventional 
broadcasting
ATSC (Advanced Television Systems Committee): Digital TV 
Standards include digital high-definition television (HDTV), 
standard-definition television (SDTV), data broadcasting, 
multi-channel surround-sound audio and interactive 
television.
Cable Box/Cable
You need to subscribe to a cable TV service to enjoy viewing 
their programming.
You...

13
Getting Start ed
Example 1   Connecting Antenna (To watch TV)
To connect antenna terminals
Cable TV
Projection DisplayVHF/UHF Antenna
Note
For additional assistance, visit us at :  www.panasonic.com
www.panasonic.ca
• (If no Cable Box) or
ANT OUT ANT IN
Cable Box
Antenna terminal Back of the unit
Power Cord
(Connect after all the 
other connections.) Cable TV
VHF/UHF Antenna
or
If using Cable Box :
Set the TV channel to CH3, CH4, or select the appropriate input.
When using “Nut type” RF coaxial cable,...

14
Example 2   Connecting DVD recorder (VCR) (To record/playback)
To connect antenna terminals
DVD Recorderor 
VCR
Projection DisplayVHF/UHF Antenna
ANT OUT ANT IN
Antenna terminal
Back of the unit
VHF/UHF Antenna
Power Cord To use HDMI 
terminals (next page)
To use COMPONENT 
terminals (next page)
To use COMPOSITE terminals (next page)
To use S VIDEO terminals (next page)
DVD Recorder or VCR(with TV tuner)
Installation (continued)
To use OUTPUT terminals (p. 21, 22)
When using “Nut type” RF coaxial...

15
Getting Start ed
High-Definition
Standard-Definition
Notes
Some programs contain a copyright protection signal to prevent recording\
.
When the copyright protection program is displayed, do not connect the o\
ther TV monitor through a VCR. Video signals fed through 
VCRs may be affected by copyright protection systems and the picture wil\
l be distorted on the other TV monitor.
•
•
To use HDMI terminals■
To use COMPONENT terminals■
To use COMPOSITE terminals■
To use S VIDEO terminals■
Connecting to...

16
Example  3   Connecting DVD recorder (VCR) and satellite receiver
DVD Recorderor 
VCR
Projection DisplayVHF/UHF AntennaSatellite 
Receiver
ANT OUT ANT IN
Antenna terminal
Back of the unit
VHF/UHF Antenna
Power Cord To use HDMI 
terminals 
(p. 15)
To use 
COMPONENT 
terminals 
(p. 15)
To use COMPOSITE terminals (p. 15)
To use S VIDEO terminals (p. 15)
DVD Recorder or VCR(with TV tuner) ANT IN
DTV Satellite Receiver or
DTV Cable Receiver
Connecting this Projection Display and DVD recorder (VCR)
Connect...

17
Getting Start ed
To connect DVD recorder and satellite receiver
To connect VCR and satellite receiver
To use HDMI terminals■
To use COMPONENT terminals■
To use COMPOSITE terminals■
To use S VIDEO terminals■
Connecting to HDMI terminals will enable you to enjoy high-definition di\
gital images and high-quality sound.
•
Satellite Receiver may also be connected to COMPOSITE or S VIDEO termina\
ls. (see below.)
•
The S Video input will override the composite video 
signal when S Video cable is connected....

18
Installation (continued)
Example 4   Connecting Home Theater and DVD recorder
To connect HDMI terminals
DVD Recorder
Projection DisplayHome Theater
Back of the unit
Power Cord DIGITAL
AUDIO IN HDMI
AV OUT HDMI
AV IN HDMI
AV OUT
Home Theater(AV amp)
DVD Recorder
Notes
It is recommended that you use Panasonic’s HDMI cable. (p. 52)
When Using the COMPONENT VIDEO OUT terminals or the S VIDEO OUT terminal\
, refer to page 17 “To use COMPONENT 
terminals” or “To use S VIDEO terminals”.
If you connect RAM...

19
Getting Start ed
Example 5   Connecting PC
To connect PC terminals
Projection DisplayPC
MONITOR
OUT
AUDIO
OUT
Back of the unit
Power Cord
Notes
Some PC models cannot be connected to the set. A conversion adapter is r\
equired to use the RGB cable (D-SUB 15P) (Not 
included) to connect a Macintosh computer to the set. There is no need \
to use an adapter for computers with PC / AT compatible 
D-SUB 15P terminal.
The computer shown in the illustration is for example purposes only. Add\
itional equipment...

20
RGB signals that can be input
The table below lists the different types of RGB signals that can be inp\
ut.
If a signal which differs greatly from the types listed below is input, \
the picture may not be displayed correctly, 
or a black background may be displayed.
Notes
The D-SUB 15P connector can accept RGB (H-V sync separate).
The signal with a * mark is compatible with sync on Green.
To view a WXGA and WVGA picture, a setting change is necessary. Please r\
efer to “PC Adjust” on page 37.
•
•
•...